Graco Battery Kit 245343 Owner's Manual | Manualzz
INSTRUCTIONS
309406B
KEEP FOR REFERENCE.
Read this and all related manuals for
important warnings and instructions.
INSTRUCTIONS
10 mph (16 kph) Maximum Operating Speed
Battery Kit 245343
The Battery Kit allows the LineDrivert electrical
system to power additional electrical equipment. The
LineDriver generates approximately 70W at full
throttle, the light consumes 55W. The electrical system automatically keeps the battery charged when
light and/or additional electrical equipment are not in
use. If the light and additional electrical equipment
exceed 70W consumption for long periods of time,
without battery recharge from the electrical system, it
may be necessary to charge battery with an external
charger.
S
The LineDriver will not charge a dead battery;
battery must be initially charged before use.
The electrical system charges the battery between 8 to 14 volts.
S
Connect additional 12 volt DC equipment connections directly to battery. Use only 2-wire
devices that are ground isolated. Never connect ground wires or any wires to frame. Use
appropriate fuse on all additional equipment.
S
The switch on the circuit board switches the
light from regulated power from the engine
(BACK – slide switch towards engine), to DC
power from the battery (FORWARD – slide
switch away from engine). The battery will not
charge when switch is in BACK. If the battery
becomes dead at any time, slide the switch to
BACK for the light to work.
S
Replace battery only with (completely sealed
lead acid type) Graco 115753.
GRACO INC.
P.O. BOX 1441
Trouble Shooting: with battery installed
Problem
Possible
Cause
Solution
Battery does
not hold charge
Bad battery
Replace battery
Battery voltage
too low
BACK/FORWARD switch is
at BACK
Slide switch to
FORWARD.
Charge battery
with battery
charger
Light does not
light
Bad bulb
Replace bulb
Bad battery
connections
Slide switch to
BACK. If light
works, check
battery voltage.
If light does not
work and bulb
is good, check
battery connections.
MINNEAPOLIS, MN
ECOPYRIGHT 2001, GRACO INC.
Graco Inc. is registered to I.S. EN ISO 9001
55440–1441
A
To Battery
(optional)
59
7
5
B
3
8
9
6
1
4
2
77
Ref.
No.
Part No.
Description
1
2
3
4
5
6
7
8
9
115753
198974
107069
107068
100016
110755
100011
100057
100214
BATTERY, 12V
BOX, battery
CLAMP, battery
BOLT, hook
WASHER, lock
WASHER, plain
NUT, wing
SCREW, cap, hex hd
WASHER, lock
126
76
Ref B. Connects to Honda
Engine Alternator
Qty.
1
1
1
2
2
2
2
2
2
ti1656b
Ref A. Use Only for Graco
Battery Kit Number 245343
Switch
(no battery)
position
126 Bottom View
Ref 59. Light Jack
Graco Phone Number
TO PLACE AN ORDER, contact your Graco distributor, or call 1–800–690–2894 to identify the nearest distributor.
All written and visual data contained in this document reflect the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
mm 309406
This manual contains English
Graco Headquarters: Minneapolis
International Offices: Belgium, Korea, China, Japan
GRACO INC.
P.O. BOX 1441
MINNEAPOLIS, MN
http://www.graco.com
11/2001, Rev 8/2006
2
309406
55440–1441
Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Download PDF

advertisement