THE SUPER-SILENT, ULTRA-POWERFUL SOLUTION

FOR PREMIUM HOME CLEANING

USER GUIDE

Thank you for purchasing a BENNETT READ

WHISPER vacuum.

Your WHISPER vacuum incorporates the latest technological advances in home cleaning systems. It imitates the most powerful forces of nature in a sleek, elegant cleaning system to ensure that your home is easily and properly cleaned.

Your new vacuum is manufactured to a high standard of quality and is backed up by a 24 month guarantee by Tevo.

Should you need any support from us, please visit www.tevo.co.za or call 0861 77 88 88.

PLEASE KEEP THIS USER GUIDE IN A SAFE PLACE AND

READ IT CAREFULLY BEFORE USING YOUR BENNETT READ

WHISPER VACUUM FOR THE FIRST TIME.

!

WARNING:

Plastic film can be dangerous. To avoid the danger of suffocation, keep away from babies and children.

!

CAUTION:

Do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures.

2

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS

BEFORE USING YOUR VACUUM.

When using your WHISPER, basic safety precautions should be observed, including the following:

!

WARNING

TO REDUCE THE RISK OF FIRE,

ELECTRIC SHOCK, OR INJURY:

» Use the system only for its intended use.

» To protect against a risk of electric

shock, do not immerse any part of

the system in water or other liquids.

» Never yank cord to disconnect from

outlet; instead, grasp plug and pull

to disconnect.

» Do not allow cord to touch hot

surfaces.

» Do not run appliance over cord.

» Do not operate the system with a

damaged cord or plug, or if the

appliance or any other part of the

system has been dropped or

damaged. To avoid the risk of

electric shock, do not disassemble or

attempt to repair the WHISPER.

Return the unit for examination and

repair. Incorrect re-assembly or

repair can cause a risk of electrical

shock or injury to persons when the

WHISPER is used.

» Do not leave the unit unattended while

connected. Keep hair, loose clothing,

fingers and all parts of body away from

openings and moving parts.

» Do not use to pick up flammable or

combustible liquids such as gasoline

and do not use in areas where these may

be present.

» Do not pick up anything that is burning or

smoking such as cigarettes, matches or

hot ashes.

» Do not vacuum up any liquids with the

WHISPER.

» Use extra care when cleaning on stairs.

» Do not use the vacuum without the

dust bag or filters in place.

» This appliance is intended only for

household use. Follow all user

instructions in this manual.

» Do not leave the WHISPER

plugged in when un-attended.

Unplug the electrical cord when

not in use and before servicing.

» Do not allow to be used by children or to

be used as a toy.

» Close attention is necessary when

used near children, pets or plants.

» Use only as described in this

manual. Use only Bennett Read

recommended accessories.

» Do not pull cord, use cord as a handle,

close a door on cord, or pull cord

around sharp edges or corners.

» Turn off all controls as applicable before

unplugging from electrical outlet.

» Do not handle plug or vacuum with

wet hands or operate without shoes.

» Do not put any objects into openings.

» Do not use with any opening blocked.

» Keep free of dust, lint, hair and

anything else that may reduce air flow.

» Store your appliance indoors in a

cool, dry area.

» Keep your work area well lit.

» Keep end of hose, wands and other

openings away from your face and body.

» Use only on dry surfaces.

» Using improper voltage may result

in damage to the motor and

possible injury to the user. Correct

voltage is listed on rating label.

» Use only identical replacement parts.

WARNING:

» To reduce the risk of injury from

moving parts – Unplug before servicing.

» To reduce the risk of injury of electric shock:

– Unplug before cleaning or servicing.

– Do not use outdoors or on wet surfaces.

!

WARNING:

THE BENNETT READ WHISPER IS

INTENDED FOR DRY VACUUMING

ONLY . VACUUMING UP ANY

LIQUIDS WILL CAUSE PERMANENT

DAMAGE TO YOUR MACHINE AND

WILL VOID THE GUARANTEE

SAVE THESE INSTRUCTIONS

FOR FUTURE USE.

FOR HOUSEHOLD USE ONLY

3

PRODUCT VIEW

1. Floor nozzle

2. Extension tube

3. Airflow regulator

4. Handle

5. Flex-hose

6. Hose connector

7. Power button/Variable power control

8. Automatic cord rewind button

9. Dirt container lid

10. Dirt container release catch

4

3

12

11. Dust bag

12. Pre-motor filter

13. Post-motor HEPA filter

14. Power cord

15. Dusting brush

16. Upholstery tool

17. Crevice nozzle

18. Suction inlet

19. Turbo Brush

20. LED dust indicator

10

2

13

9

6

18

1

8

7

20

14

5

11 15

4

16 17 19

ASSEMBLY

1.

