Bul. 140G/140MG
DIR 1000721R0607 Version 01 - 140G-H-EA1R1B ; 140G-H-EA2B
Wired auxiliary contacts, 400V (AX2+AL1) or (AX1+AX2) for 140G-H, 140G-J
Contatti ausiliari cablati
Hilfskontakte verdrahtet
Contacts auxiliaires câblés
Contactos auxiliares cableados
Installation - Installazione - Instalación
Instalação - -
WARNING: To prevent electrical shock, disconnect from power source before installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
(Seguire i requisiti NFPA70E).
WARNUNG: Vor Installations- oder Servicearbeiten Stromversorgung zur
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen
Sie die Anforderungen nach NFPA70E).
AVERTISSEMENT: Avant le montage et la mise en service, couper l'alimentation secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs. (Vous devez respecter la norme NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de contaminantes. (Cumpra as exigências da norma NFPA70E).
警告：感電事故防止のため、取付けまたは修理の際は電源から取り外してく
ださい。適切なケース内に取付けてください。また、汚染物質がないことを
確認してください。（
NFPA70E
の要件に従ってください）
警告：为了防止触电，在安装或维修之前必须先切断电源。安装在合适的设备
物
140 G-H-EA1R1B
140G-H
1
CLACK
140G-J
140 G-H-EA2B
AX2+AL1
Electrical diagram label
AX1+AX2
Electrical diagram label
Catalog number label
DIR 1000721R0607 Version 01
Catalog number label
1
2
3
1
2
2
- If present
- Se presente
- Falls vorhanden
- Si présent
- Si lo hay
3
5
5
6
- If present
- Se presente
- Falls vorhanden
- Si présent
- Si lo hay
CLICK
4
140G-H, 140G-J
DIR 1000721R0607 Version 01
(2)
3
4
6
DIR 1000721R0607 Version 01
AX2+AL1
5
Optional
AX1+AX2
7
Optional
(3)
Remove the plugs
AX2+AL1
Optional
AX1+AX2
Optional
8 9
140G-H, 140G-J
1
2
3
3
CLICK
4
DIR 1000721R0607 Version 01
5
5
7
6
6
- If present
- Se presente
- Falls vorhanden
- Si présent
- Si lo hay
9.7 lb-in
1.1 Nm
(4)
8
Apply labels
10
22 24 96 98
AX2
AL1
12 14 22 24
AX1 AX2
21 95 11 21
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Rockwell Automation maintains current product environmental compliance information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/ sustainability-ethics/product-environmental-compliance.page
Publication 140G-IN103B-MU-P - February 2016 DIR 1000721R0607 Version 01 (L8904) - B0613
Copyright © 2016 Rockwell Automation, Inc. All Rights Reserved. Printed in Italy.
