QUICK GUIDE
VIO
®
300 S
!
This quick guide is no substitute for briefing and user manual. This quick guide does not include any safety notes. Make yourself familiar with the safety notes in the user manuals.
Necessary operating steps
1 Switch on the device 4 Apply and connect return electrode
Only if you are using a monopolar instrument.
2 Select and adopt program
1
The long edge of the return electrode (1) must point to the operating field.
5 Monitor return electrode
Following application and during surgery.
Correct Error
3 Check settings
Check the settings of the instrument receptacles used by pressing their focus buttons one by one.
If the red return electrode symbol lights up, check the following:
• Is the return electrode correctly connected to the device?
• Does the long edge of the return electrode point to the operating field?
• Does the return electrode have sufficient contact to the skin?
6 Connect instruments
1
+
+
Prog/
Setup
2
MONOPOLAR
HIGH CUT
FORCED
COAG
CUT COAG
+
+
ATTENTION: You may only plug monopolar 4 mm Ø connectors into the receptacle with the blue ring (1) . Otherwise you damage the device.
ELECTROSURGERY 80114-261 02.16
Optional operating steps
7 Changing mode 10 Selecting receptacle (e.g. BIPOLAR)
With the "More"-button, you can select further modes (if available).
8 Changing effect
+
Effect Effect
+
11 Allocating AUTO START or foot switch to the selected receptacle
AUTO START can only be allocated to the bipolar receptacle.
9 Changing power limit
+ max. Watts max. Watts
+
With the "More"-button, you can select further foot switch types and
(if available) AUTO START.
12 For APC applications, open argon bottle
© Erbe Elektromedizin GmbH Hotline +49 7071 755 123 www.erbe-med.com
