Gigabit Ethernet

Cardbus Add-On card, 32 Bit

User Manual

(DN-10121)

All brand names and trademarks are properties of their

Respective owners.

Features



Realtek chipset



Auto-Negotiation with Next Page capability



Crossover Detection & Auto-Correction



10/100/1000M data rate auto-negotiation



LEDs indicate the status of data transmission



Support Wake On Lan (WOL) power management (optional)



Support Full Duplex flow control(IEEE 802.3X)



Fully compliant with IEEE 802.3, IEEE 802.3u, IEEE 802.3ab



Supports Windows 7, Vista, XP, 2000

System Requirements



Windows 7, Vista, XP, 2000



Available Type II CardBus Slot

Page 2

Hardware Description

LED Indicators

LED Indicators Color Status Indication

L GREEN ON Connection at 100Mbps

Page 3

Hardware Installation

1. Power off your notebook computer.

2. Insert the 10/100/1000 Gigabit Ethernet CardBus Adapter into the

Type II PC Card slot of your notebook computer. Make sure it is inserted all the way in for a solid connection.

3. Power on your notebook computer.

Driver Installation

For Windows® 2000/XP/Server 2003

Note: Please take notice of the installation order. First, run the

InstallShield Wizard, and then plug in the PCMCIA Ethernet Adapter to the CardBus Slot.

1. Power on your computer and boot to Windows.

2. Insert the Driver CD into the CD-ROM Drive, and then please browse CD and locate the Driver Folder “\Cardbus\Gigabit

LAN” and double click the InstallShield driver setup program

“Setup.exe” to start the application installation procedure, and follow the on-screen instructions to complete the installation.

3. Insert the Gigabit Ethernet CardBus Adapter into the Type II PC

Card slot of your notebook computer.

Page 4

4. Windows should detect the new device, and automatically install the drivers for the new hardware connected.

5. When Windows desktop is displayed, the driver installation is complete.

For Windows® Vista

In Windows® Vista, when the system is booted up it automatically detects the Gigabit Ethernet CardBus Adapter and install the Gigabit

Ethernet CardBus Adapter with in-build drivers. Following is the procedures for upgrading Gigabit Ethernet CardBus Adapter driver under Windows® Vista operating system.

1. Insert the Driver CD into the CD-ROM Drive, and then please browse CD and locate the Driver Folder “\Cardbus\Gigabit

LAN\Vista” and double click the InstallShield driver setup program “Setup.exe” to start the application installation procedure, and follow the on-screen instructions to complete the installation.

2. When Windows desktop is displayed, the driver installation is complete.

Page 5

To Verify Driver Installation

Click on the “Device Manager” tab in System Properties, which you access from the Windows Control Panel. You should see a “Realtek

RTL8169/8110 Family Gigabit Ethernet NIC” in Windows®

2000/XP/2003(“Realtek RTL8169/8100 Family PCI Gigabit

Ethernet NIC (NDIS 6.0)” in Windows® Vista) installed under

“Network adapters” item.