Your WHISPER comes fully assembled but we recommend you check the following before vacuuming:

• Pre-motor filter [12] properly installed:

Open the dirt container lid (9) by lifting the release catch (10) as shown on pg

8. Slide the pre-motor filter into the slot from the top and clip it into place:

SETTING UP YOUR

WHISPER:

1.

Connect the flex-hose (5) to the vacuum by inserting the hose connector (6) on the end of the flex-hose into the suction inlet (18). To remove the flex-hose, press the two tabs on either side of the connector and pull the flex-hose outwards.

• Post-motor HEPA filter [13]:

Slide the HEPA filter in and press down gently to clip it into place:

2.

Connect hose handle (4) to the end of the extension wand (2) and twist slightly to tighten:

• Dust Bag [11] properly installed:

Insert the front plastic housing of the

Dust Bag into the machine (arrows pointing down) by inserting the bottom of the housing into the slot inside the tank cavity until it clips into place:

3.

To extend the extension wand, hold the grip and push it away from you. To retract, hold the grip and pull it towards you:

5

4.

Connect floor nozzle (1) to the end of the extension wand (2) and twist slightly to tighten:

AUTOMATIC CORD REWIND

Your vacuum is equipped with an automatic cord rewind. When cleaning is finished, switch the electricity off at the wall socket and disconnect the plug from the electrical outlet. Hold the plug and press the automatic cord rewind button to rewind the power cord:

5.

Once assembled, you can store your vacuum by inserting the storage clip (located on the back of the floor nozzle) into the storage slot on the rear of the vacuum:

POWER BUTTON

Turn the power ON or OFF by pressing lightly downward on the power button:

OPERATIONS

POWER CORD

The power cord is located at the rear of the vacuum. Gently pull out the power cord:

VARIABLE SUCTION CONTROL

The power button also controls the suction power of your Bennett Read

WHISPER:

A.

Settings 1 and 2 are suitable for delicate areas and fabrics such as curtains, blinds, upholstery & area rugs:

Setting 1:

Stop pulling the power cord once the yellow line is visible. There is also a red line, which indicates the end of the useable cord. Do not pull the power cord out beyond the red line.

Failure to adhere to this will render your guarantee void.

6

Setting 2:

B.

Setting 3 is for fitted carpets:

Setting 3:

C.

Setting 4 and 5 are for hard floors:

Setting 4:

AIR FLOW REGULATOR

Open the airflow regulator (3) by sliding the regulator up towards the handle to create an open position.

This will reduce the suction power for vacuuming delicate fabrics.

For full suction power, close the airflow regulator by sliding the regulator to the closed position.

OPEN

CLOSED

Setting 5:

SPECIAL TOOLS

Your Bennett Read WHISPER is not only a powerful carpet and rug vacuum cleaner, it is also a versatile bare floor and above floor vacuum cleaner when you select one of the special tools:

FLOOR NOZZLE (1)

Use to vacuum carpets, rugs and bare floors. Swivel head turns to get into tight spaces and fits under furniture and cabinets.

DUSTING BRUSH (15)

Use the dusting brush to clean cornices, skirtings and tight spaces.

UPHOLSTERY TOOL (16)

Use the upholstery tool to clean curtains, draperies, cushions and fabrics.

CREVICE TOOL (17)

Use the crevice tool in tight, narrow spaces.

PET TURBOBRUSH (19)

Ideal for removing pet hair from furniture.

7

MAINTENANCE

AND CARE

EMPTYING THE DUST BAG

• First, unplug the vacuum from the electrical outlet. Remove the hose by pressing the securing clips inwards and pulling the hose connector out from the suction inlet. Set the hose aside

!

CAUTION:

Use only Bennett Read WHISPER replacement filters in your vacuum.

Replacement parts can be purchased from selected retail stores or directly from

Tevo. See page 11 for details

!

CAUTION:

Empty the dust bag (11) regularly to ensure maximum suction power at all times. The machine is equipped with an LED “Dust Indicator” [20] above the power button. Once this indicator turns red, the bag needs to be emptied immediately as per the instructions

• Open the Dirt Container lid:

• Ensure that the slider at the bottom of the bag is completely closed before returning to the machine

This bag can be rinsed under running water and must be allowed to dry completely before returning to the machine. It is recommended to slide open the bag at the bottom before washing

Note: The Dirt Container lid will not close if

the Dust Bag is not fitted in place

• Remove the Dust Bag as shown:

REPLACING/CLEANING

THE PRE-MOTOR FILTER

The pre-motor filter assists in the filtration process that returns cleaner air back into your home.

