SILIGUN SG-4-CLK 4 in. Super Compact Heavy-Duty Dripless Caulk Gun for 10 oz Tubes - (Tool Only) Use Instructions

SILIGUN

SET UP AND USE INSTRUCTIONS

STEP 1:

Cut away at the nozzle of your tube . Be sure to cut at least 0.25” from tip to ensure an opening where material can pass fluidly.

STEP 2:

Press down on the clutch

STEP 3:

While clutch is pressed down, insert the tube into the chamber and press down firmly until the tube is caught. Then release the clutch.

STEP 4:

Remove Puncture included with your

Siligun to puncture the seal of your tube… Clean off the puncture pin and place back into the gun for next use.

STEP 5:

Slowly pull down on handle to the base, then release handle to the full extended position, and slowly pull down on handle again to base.

Repeat this step to start working –

The gun will begin dispensing the tube smoothly.

5.

SILIGUN

Removing the tube

STEP 1:

Press down on the clutch to the base.

STEP 2:

While the clutch is being held down, firmly push the tube forward from the back.

If excess tube has been cut from the back, please jump to Step 3.

STEP 3:

And pull the tube out from the chamber.