Star Water HSPJ100 Portable Lawn Sprinkler Pump Quick Start Guide 2 Pages
Star Water HSPJ100 Portable Lawn Sprinkler Pump
If you are looking for a simple and effective way to keep your lawn lush and green, the Star Water HSPJ100 Portable Lawn Sprinkler Pump is a great option. This pump can draw water from a variety of sources, including pools, ponds, and even rain barrels. It has a maximum vertical distance of 20 feet, so you can easily reach even the highest parts of your lawn. The pump also features an adjustable flow rate, so you can customize the amount of water that is applied to your lawn.
The Star Water HSPJ100 Portable Lawn Sprinkler Pump is easy to set up and use. Simply connect the pump to a water source and a garden hose, and then turn it on. The pump will automatically start pumping water and will continue to do so until you turn it off. It's also relatively quiet, so you can use it without disturbing your neighbors or family.
advertisement
Outlet
BOOSTER
UTILITY PUMP
MODEL HSPJ100
QUICK START GUIDE.
SEE INSTRUCTION
MANUAL FOR
COMPLETE DETAILS.
Water Source
Maximum
20 Ft.
Vertical
Distance
Foot Valve
1. Set pump as close as possible to the water source, keeping the vertical distance from the water to pump as short as possible and no more than 20 ft.
A foot valve with strainer (not provided) should be installed at the end of the suction hose or pipe to maintain prime during operation.
Priming Port
Inlet
2. Connect garden hose or 1-in pipe to pump inlet and outlet.
3. Remove priming nut on pump and fill cavity with water. Reinstall priming nut.
RESET
RESET
TESTTEST
4. Turn the switch to the ‘off’ position and plug power into GFCI outlet. Turn the switch to the
‘on’ position to begin pumping.
WARNING:
FOR YOUR PROTECTION, ALWAYS DISCONNECT
PUMP FROM POWER SOURCE BEFORE HANDLING.
Printed in China SW1430 A
BOMBA
REFORZADORA
PARA USO
GENERAL
MODELO HSPJ100
GUÍA DE INICIO RÁPIDO
CONSULTE LOS DETALLES COMPLETOS
EN EL MANUAL DE INSTRUCCIONES
Water Source
Maximum
20 Ft.
Vertical
Distance
Foot Valve
1. Coloque la bomba lo más cerca posible de la fuente de agua, manteniendo la menor distancia vertical posible desde el agua hacia la bomba, a no más de 6,09 metros.
Se debe instalar una válvula de pie con colador (no incluida) en el extremo de la manguera o del tubo de succión para mantener el cebado durante el funcionamiento.
Outlet
Priming Port
Inlet
2. Conecte la manguera para jardín o la tubería de 1 pulg. a la entrada y la salida de la bomba.
3. Retire la tuerca de cebado de la bomba y llene la cavidad con agua. Vuelva a instalar la tuerca de cebado.
RESET
RESET
TESTTEST
ADVERTENCIA:
PARA SU PROTECCIÓN, DESCONECTE SIEMPRE
LA BOMBA DE LA FUENTE DE SUMINISTRO
ELÉCTRICO ANTES DE MANIPULARLA.
4. Coloque el interruptor en la posición ‘off’ (apagado) y enchufe el cable eléctrico en un tomacorriente con GFCI. Coloque el interruptor en la posición ‘on’
(encendido) para comenzar a bombear.
Impreso en China
advertisement
Related manuals
advertisement