• Unplug the vacuum from the electrical outlet

• Open the dirt container lid

• Remove the dust bag

• Press down on the button on top of the pre-motor filter and pull upwards to remove

• While holding the dust bag over an outside dust bin, slide open the bottom and shake the bag to rid of all the dust and dirt inside

!

WARNING:

To avoid injury, turn vacuum OFF and unplug cord from the wall when performing maintenance.

8

• The pre-motor filter can be hand-washed in cold water. Rinse well and air-dry thoroughly before returning to the vacuum

• Clip the pre-motor filter securely back into place before use

REPLACING/CLEANING THE

POST-MOTOR HEPA FILTER

The post-motor HEPA filter assists in the filtration process that returns cleaner air back into your home.

• Unplug the vacuum from the electrical outlet

• Open the Dirt Container lid

• Remove the Dust Bag

• Remove the HEPA filter by lifting the tab (indicated with an arrow on the filter cover) and pulling the filter outward

!

NOTE:

Your Bennett Read Whisper is equipped with a Thermal

Cut-off function that is designed to protect the motor from overheating. Should the machine switch off while working, unplug the vacuum’s power cord from the wall socket, then check and clean all filters as explained in this

User Guide. Allow your vacuum to cool down before switching it back on. See the

Troubleshooting Guide for more information.

• Replace the post-motor HEPA filter by sliding it back into the slot and pressing down firmly on the arrow until it clips into place

!

CAUTION:

The post-motor HEPA filter is NOT washable with water. Only use a brush or compressed air to clean the HEPA filter.

!

WARNING:

DO NOT OPERATE YOUR

BENNETT READ WHISPER

WITHOUT IT’S FILTERS IN

PLACE OR WITH WET/DAMP

FILTERS. SERIOUS DAMAGE

WILL BE CAUSED TO THE

MACHINE IF NOT OPERATED

ACCORDING TO THIS USER

GUIDE AND WILL VOID YOUR

WARRANTY.

9

!

CAUTION:

Use only Bennett Read WHISPER replacement filters in your vacuum.

Replacement parts can be purchased from selected retail stores or directly from

Tevo. See page 11 for details

ACCESSORIES

15

1

16

3

4

2

5

17 19

1. Floor nozzle

2. Extension wand

3. Airflow regulator

4. Handle

5. Hose

15. Dusting brush

16. Upholstery tool

17. Crevice nozzle

19. Turbobrush

TROUBLESHOOTING

PROBLEM

Vacuum cleaner won't switch on

POSSIBLE CAUSES

1. Power cord not firmly plugged in, or

is not switched on at the wall socket

Weak suction power

1. Dust bag full

2. Pre-Motor filter clogged/dirty

3. Post-Motor HEPA filter clogged/dirty

REMEDIES

1. Check electrical plug

1. Remove and clean

dust bag and filters

2. Check and clean filter

regularly

3. Check and clean filter

regularly

Visible dust escaping from the machine while vacuuming

1. Filter bag/pre or post motor filters

are not installed properly

2. Filter bag and filters are dirty

1. Check and install all

filters as explained in

this User Guide

2. Clean all filters as

explained in this

User Guide

10

PROBLEM

Machine switches off during operation

(Thermal Cut-off

Switch)

POSSIBLE CAUSES

1. Filters dirty or clogged, or the

Dust Bag is full

2. Obstruction in the flex-hose or in

the extension tube

REMEDIES

1. Clean or replace all

filters as explained in

this User Guide

2. Check and clean the

flex-hose and the

extension tube

The machine will only switch on after it has cooled down sufficiently.

Permanent damage will be caused to your machine if you continue to use it without addressing the root cause of the overheating as explained above

Other maintenance or service not included in the manual should be performed by an authorized service representative.

Thank you for selecting a Bennett Read product.

CONSUMER GUARANTEE

Your Bennett Read WHISPER has a 24 month product guarantee from Tevo

(Pty) Ltd. In the event of the unit malfunctioning, Tevo will replace or repair, at

Tevo’s option, any faulty component, free of charge from the date of purchase by the original purchaser for 24 months. This guarantee does not apply to routine maintenance components such as filters and brushes.

Damage or malfunction caused by negligence, abuse, unauthorized repair, or use not in accordance with the User Guide is not covered. Tevo is not liable for incidental or consequential damages of any nature associated with the use of this product. Tevo’s liability will not exceed the purchase price of this product.

Guarantee and Service enquiries can be made by contacting:

Tevo (Pty) Ltd

Monday to Friday from 8am - 5pm

Customer Service Help Line 0861 77 88 88

Gauteng 086 111 8386

Durban (031) 570 5900

Cape Town (021) 380 0038/9 www.tevo.co.za

11

THE SUPER-SILENT, ULTRA-POWERFUL SOLUTION

FOR PREMIUM HOME CLEANING