Methven AOHRCPUS 1-Spray 6 in. Single Wall Mount Fixed Shower Head Installation guide
Methven AOHRCPUS is a high-rise shower designed for a luxurious and efficient showering experience. Crafted with precision engineering, it offers optimal performance within a wide operating pressure range of 100kPa to 500kPa, ensuring a consistent and satisfying shower. The shower's versatility extends to its temperature adaptability, allowing hot water up to a maximum of 70°C and cold water as low as 5°C, catering to diverse preferences and needs.
Advertisement
Advertisement
Care and Cleaning:
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with contamination free warm soapy water and a damp soft cloth.
Clean filter washer located in the swivel joint periodically.
If shower performance is compromised by the build-up of lime-scale, clean by using a soft toothbrush and gently scrubbing along the spray slot under running water.
AURAJET™ HI-RISE SHOWER
Installation Guide
Technical Specifications:
Operating Pressure:
Min: 100kPa/1bar
Max: 500kPa/5bar*
Optimum: 150kPa/1.5bar - 500kPa/5bar
Operating Temperature:
Hot: Max 70°C*
Cold: Min 5°C
Inlet Connections:
All ½" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at www.methven.com
Methven warrants this product against manufacturing defects and that it is suitable for use under the general operating conditions specified in this instruction sheet. However, regional regulations apply and may affect your warranty. Please refer to www.methven.com
or call customer service for full details.
New Zealand
0800 804 222
439923
Australia
1300 638 483
UK
0800 195 1602
ISSUE A
www.methven.com
•
•
•
•
IMPORTANT: Please read all of the instructions before installation.
General:
• Methven recommends this product is installed by a licensed plumber in compliance with all relevant regional regulations.
After installation all connections must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a safe temperature as per regional regulations.
It is the responsibility of the installer to ensure a waterproof seal is achieved.
NOTE: Some showers may not provide an effective shower when used with gravity fed heated water systems or where pressures are less than 150kPa/1.5bar at the outlet. Additionally showers with flow rates of less than 9L/min may not allow the following to function correctly:
- some instantaneous water heaters
- some tempering valves
- some thermostatic mixing valves
IMPORTANT: Before you begin, turn off the water supply.
13±2mm
• •
•
Step 1
Wall lining hole should be cut or finished as per the dimension shown in the diagram on the right.
Cut off the threaded nipple 13±2mm from the wall lining and apply thread seal tape to ensure a good seal.
26mm max
•
Step 2
Screw the shower arm onto the nipple ensuring that the o-ring is sufficiently compressed to create a watertight seal.
½" BSP Nipple
(Not Supplied)
Hi-Rise Shower
O-ring
•
Step 3
Ensure that the shower arm is oriented vertically with the ‘Top’ sticker on the shower arm oriented upwards.

Public link updated
The public link to your chat has been updated.
Advertisement