Everbilt 22-MSSG-93 Removable Splash Guard and Stopper Set for 3-Bolt Garbage Disposals Installation Guide

J

K

I

H

E

F

G

C

D

A

B

Removable Splash Guard and

Stopper Set - Instructions

LOWER MOUNT RING

STOPPER

REMOVABLE SPLASH GUARD

(Not Shown-Extended SInk Flange. 1” Longer)

FIBER GASKET

SUPPORT FLANGE

UPPER MOUNT RING

Sink

MOUNT SCREWS

RETAINER RING

CUSHION RING*

LOWER MOUNT RING*

MAGNETIC CATCH RING

ATTACHMENT INCLUDED WITH

MODELS EB750, EB750-SL &

EB1250-HT (See page 8 for installation)

* Part not disengaged during disposer installation.

DISHWASHER INLET

MOUNT TAB

DISPOSER CUSHION RING

NOTE: As the mounting assembly is properly assembled at the factory, please pay close attention to the order of the mounting system parts.

Removable Splash Guard

Sink Flange

Plumber’s Putty (not included)

Groove

Fiber Gasket

Support Flange

Upper Mount Ring

Mounting Screw

Retainer Ring

Cushion Ring

Lower Mount Ring

Rubber Gasket

Elbow Flange & Screw Set (2)

Elbow

Spring Clamp Ring

Elbow

OR

EB1250-HT

MODEL ONLY

(2. CONTINUED) INSTALLATION OF MOUNTING ASSEMBLY

A. The Cushion Ring and the Lower Mount Ring will remain attached to the disposer during installation . Take apart the other parts of the mounting assembly by rotating the Lower Mount Ring

clockwise until the Lower Mount Ring Tabs slide off from the Upper Mount

Ring ramp ( A1 ). This allows you to pull the Sink Flange up and out of the remaining Lower Mount Assembly. Note the order of these parts as they are arranged in the required order. Unscrew the 3 Mount Screws until the

Upper Mount Ring can be moved to the top of the Support Flange.

Remove the Retainer Ring with a flat head screw driver.( A2 )

A1

B. Keep the remaining parts placed together in the order they were removed ( B1 ).

Before you connect the disposer to the mount assembly under the sink, make sure the

Lower Mount Ring is in place and the black Cushion Ring is still engaged properly to the top of the disposer hopper ( B2 ).

Removable

Splashguard

When installing the splash guard, assure that the indentation at the bottom of the splash guard fits snugly to the protrusion at the bottom of the sink flange. Clean the bottom of the splash guard to help prevent odors.

• Allows for insertion of bulk items into the disposal such as rice, coffee grinds, etc.

• See clearly inside the grind chamber, or to remove objects that may have fallen in.

• Easily replace it without having to remove your complete mounting system.

Sink

Stopper

Easily plug your sink with universal fit.

Push the stopper down until it sits tight within the top of sink flange opening.

Fill sink with water to make sure the seal is tight. If water still drains, adjust the fit until it stops the flow completely.

B1

B2

A2

IM-STP-SPLSH-201