n
A
bi
+
x
=
e
[3
TK355:"
EDITION
Max 2000 Lumens
User manual
Illuminate Your Adventure
TK35 Ultimate Edition
Fenix TK35UE, this upgraded flashlight integrates
exquisite craftsmanship and high performance. With
Cree XHPS50 LED, it delivers maximum output of 2000
lumens, five brightness levels plus Strobe and SOS, but
from more compact body. The dual tail button switch is
convenient for fast and simplified operation, realizes
one-handed momentary-on function and mode switching.
Moreover, paralleled battery compartment, compatibility
with both 18650 rechargeable Li-ion and CR123A
batteries make it outstand in outdoor searching, caving,
standby application for driving and more.
* Uses Cree XHP 50 LED with a lifespan of 50,000 hours
* Powered by two 18650 rechargeable Li-ion batteries or
four 3V CR123A Lithium batteries
Xx 161mm(length) X 50mm(head diameter)
# 240 grams(excluding batteries)
* Digitally regulated output maintains constant
brightness
* Reverse polarity protection, to protect from improper
battery installation
# Low-voltage reminder indicates when battery
replacement is needed
» Dual tail button switch for simple and fast operation
xy Made of durable aircraft-grade aluminum
Xy Premium Type Ill hard-anodized anti-abrasive finish
* Toughened ultra-clear glass lens with anti-reflective
coating
Technical Parameters
ANSI/NEMAFL 1
General M
ode
Turbo High Mid
Strobe sos
Low Eco
+ OUTPUT
2000 Lumens | 1050 Lumens | 380 Lume
ns
120 Lumens | 20 Lumens | 2000 Lumens 380 Lumens
® RUNTIME 1h15min* | 3h10min** | 9h15mir 33h 160h / /
EE DISTANCE 320m (Max)
& INTENSITY 25600cd (Max)
а IMPACT am
“Y” WATERPROOF IPX-8,underwater 2m
Lanyard, holster, spare O-ring
Note: The above-mentioned parameters (lab-tested by using Fenix ARB-L
between flashlights, batteries and environments.
*Due to the ad setup of automatically turning to High from Turbo
accumulated tim
**Due to the protective setup of automatically turning to Mid from High
accumulated time.
Operation Instruction
Dual Tail Button Switch
The big tail switch is power switch, and the small one is mode switch.
ON/OFF
Slightly tap the power switch to turn on the light temporarily, release it
the light will go out
Fully press the power switch to turn on and lock the light constantly,
press once again to unlock and turn off the light.
Output Selection
With the light on, single-click the mode switch to cycle through
Turbo—Eco—Low—Mid—High.
Strobe and SOS
With the light on, press and hold down the mode switch for 1 second
to enter Strobe mode.
With the light on, press and hold down the mode switch for 3 seconds
to enter SOS mode.
Under Strobe and SOS mode, single-click the mode switch to turn
back to general output mode.
2-3400 18650 rechargeable Li-ion battery) are approximate and may vary
after working 5 minutes, the runtime of the Turbo brightness level is the
after working 30 minutes, the runtime of the High brightness level is the
Intelligent Memory Circuit
The flashlight memorizes the last used brightness level of general
mode, but it will not remember the Strobe and SOS mode. The next
time you turn it on, it will recall that previously brightness level.
Over-heat Protection
The flashlight will accumulate a lot of heat when it is working at Turbo
or High brightness level. When it works at Turbo for 5 minutes or at
High for 30 minutes, the flashlight will automatically adjust the output
to prevent the light from overheating. If the Turbo or High output is
needed, please reset it again.
Low-voltage Warning
When the voltage level drops below the preset level in using 18650
rechargeable Li-ion batteries, the flashlight is programmed to
downshift to a lower brightness level. When this happens in Low
output mode, the flashlight blinks three times every five minutes to
remind you to replace the battery. To ensure normal use, the
flashlight will not turn off automatically and will work until the batteries
run out completely.
Battery Specifications
Type Usability
Warning: Please do not mix batteries of different brands, sizes, capacities or
a Doing so can cause damage to the flashlight or the batteries being
0650/16340 Li-ion batteries are powerful cells designed for commercial
applications and must be treated with caution and handled with care. Quality
batteries with circuit protection will reduce the ial for combustion or
explosion but cell damage or short circuiting are potential risks the user
Battery Replacement
a. the light head to take out the ‚battery holder Insert the
e bottom
Put the battery holder into he tube with “he round side towards the
light head and the raised place in the side towards the groove in the
inner wall of the tube. Screw the light head back on.
Usage and Maintenance
© Disassembling the sealed head can cause damage to the light and will
void the waa nty.
be used for an extended period, remove the Better or yr the e NICH could be
damaged by
Unscrew the tail cap one-half tum or : take out the battery to prevent
y transportation.
heat protection or tant beam trembling, to maintain normal status, please
ower
o Long-term use can result in O-ring wear. To maintain a proper water seal,
replace the ring with an approved spare
© Periodic cleaning of the battery contacts improves the flashlight's
performance as dirty contacts may cause the fiashlight to flicker, shine
eason nA: The batteries need replacing.
Solution: Replace batteries (Please confirm the correct installation of anode
and cathode).
Reason B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing
alcohol.
If the above methods don't work, please refer to the warranty policy
haf ized distrib rt
Notice: The routine cleaning video can be watched and downloaded
through Fenix official website, please log onto the service channel-
>"maintenance for light".
Product Warranty
Fenix will replace products with documented manufacturing defects
within 15 days of purchase and repair a light free of charge within 5
years of purchase if problems develop with normal use; if repair is
required after 5 years from the date of purchase, Fenix will charge for
parts. The total repair fee is dictated by the cost of the replaced
materials.
Product Registration
Fenix suggests you register your product on the official website for
Fenixlight Limited (www.fenixlight.com). You can get an extra six-
month warranty period once you have successfully registered. By
participating in an optional customer survey, you are entered in a
drawing for free Fenix products.
Warning
The flashlight is a high-intensity lighting device capable of causing
eye damage to the user or others. Avoid shining the light directly into
anyone's eyes.
">