6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
.
.
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC
29445
Customer Service
Phone 631.273.2700
Fax 631.231.7102
www.quoizel.com
Assembly Instruction Sheet #IS-TRG1816OZ
For Style TRG1816OZ
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Bulb Recommended: (3) Medium Base Decorative Filament 60W bulb (suppled),
Maximum 100W.
Estimated Assembly Time: 20-30 minutes
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject glass parts to any shock while in operation or shattering may result.
L
M
J
K
H
I
N
O
P
Part
A
D
E
B
C
F
G
Package Contents
Description
Crossbar
Nipple
Lock Washer
Hex Nut
Canopy Chain Loop
Canopy Lock Ring
Fixture Chain
Ceiling Canopy
Fixture Loop
Spacer
Fixture Body
Ring
Shade
Shade Holder
Lock Ball
Bulb
Quantity
1 pc.
1 pc.
2 pcs.
2 pcs.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
3 pcs.
3 pcs.
A
E
F
G
H
B
C
D
I
J
K
O
P
N
L
M
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700 or visit us on-line at www.quoizel.com
2014 QuoizelInc.
1of7
May2014
TRG1816OZ
FINISH: OLD BRONZE
2.4mm
13Ga
GND
QUOIZEL
R
1
5” Dia.
1”
Overall Height 70”
(Includes 48” Chain)
20”
2
5.5”
11.5” Dia.
16” Dia.
(3)Medium Base
Decorative Filament
60W bulbs (provided),
Maximum 100W.
NO.
1
2
PART NUMBER
M2374CHOZ
G3643SH
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2 "
REPLACEMENT PART DESCRIPTION
CHAIN OLD BRONZE 3.8MM X 4'
GLASS CLEAR SEEDY 16"D
2of7
REQ.
1
1
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
.
.
Assembly Instruction Sheet #IS-TRG1816OZ
For Style TRG1816OZ
STEP 1
-
Attach Fixture Loop to Fixture Body
A. Place Spacer (J) over the Nipple on the top of Fixture
Body (K), secure by threading Fixture Loop (I) onto the
Nipple. Hand tighten until sung.
Fixture Loop
Spacer
Nipple
STEP 2
-
Install Shade
A. Attach the Shade Holder (N) onto the end of the Side
Arms. Secure by threading the Lock Ball (O) into the ends of the Side Arms. Hand tighten until snug.
B. Place the Shade (M) over the Fixture Body (K), seat onto the Shade Holder (N). Proceed to place the Ring
(L) over the Fixture body (K), seat onto the top edge of the Shade (M).
Fixture Body
Figure 1
Ring
Shade
Fixture Body
Side Arm
Figure 2
Shade Holder
Lock Ball
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700 or visit us on-line at www.quoizel.com
2014 QuoizelInc.
3of7
May2014
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
.
.
Assembly Instruction Sheet #IS-TRG1816OZ
For Style TRG1816OZ
STEP 3
-
Attach Crossbar to Outlet Box
A. Secure the Crossbar (A) to the outlet box with outlet box screws (not supplied). Tighten until snug.
Figure 3
Outlet Box
Mounting
Hole
Crossbar
Outlet Box
Screw (not
Supplied)
STEP 4
-
Attach Nipple to Crossbar
A. Thread one Hex Nut (D) onto the top end of the Nipple
(B).
B. Place one Lock Washer (C) over the top end of the
Nipple (B) and then thread the Nipple (B) into the center lock hole of the Crossbar (A).
C. Using pliers, thread the hex Nut (D) against the
Crossbar (A) and hand tighten until snug.
Crossbar
Lock Washer
Hex Nut
Nipple
Figure 4
STEP 5
-
Attach Canopy Chain Loop to Nipple
A. Thread another Hex Nut (D) onto the end of the Nipple
(B).
B. Place the Lock Washer (C) over the end of the Nipple
(B) and then thread the Canopy Chain Loop (F) onto the end of the Nipple (B).
