MOUNTING ASSEMBLY INSTALLATION
READ CAREFULLY AND COMPLETELY BEFORE STARTING
J
K
I
H
E
F
G
C
D
A
B
STOPPER
REMOVABLE SPLASH GUARD
LOWER MOUNT RING
SINK FLANGE
(Not Shown-Extended SInk Flange. 1” Longer)
FIBER GASKET
SUPPORT FLANGE
UPPER MOUNT RING
DISHWASHER INLET
MOUNT TAB
DISPOSER CUSHION RING
NOTE: As the mounting assembly is properly assembled at the factory, please pay close attention to the order of the mounting system parts.
MOUNT SCREWS
RETAINER RING
CUSHION RING*
Sink
Removable Splash Guard
Sink Flange
Plumber’s Putty (not included)
Groove LOWER MOUNT RING*
MAGNETIC CATCH RING
ATTACHMENT INCLUDED WITH
MODELS EB750, EB750-SL &
EB1250-HT (See page 8 for installation)
* Part not disengaged during disposer installation.
Fiber Gasket
Support Flange
Upper Mount Ring
Mounting Screw
Retainer Ring
Cushion Ring
Lower Mount Ring
Rubber Gasket
Elbow Flange & Screw Set (2)
Elbow
Spring Clamp Ring
Elbow
OR
EB1250-HT
MODEL ONLY
(2. CONTINUED) INSTALLATION OF MOUNTING ASSEMBLY
A. The Cushion Ring and the Lower Mount Ring will remain attached to the disposer during installation . Take apart the other parts of the mounting assembly by rotating the Lower Mount Ring
clockwise until the Lower Mount Ring Tabs slide off from the Upper Mount
Ring ramp ( A1 ). This allows you to pull the Sink Flange up and out of the remaining Lower Mount Assembly. Note the order of these parts as they are arranged in the required order. Unscrew the 3 Mount Screws until the
Upper Mount Ring can be moved to the top of the Support Flange.
Remove the Retainer Ring with a flat head screw driver.( A2 )
A1
B. Keep the remaining parts placed together in the order they were removed ( B1 ).
Before you connect the disposer to the mount assembly under the sink, make sure the
Lower Mount Ring is in place and the black Cushion Ring is still engaged properly to the top of the disposer hopper ( B2 ).
C. Be sure the sink is clean. Load the underside rim of the sink flange with plumber's putty ( C1 ). From top of the sink, push the sink flange down against the sink opening to make a good seal ( C2 ). DO NOT MOVE OR ROTATE the sink flange once it has been seated or the seal may be broken.
D Place a heavy object, such as the disposer (use a towel to prevent sink scratching) on top of the Sink Flange to hold it down.
B1
B2
C1
A2
C2
E. Take the remaining portion of the mount assembly, that was put aside. From under the sink insert the Fiber Gasket ( E1 ), then the Support Flange ( E2 ), and then the Upper Mount Ring ( E3 ).
F. Hold the three parts in place while attaching the Retainer Ring ( F1 ) by pulling it apart and having it snap within the groove of the sink flange ( F2 ).
G. Tighten the three Mount Screws evenly and firmly against the Support Flange
( G1 ). Do not over tighten.
H. Trim off any excess plumber’s putty in the sink with a plastic knife or something similar that will not damage your sink.
E1
E2
E3
F1
F2
G1
IM-3B-201