Battery Holder S300/S400 User`s Manual - STAR
Battery Holder S300/S400
User’s Manual
536 Nanatsushinya, Shimizuku,
Shizuoka, 424-0066 Japan
Tel:(int+81)-54-347-0112
Fax:(int+81)-54-347-0409
◆ Information
This manual contains operating instructions and important safety guidelines.
The Battery Holder S300/S400 is designed to charge only the Lithium-Ion battery
pack compatible with the SM-S300 and SM-S400 Portable Printers.
The contents of this manual are subject to change without prior notice.
◆ Suitable Environment for the Use of the Battery Holder is as Follows:
1.
2.
3.
4.
5.
Operation Temperature : 0℃ to 40℃ (No Condensation)
Storage Temperature : -30℃ to 85℃
Relative humidity : 5% to 95% (No Condensation)
Altitude : 0 ~ 10,000 feet
Cooling : Convectional (Non-Vented Case)
◆ Warning / Safety Guidelines
• Keep the charger in a cool, dry place, away from direct sunlight, high
temperature, and moisture.
• Do not insert foreign objects into the charger.
• Do not operate the charger if it appears damaged.
• Do not disassemble, incinerate, or short circuit batteries, the charger, or related
components.
• Do not operate the charger when your hands or body are wet.
• Do not operate the charger near water.
• To reduce the risk of electric shock, unplug the charger before cleaning.
• This charger cannot be used for any other types of batteries.
• Use of any charger not approved for the SM-S300 and SM-S400 Series can
damage the batteries or the printer and will void the warranty.
◆ General Guidelines
• The recharging time depends on the voltage level and ambient temperature of
the battery. Normally, it takes about four (4) to five (5) hours to completely
recharge one battery pack.
• The battery is a consumable part that will gradually lose its lifespan over time,
depending on the total number of usage hours. Batteries approved for use with
the SM-S300 and SM-S400 carry a standard warranty of six (6) months.
Copyright © 2010 Star Micronics Co., Ltd.
im00100EN
 S300/S400 Parts Breakdown
Charge Contacts Locking Tab Charge Connector Battery Pack Lock DC Plug Battery Charger AC Cord  Using the Battery Holder S300/S400
1. To install battery pack, proceed as follows:
- Insert the battery pack in the direction of the colored arrow.
2. To recharge the battery, install the battery pack in the Battery Holder S300/S400.
Insert the DC Plug into the charge connector and plug the AC Cord into a power outlet.
3.
The S300/S400 Series Battery Pack will begin the charge cycle.
LED Indicators 1.Red LED ON: Charging
2.Green LED ON: Fully Charged
3.OFF:Battery Unloaded or Voltage Overload
NOTE: Only use the AC Cord approved for the SM-S300 and SM-S400.
Usage of any othercord can damage the printer, battery, or battery
pack and will void the warranty.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising