E-Z Trail 510 Operator's Manual

E-Z Trail 510 Operator's Manual

Add to My manuals
9 Pages

advertisement

E-Z Trail 510 Operator's Manual | Manualzz

OPERATORS MANUAL

&

PARTS BOOK

510 GRAIN CART

1050 E. COLUMBIA

P.O. BOX 168

ARTHUR, IL 61911

TOLL FREE: 800-677-2802

PHONE: 217-543-3471

WWW.E-ZTRAIL.COM

WARNING

Do not attempt to clean, adjust, lubricate, or enter the grain cart while any part is in operation.

Do not start the machine without all guards & shields in place & in good working condition.

Do not operate on public roads unless equipped with proper lighting or warning devices. It is the responsibility of the user & owner to install lighting or other equipment as required by state & federal laws.

Do not allow children to play on or around the grain cart.

OPERATION

The indicator flag on the front of the cart shows the position of the inner door.

When engaging the PTO, the door should be closed & and the tractor should be running at low RPM's to prolong the life of the driveline & gearbox.

With the auger running, open the door to begin unloading grain. Do not exceed 750 PTO RPM for maximum efficiency & auger life.

When the cart is nearly empty, the door can be partially closed to provide better clean out.

Over tightening of the shear bolt on the front PTO yoke creates excessive friction, which drastically increases shear torque and can damage or result in premature failure of the gearbox. Always use a locknut on the shearbolt and leave the nut loose enough that you can turn the bolt with your fingers.

The top auger must remain locked in the unloading position while the PTO is engaged. Folding the top auger while the auger is turning can cause damage to the augers.

The top auger is equipped with an over-center lock to hold the auger in unloading position. If the auger will not fold down, the lock may be going too far over center. To correct this, a shim can be placed between the square bar & the stop pin on the linkage bars.

MAINTENANCE

Grease regularly:

PTO Shaft

U-joint at Gearbox

Bearing at Top of Lower Auger

Bearing at Top of Top Auger

 Auger Hinge

 Auger Over-Center Lock

Swivel Hitch

Approximate Tire Inflations:

18.4 x 26 ... 35 PSI

23.1 x 26 ... 33 PSI

24.5 x 32 ... 30 PSI

30.5 x 32 ... 30 PSI.

Before first use, then annually:

 Check gearbox oil level, use 90W oil.

Check wheel bearings for sufficient grease

& proper adjustment.

UP

AUGER

DOWN

OPEN

SLIDE

CLOSE

advertisement

Related manuals

Download PDF

advertisement