C. Using pliers, thread the Hex Nut (D) against the
Canopy Chain Loop (F) and hand tighten until snug.
Outlet Box
Crossbar
Lock Washer
Canopy
Chain Loop
Nipple
Hex Nut
Figure 5
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700 or visit us on-line at www.quoizel.com
2014 QuoizelInc.
4of7
May2014
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
.
.
Assembly Instruction Sheet #IS-TRG1816OZ
For Style TRG1816OZ
STEP 6
-
Assemble Ceiling Canopy
A. Push the Ceiling Canopy (H) upward over the Outlet
Box. Thread the Canopy Lock Ring (F) onto the Canopy
Chain Loop (E) and tighten until snug to secure the
Ceiling Canopy (H).
Canopy Chian Loop
Ceiling Canopy
Canopy
Lock Ring
STEP 7
-
Attach Fixture Chain to Canopy
Chain Loop and Fixture Loop
A. Adjust the Fixture Chain (G) to your desired length by removing the links if needed. You may need to use plier to open the chain links. If so, put a cloth over the chain to protect the finish from the pliers.
B. Attach one end of the Fixture Chain (G) onto the
Canopy Chain Loop (E) and then attach the other end of the Fixture Chain (G) onto the Fixture Loop on the top of the fixture.
Fixture Loop
Figure 6
Canopy Chain Loop
Fixture Chain
Supply Wire and
Ground Wire
Figure 7
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700 or visit us on-line at www.quoizel.com
2014 QuoizelInc.
5of7
May2014
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
.
.
Assembly Instruction Sheet #IS-TRG1816OZ
For Style TRG1816OZ
STEP 8
-
Pass Supply Wires through Fixture
Chain
A. Pull the Supply Wires and Ground Wire up through the
Fixture Chain (G) alternating links. Push the wires up through the Canopy Chain Loop (E) into the outlet box.
Canopy Chain
Loop
Fixture Chain
Supply Wire and Ground Wire
Figure 8
STEP 9
-
Make Wire Connections
A. Un-thread the Canopy Lock Ring (F) and slide Canopy Lock
Ring (F) and Ceiling Canopy (H) down the Fixture Chain (G).
B. Push all slack fixture wire through Canopy Chain Loop (E) into Outlet Box. Trim excess fixture wire leaving a minimum of 6 inch. Hanging out of the Outlet Box.
C. Use standard wire connectors to make all wire connections.
(Connectors are not included with fixture.) Strip and prepare wire ends according to instructions supplied with connectors.
D. Connect White Supply Wire from the Outlet Box to Ribbed side from fixture.
E. Connect Black (or Red) Supply Wire from the Outlet Box to
Smooth side from fixture.
F. Connect Ground Wire from the Outlet Box to Ground Wire from fixture.
G. Twist connectors until wires are tightly joined together.
H. Wrap each connection with approved electrical tape and carefully stuff all the connected wires into the Outlet Box.
G. Re-attach the Ceiling Canopy (H) as shown in Step 6.
Supply Wire and
Ground Wire from
Outlet Box
Supply Wire and
Ground Wire
Canopy Chain
Loop
Fixture Chain
Ceiling Canopy
Canopy Lock Ring
White wire from supply Bibbed side from fixture
Figure 9
Black wire from supply
(or Red)
Ground wire from supply
Smooth side from fixture
Ground wire from fixture
Figure 10
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700 or visit us on-line at www.quoizel.com
2014 QuoizelInc.
6of7
May2014
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
.
.
Assembly Instruction Sheet #IS-TRG1816OZ
For Style TRG1816OZ
STEP 10
-
Install Bulb
A. This fixture uses standard bulb 60W (supplied) with a standard screw base. Maximum 100 watts.
B. Insert bulb and screw properly into place.
Your fixture is now assembled and ready to use.
Enjoy!
Figure 12
Bulb
Socket
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700 or visit us on-line at www.quoizel.com
2014 QuoizelInc.
7of7
May2014
