User`s Manual
Aimpoint AB
Jägershillgatan 15
SE- 213 75 Malmö, Sweden
Phone +46 (0)40 671 50 20
Fax +46 (0)40 21 92 38
e-mail: [email protected]
User’s Manual
Aimpoint Micro® Sight
Mounting Kit for
Ruger Mark III pistols
Aimpoint Inc.
14103 Mariah Court
Chantilly, VA 20151-2113, USA
Phone +1 703-263-9795
Fax +1 703-263-9463
e-mail: [email protected]
© 2008 - Contents property of Aimpoint
All rights reserved. [12505-0]
This Aimpoint Mount Kit is designed for mounting
an Aimpoint Micro red dot sight using the existing
mounting holes on a Ruger Mark III .22 caliber pistol.
An Aimpoint Micro red dot sight is not included in
the kit.
Physical Specifications
(The Micro Sight excluded)
Dimensions Length:
71 mm (2.8”)
20 mm (0.8“)
10 mm (0.4”)
25 grams (0.9 oz).
25 grams (0.9 oz).
Material – Mount:
High strength aluminum, anodized.
Material – Screws:
Stainless steel
Matte black or matte silver.
Hazardous Materials: None
Instructions for use
Read the instructions below carefully, and if you are
unsure of your ability to safely follow any of these
directions, STOP and bring your pistol and mount to
a qualified gunsmith for assistance. Do not attempt
to utilize this mounting kit on any firearm other than
a Ruger Mark III pistol with factory drilled mounting
holes! Do not attempt to use this mounting kit with
any sight other than an original Aimpoint Micro sight
purchased from an authorized Aimpoint Dealer.
A) Important: Place the two screws (#2) into the end
holes of the sight bracket before securing the
Aimpoint sight to the bracket!
B) Secure the Aimpoint Micro sight (#3) to the mount
bracket (#1) with four screws (#4), max torque
0,9 Nm (0,664 lbf ft), using the Torx head bit on
tool (#5).
C) Firmly secure the mounting bracket to the pistol
using the Allen wrench (#6).
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF