Graco 3A1586B - ThermoLazer Box Rear Heat Kit Owner's Manual


Add to my manuals
2 Pages

advertisement

Graco 3A1586B - ThermoLazer Box Rear Heat Kit Owner's Manual | Manualzz

Instructions

ThermoLazer

Box Rear Heat Kit

Model 24H626

3A1586B

- For professional application of thermoplastic traffic marking compound materials

(reflective beads applied simultaneously with screeding) -

- For outdoor use only (not to be operated in rain or damp conditions) -

EN

IMPORTANT SAFETY INSTRUCTIONS

Read all warnings and instructions in manual 3A1319. Save these instructions.

ti17139a

Installation

1.

Disconnect propane source.

3.

Slide die heat kit over bead dispenser. Align slot on bracket with bead dispenser screw head as shown.

Bolt hole should also be aligned. ti14128a ti17144a

2.

Remove plug and copper gasket(ferrule) from fitting.

4.

Route hose as shown below.

ti17156a ti17154a

5.

Attach hose swivel to fitting (21mm).

ti17155a ti17157a

6.

Install screed box rear burner lighting instruction label (262) on screed shroud door below the torch lighting instruction label (261).

2 ti14144a

All written and visual data contained in this document reflects the latest product information available at the time of publication.

Graco reserves the right to make changes at any time without notice.

Original instructions. This manual contains English. MM 3A1586

Graco Headquarters: Minneapolis

International Offices: Belgium, China, Japan, Korea

GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA

Copyright 2008, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.

www.graco.com

Revision B- APRIL 2012

3A1586B

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement