Everbilt 22-0003R-00 3-Bolt Extended Sink Flange Universal Installation Guide

SINK FLANGE & EXTENDED SINK FLANGE INSTALLATION

READ CAREFULLY AND COMPLETELY BEFORE STARTING

LOWER MOUNT RING sink flanges and the parts in gray below are not included but for illustration purposes only.

STOPPER

REMOVABLE SPLASH GUARD

SINK FLANGE

(Not Shown-Extended SInk Flange. 1” Longer)

FIBER GASKET

DISHWASHER INLET

MOUNT TAB

DISPOSER CUSHION RING

NOTE: As the mounting assembly is properly assembled at the factory, please pay close attention to the order of the mounting system parts.

SUPPORT FLANGE

UPPER MOUNT RING

MOUNT SCREWS

RETAINER RING

CUSHION RING*

Sink

LOWER MOUNT RING*

MAGNETIC CATCH RING

ATTACHMENT INCLUDED WITH

MODELS EB750, EB750-SL &

EB1250-HT (See page 8 for installation)

* Part not disengaged during disposer installation.

Removable Splash Guard

Sink Flange

Plumber’s Putty (not included)

Groove

Fiber Gasket

Support Flange

Upper Mount Ring

Mounting Screw

Retainer Ring

Cushion Ring

Lower Mount Ring

Rubber Gasket

Elbow Flange & Screw Set (2)

Elbow

Spring Clamp Ring

Elbow

OR

EB1250-HT

MODEL ONLY

(2. CONTINUED) INSTALLATION OF MOUNTING ASSEMBLY

A. The Cushion Ring and the Lower Mount Ring will remain attached to the disposer during installation . Take apart the other parts of the mounting assembly by rotating the Lower Mount Ring

( J on page 3 ) clockwise until the Lower Mount Ring Tabs slide off from the Upper Mount Ring ramp ( A1 ). This allows you to pull the Sink Flange up and out of the remaining Lower Mount Assembly. Note the order of these parts as they are arranged in the required order. Unscrew the 3

Mount Screws until the Upper Mount Ring can be moved to the top of the

Support Flange. Remove the Retainer Ring with a flat head screw driver.( A2 )

A1

B. Keep the remaining parts placed together in the order they were removed ( B1 ).

Before you connect the disposer to the mount assembly under the sink, make sure the

Lower Mount Ring is in place and the black Cushion Ring is still engaged properly to the top of the disposer hopper ( B2 ).

C. Be sure the sink is clean. Load the underside rim of the sink flange with plumber's putty ( C1 ). From top of the sink, push the sink flange down against the sink opening to make a good seal ( C2 ). DO NOT MOVE OR ROTATE the sink flange once it has been seated or the seal may be broken.

D Place a heavy object, such as the disposer (use a towel to prevent sink scratching) on top of the Sink Flange to hold it down.

B1

B2

C1

A2

C2

E. Take the remaining portion of the mount assembly, that was put aside. From under the sink insert the Fiber Gasket ( E1 ), then the Support Flange ( E2 ), and then the Upper Mount Ring ( E3 ).

F. Hold the three parts in place while attaching the Retainer Ring ( F1 ) by pulling it apart and having it snap within the groove of the sink flange ( F2 ).

G. Tighten the three Mount Screws evenly and firmly against the Support Flange

( G1 ). Do not over tighten.

H. Trim off any excess plumber’s putty in the sink with a plastic knife or something similar that will not damage your sink.

E1

E2

E3

F1

F2

G1

IM-3B-EXSF-201