Airflo AFV30 Wet & Dry Vacuum Cleaner INSTRUCTION MANUAL

Product Details

Model

AFV30

Power (W)

1200

Voltage (V)

220-240

Rate(HZ)

50 / 60

INSTRUCTION MANUAL

Wet & Dry Vacuum Cleaner

AFV30

Parts

H andle

C lips

Pull out the clips to open,

conversely, to lock it.

Ho ld the handle to lift up the machine

ON / OFF switch

" O " for power turn off

" " for power turn on

Dust shaking function

Turn off the power, press the dust removing button at the bottom,

then release it quickly .

T he button will go back to its original position .

O perate it repeatedly to shak e off dust.

Hanging wire function

You can hang the wire for storage

Hose

To connect the hose, move the locker to the left side and insert the hose connector into the suction mouth . T hen , release the locker to make it tightly locked.

Conversely, to separate it.

B lowing function

Move the locker to the right side, insert the hose connector into the blowing mouth, then release the locker to make it tightly locked. Move the blowing control bar to the left for blowing function on and to the right for blowing function off.

Rod assembly storage function

Put the rod assembly here for storage to save space

Filter assembly and disassembly

Pull out the machine head

Pull out the clips to pull out the machine head

Take out the dust removing board Replace the HEPA filter

Twist the knob counter clockwi then take out the dust removing board

Twist the HEPA clockwise to take it off

Install the HEPA and Dust removing board

Twist the HEPA counter clockwise to lock, then pull out the dust removing board . T ighten the knob.

Troubleshooting

Problem

Vacuum is not working

Suction is weak

R easons

1 .

T he plug is not inserted tightly and correctly.

2 .

T he socket is switched off .

Solutions

1 . I nsert the plug into the socket tightly

2 .

Ensure th at the socket is switched on

1 . T he hose or tube i s blocked

2 . T he filter i s blocked

3 . T he machine is not fastened tightly

4

. T he air-out filter is

blocked

5 . T he adjust window in the hose is open

1 .

Clean up all the obstructions in the hose or tube or filter

2 .

Clean or replace the filter

3. Make sure that the adjust window is closed

Abnormally loud noise

1 . T he filters a re blocked

2 . T he hose, rod or accessories are blocked

1

.

Clean and

maintain the filter

2

.

Get rid of all

obstructions

If you still can not solve the problem, take it to a service center, not repair by yourself.

Pull out the filter

IMPORTANT REMINDERS

T o avoid damages or injuries , do not move vacuum when the clips are unlocked.

Use wire and plug correctly

Pull out the plug when

not in use

This is t o avoid possible electric shock or fire, etc.

Avoid incorrect operation

Do not put metal into the connector of this machine (To avoid electric shock)

Do not pull the plug by the wire

Do not pull or move the machine by pulling the hose

Please use the handle to move or pull it

K eep the vacuum at a safe distance from fire/heat source or sunlight

Cleaning and Maintenance

1. Turn off the switch

“ o” for

OFF

“-” for ON

2 .

Pull out the plug and put the wire in order

5 .

Pull out

the filter, wash and dry it for next use

6 .

Clean the tank and dry with a soft cloth

3.

Take off the hose and floor brush

4 .

Pull out

the head as shown in

the picture

Operation

To prolong your vacuum's life

Do

not collect the following as it may cause vacuum's breakdown:

C onstruction rubbish / powder

Ash or any flammable material

Glass/tins/needles/toothpicks

R opes/stockings or the like

Do

not use the hose or the rod

to collect dust

directly to avoid wear

Always u se the floor brush or crevice nozzle etc.

to pick up dirt / water

Do

not block the air-outlet

If

the suction mouth is blocked

, unblock it first

before using the vacuum

Please check whether the cloth or HEPA filter i s installed before operating

U se the hose carefully to avoid damage

To avoid the motor overheating , do not use it contin uous ly for more than half an hour . Also, it's time to service the vacuum when:

T he tank is full of dust / dirt

T he suction mouth is blocked

T he hose, rod or nozzle is blocked

Protective Device

Special instruction s for the protective device

When the tank is full of water, th is Protective D evice will rise up

.

S uction power will stop but an abnormal noise

may indicate that the motor is running at a high speed. If this happe ns

, cut off the power

immediately

and pour out

the water

from the tank

.

When vacuum cleaner overturn s

or shak es excessively

, the

Protective D evice may not work correctly. What you should do is to switch off the machine and turn it upright before continuing to use the vacuum.

Raising of

water level

When the tank is full of water, the

Protective Device

will rise up, suction power will cut off

. Pour out all the water from the tank before resuming operation.

Tips on cleaning filters

Diagram of cloth filter Diagram of HEPA filter

BEFORE CLEANING:

Turn off the power and pull out the plug.

Use brush to clean the dust o ff the filter

Use tap to wash the filter from inside to outside for better clean.

Put the filter in a well-ventilated place to air-dry it.

Store it properly for your next use.

AFTER CLEANING:

Be sure to thoroughly dry the filter

( t o avoid bad smell or block age

)

Do not use an air blower to dry the filter t o avoid getting it out of shape and making it unsuitable to use.

Do not use detergent/bleach/thinner/alcohol etc. (to avoid causing cracks and fading its color)

More Safety Reminders

Please observe the following to avoid personal injury or property los s

Do not collect cigarette/ gasoline/printing ink/ thinner or other flammable material

Do not use when the plug or cable is damaged.

(To avoid causing fire because of overheating)

Do not collect plaster dust as it will cause damage to the vacuum.

Do not wash by water (besides washable parts)

Do not use in bathroom

, damp environment

.

Do not disassembly, repair or transform it by yourself ( t o avoid fire or electronic shock)

The appliance is not intended for use by persons

(including children) with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Make sure that the plug is tightly inserted i nto the socket t o avoid electric shock or fire .

U se an

AC socket separately

.

Pull out the plug before you clean your machine.

Clean the machine regularly causing bad insulation or

to avoid damage.

Ensure that

the filter is installed when in operation t o avoid the motor burning

Do not pull out the plug with wet hands t o avoid electric shock .

Immediately cut off the power and remove the plug when the following happens:

The appliance does not work after you switch it on.

The machine is out of shape or hot

to the touch.

Stops work ing all of a sudden.

Cuts off and on.

*** Have the vacuum checked by a designated service center.

The hose is damaged

Burnt smell

Abnormal noi s e during your usage