Bul. 140G/140MG
DIR 1000479R0822 Version 01 - 140G-M-EXT3, 140G-M-EXT4, 140G-M-EXSLI3, 140G-M-EXSLO4, 140G-EXS4
Extended front terminals and spread extended front terminals for 140G-M
Terminali anteriori prolungati e terminali anteriori prolungati divaricati
Vorderseitige verlängerte Anschlüsse und vorderseitige verlängerte V-förmige Anschlüsse
Prises de raccordement avant prolongées et prises de raccordement avant prolongées écartées
Terminales frontales prolongados y terminales frontales prolongados separados
加长前接线端⼦ 和扩展加长前接线端⼦ 140G-M 固定式
Installation - Installazione - Instalación
Instalação - -
WARNING: To prevent electrical shock, disconnect from power source before installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
(Seguire i requisiti NFPA70E).
WARNUNG: Vor Installations- oder Servicearbeiten Stromversorgung zur
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen
Sie die Anforderungen nach NFPA70E).
AVERTISSEMENT: Avant le montage et la mise en service, couper l'alimentation secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs. (Vous devez respecter la norme NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de contaminantes. (Cumpra as exigências da norma NFPA70E).
警告：感電事故防止のため、取付けまたは修理の際は電源から取り外してく
ださい。適切なケース内に取付けてください。また、汚染物質がないことを
確認してください。（
NFPA70E
の要件に従ってください）
警告：为了防止触电，在安装或维修之前必须先切断电源。安装在合适的设备
物
3p 4p
140G-M-EXT3
140G-M-EXT4
140G-M-EXSLI3
140G-M-EXSLO3
140G-M-EXS4
DIR 1000479R0822 Version 01
1
3
140G-M-ETX3
140G-M-ETX4
80 lb-in
9 Nm
CH 6
2 140G-M-EXSLI3
140G-M-EXSLO3
80 lb-in
9 Nm
CH 6
140G-M-EXS4
Installation of lower spread terminal not shown in illustration
80 lb-in
9 Nm
CH 6
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Rockwell Automation maintains current product environmental compliance information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/ sustainability-ethics/product-environmental-compliance.page
Publication 140G-IN039B-MU-P - May 2016 DIR 1000479R0822 Version 01 (L5324) - B0908
Copyright © 2016 Rockwell Automation, Inc. All Rights Reserved. Printed in Italy.
