Graco 308654A FTx Spray Gun Swivel Replacement Kit Owner's Manual

Add to my manuals
2 Pages

advertisement

Graco 308654A FTx Spray Gun Swivel Replacement Kit Owner's Manual | Manualzz

INSTRUCTIONS-PARTS LIST

This manual contains important warnings and information.

READ AND KEEP FOR REFERENCE.

INSTRUCTIONS

308–654

Rev. A

FTx Spray Gun

Swivel Replacement Kit

GENERAL REPAIR INFORMATION

WARNING

INJECTION HAZARD

The system pressure must be manually relieved to prevent the system from starting or spraying accidentally. Fluid under high pressure can be injected through the skin and cause serious injury. To reduce the risk of an injury from injection, splashing fluid, or moving parts, follow the Pressure Relief Procedure whenever you: are instructed to relieve the pressure, stop spraying, check or service any of the system equipment, or install or clean the spray tip.

Pressure Relief Procedure

1. Engage the gun safety latch.

2. Turn the ON/OFF switch to OFF.

3. Unplug the power supply cord.

4.

Disengage the gun safety latch. Hold a metal part of the gun firmly to a grounded metal pail. Trigger the gun to relieve pressure.

5. Engage the gun safety latch.

6. Open the pressure drain valve. Leave the pressure drain valve open until ready to spray again.

If you suspect that the spray tip or hose is completely clogged, or that pressure has not been fully relieved after following the steps above, VERY SLOWLY loosen the tip guard retaining nut or hose end coupling to relieve pressure gradually, then loosen completely.

Now clear the tip or hose obstruction.

Test your repair before regular operation of the sprayer to be sure the problem is corrected.

GRACO INC.

P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441

COPYRIGHT 1996, GRACO INC.

Graco Inc. is registered to I.S. EN ISO 9001

Service

Replace Swivel

(See Fig. 1)

Disassembly

1.

Follow Pressure Relief Procedure on page 1.

2.

Push up on trigger guard (12) and swing trigger guard away from trigger (5).

3.

Unscrew gun handle (6) from housing (26).

Remove filter and clean in compatible solvent.

4.

Remove swivel (15), guard retainer (42) and cushion o-ring (43).

5.

Save guard retainer and cushion o-ring.

Reassembly

1.

Clean internal thread of handle (6).

2.

Install guard retainer (42), cushion o-ring (43) and swivel (15).

3.

Apply anaerobic sealant (included in Swivel Kit

238–817) to external thread of swivel (15) that connects to handle (6).

4.

Install swivel (15) into handle (6). Torque swivel to

250 in-lb.

5.

Engage trigger guard (12) to retainer guard (42).

Fig. 1

12

6

42

43

15

Sales Offices: Atlanta, Chicago, Detroit, Los Angeles

Foreign Offices: Belgium, Canada, England, Korea, Switzerland, France, Germany, Hong Kong, Japan

GRACO INC.

P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441

PRINTED IN U.S.A. 308–654 March 1996

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement