Kincrome K11100 Digital Vernier Caliper 150mm Metric Manual
kincrome K11102 is an electronic measuring tool that, thanks to its accuracy (with a resolution of 0.01mm) and wide measuring range, will be perfect for various types of measurements regardless of whether you are a DIY enthusiast or a professional. The device has three measuring modes: internal, external and depth. A large LCD display and intuitive user interface make it easy to use. Other advantages include quick conversion between inches, millimeters and fractions of an inch, as well as an auto power-off function that turns off the device after 5 minutes of inactivity, saving battery power.
Advertisement
Advertisement
USER’S MANUAL OF DIGITAL CALIPER
K11100 / K11102 / K11103
0-150MM (3V BATTERY)
• MAINTENANCE INSTRUCTIONS
1. Before using a digital caliper, clean the surface of the protective sticker with dry and clean cloth (or soaked with cleaning oil).
2. Never apply voltage (e. g. engraving with an electric pen) on any part of the Digital Caliper for fear of damaging the circuit.
3. Take out the battery if it’s not used for a long time to save power.
• TECHNICAL SPECIFICATIONS
Resolution: 0.01mm
Power: One button cell battery 3V
Measuring speed: ≤1.5m/s
Working temperature: 0~+40
Relative humidity: <80%
Storage temperature: -10 ° C~+60 ° C
Auto-power off
• DIGITAL CALIPER STRUCTURES
1. Step Measuring Face 2. Inside Measuring Face 3. LCD Display 4. Locking Screw
5. Battery Cover 6. Caliper Body 7. Protective Sticker 8. Depth Bar 9. Housing
10. Zero Setting Button 11. in/mm/F conversion button 12. Slider 13. Outside Measuring Face
• FUNCTION
1. Zero-setting at any point for incremental measurement.
2. in/mm/F conversion at any point.
• OPERATIONS
1. TO TURN ON
(1) Dry the surface of the protective sticker and clean the measuring surfaces.
(2) Loosen the locking screw and move the slider.
(3) The digital caliper is now ready for use.
2. MEASUREMENT
(1) Press in/mm/F to choose desired unit system.
(2) Then move the slider to make two outside measuring faces touch gently and press Zero button to start regular measuring.
3. BATTERY REPLACEMENT
Abnormal display (digits flashing or even no display) shows a flat battery and it should be replaced. Pull out battery cover (5) to take out the battery and put in a new battery.
Note: The positive pole of the battery must face upwards.
Important: If the user does not intend on using the device for a long period of time, please remove the battery, this will reduce the risk of a leaking battery and will also increase the life span of the battery.
Auto-Off Function - 5 Minutes after last use
• BRIEF ON MAINTENANCE
Troubles
Flashing Digits
No Display
Fixed Digits
Possible Causes
Low voltage
Solutions
Replace the button cell
1. Low voltage
2. Poor contact
1. Replace the button cell
2. Adjust and clean the battery seat
Accidental trouble in circuit Take out battery and put it back after one minute
Measuring Diagram

Public link updated
The public link to your chat has been updated.
Advertisement