G LALA C-401 C-401 Switching Rapid Charger USER MANUAL CHARGER OPERATION Congratulation on your purchase of the outstanding PowerBase Switching Rapid Charger C-401. This manual will help you understand how to operate 1 : Connect the power supply by AC/DC adaptor this Charger and Batteries. or 12V car DC adaptor. Tom The Blue LED will be light up that indicate the FEATURES OF C-401 RAPID CHARGER charger in standby state. _ - 2 or 4 AA / AAA size Ni-MH batteries can be charged. | - Blue & Red LED Indicator for standby, charging and complete states. - Trickle pre-charge and trickle maintain functions. - Adopt non-continuum pulse charging current to avoid memory effect. (romeo ]} It enhances the charging efficiency and reduce the temperature of the batteries. So, the batteries will has better performance and longer cycle life. - Can be used in indoor by an AC adaptor or outdoor by 12V DC car 2 : Put the button on the upright position when adaptor. charging AA or put the button on the level Porrera - Possess reverse polarity protection. position when charging AAA batteries. *C-401 Charger is designed to charge 2 or 4 AA/ AAA sizes Ni-MH batteries. Please refer to the combinations below; AAA size (1) For 2 AA or AAA size Ni-Mh Cells. PowerBase | < 3! = 3 : Charge 2 piece batteries, put the switch to N mark ' 2 location. a When charge 4 piece batteries, put the switch to mark ' 4' location. Select the 2 or 4 AA/ AAA Y LILILIL ] 2 piece AA/AAA size Ni-MH Battery AA Ni-MH Battery AA PowerBase PowerBase 4 : The charger will Automatically detect and charging when the batteries put correctly. (2) For 4 AA or AAA size Ni-Mh Cells. | | Ш Nx | Standby mode and PowerBase Blue LED light up when the charger is in —z— | function state. standby mode. Blue Light < Red LED light up and flash that indicate the < | batteries to charging in a high speed. Bator < atteries charging < N 1, у state. ал 2 After fully charged the LED will change to Blue NS from Red. Then, the charger is going to == trickle current. Red Light \ AA Y N N Ч ~ 4 piece AA/ AAA size PowerBase } Ni-MH Battery AA Ni-MH Battery AA PowerBase Ni-MH Battery AA Ni-MH Battery AA PowerBase PowerBase CHARGER SPECIFICATION : Ne NOTE : Never put Ni-MH and Ni-Cd batteries together in the PowerBase Rapid Charger Switching : 100~240V 50~60Hz CAUTION International Voltage (UL, VDE, SAA, JIS) LA Ar 12V DC Car Adaptor 1. Do NOT recharge Ni-Mh & Ni-Cd rechargeable batteries at the same time. 2. This product is designed for Ni-Mh & Ni-Cd rechargeable batteries only. Battery Type / Size Ni-MH AA & AAA Batteries To avoid personal injury and damage, do not charge any primary alkaline, zinc chloride, or zinc carbon type batteries. 3. Do not expose the charger to rain or moisture. Charging Current 4. Do not operate the charger using an extension cord. 2000mA ~ 2500mA / AA 1000mA - 1300mA / AAA 5. Do not use the charger if it has received a sharp blow, been dropped, Or damaged in anyhow. Charging Mode Pulse charging current 6. To reduce risk of shock, disconnect the AC power source (AC adaptor) from outlet before attempting any cleaning of the charger. Trickle Charge Trickle pre-charge and trickle maintain function 7. Do not charge a leaking, corroded or dead battery. 8. Do not attempt to repair charge by yourself, when service or repair is Termination Method Minus Delta V (-AV) required. Contact qualified service personnel. 9. Do not try to disassemble the charger. Timer Cut-off function 90 minutes charging time limit 10. Store the charger in a cool and dry place when not in use. Keep away from children. Operation Temperature -10°С ~ 40°C PLEASE NOTE: *PowerBase Industrial (HK) Ltd. will not be responsible for any personnel loss and/or injury if the defect was caused by misuse or mishandling by the user in any way.