Bluetooth Wooden Retro Radio

User’s Guide for Model No. RETRO-100

Important Safety Instructions

• Read these Instructions.

• Keep these Instructions.

• Heed all Warnings.

• Follow all instructions.

• Do not use this apparatus near water.

• Clean only with a dry cloth.

• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus

(including that produce heat.

• Do not defeat the safety purpose of the polarized or grounding - type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. wide blade or the third prong are provided for your safety. When the provided plug does not into your outlet, consult an electrician for replacement of the obsolete outlet.

• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

• Only use attachments/accessories by the manufacturer.

• Unplug this apparatus during lightning storms or when unused for long periods of time.

• Refer all servicing to service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

• Use only with a cart, stand, tripod, bracket, or table by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over.

• WARNING: To reduce the risk of or electric shock, do not expose this apparatus to rain, moisture, dripping, or splashing.

• CAUTION: Use of controls or adjustments or performance of procedures other than those may result in hazardous radiation exposure.

• WARNING: Changes or to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

• WARNING: Do not place this unit directly onto furniture surfaces with any type of sensitive porous, or

As with any rubber compound made with oils, the feet could cause marks or staining where the feet reside.  We recommend using a protective barrier such as a cloth or a piece of glass between the unit and the surface to reduce the risk of damage and/or staining.

• WARNING: Use of this unit near lighting may cause interference regarding use of the remote. If the unit is displaying erratic behavior move away from any lighting, as it may be the cause.

• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

• WARNING: is a danger of explosion if you attempt to charge standard Alkaline batteries in the unit. Only use rechargeable NiMH batteries.

• WARNING: Lithium batteries, like all rechargeable batteries, are recyclable and should be recycled or disposed of in normal household waste. Contact your local government for disposal or recycling practices in your area. should never be incinerated since they might explode.

• WARNING: Shock hazard - Do Not Open.

FCC Warnings

Warning: Changes or to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. limits are designed to provide reasonable protection against harmful interference in a residential installation. equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit connected.

from that to which the receiver is

• Consult the dealer or an experienced radio/TV technician for help.

Additional Warnings and Precautions

• CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE

SLOT, FULLY INSERT.

• Caution and marking information is located at the rear or bottom of the apparatus.

• Objects with liquids, such as vases, shall not be placed on the apparatus.

• Mains plug is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected form the mains socket outlet completely.

• Battery shall not be exposed to excessive heat such as sunshine, or the like.

• Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children.

• If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

• Do not mix old and new batteries.

• Completely replace all old batteries with new ones.

• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.

• Batteries should be recycled or disposed of as per state and local guidelines.

CAUTION WARNING: To reduce the risk of electric shock, do not remove cover

(or back). No user-serviceable parts inside. Refer servicing to service personnel.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

The lightning with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of constitute a risk of electric shock to persons.

magnitude to

This symbol indicates that this product incorporates double insulation between hazardous mains voltage and user accessible parts.

FEATURES AND CONTROLS

FEATURES

• 3.5mm audio input

• Analog volume control

• USB port for mobile phone charging

• LED pairing indicator

• Built-in AM/FM wire antenna

• Bluetooth Wireless range: 33 feet

• AC power input: requires an AC power cable (included)

Tuning

Turn to adjust the AM or

FM radio station.

Source/Pair

Adjust the switch to one of the sources to turn the unit on. In Bluetooth mode, press to begin pairing.

Volume

Turn to adjust the volume.

Pairing Indicator

M

IN

VO

SOURCE/PAIR

OFF

FM

AM

/LINE IN

FM 88 91 94 98 102 106 108 MHz

AM 530 700 900 1100 1300 1500 1700 KHz

G

3.5mm Audio Line Input

USB Charging Port

AC Power Input

AC IN~

USB CHARGER LINE IN

RETRO-100 1 11/19/2014 11:35:44 AM

POWER & CHARGING

Plug the AC/DC power adapter (included) into the AC Power Input on the unit, and a standard power outlet. The unit can be used to charge mobile devices through a

USB Charging Port in the rear, as seen below (additional USB cable not included).

Power to unit

USB CHARGER LINE IN

AC IN~

Power to device

BLUETOOTH

Pairing a Bluetooth Device for the First Time

1. Adjust the Source/Pair knob to the Bluetooth/Line in setting. of the unit.

2. Press the Source/Pair knob.

3. Using the native controls on your Bluetooth device, select the ISB313CW in your Bluetooth settings to pair. If your device requests a password, enter the

RADIO

Radio Reception

An AM and FM antenna is built into the radio. To improve radio reception, adjust the position of the unit.

Playing the Radio

1. Adjust the Source/Pair knob to AM or FM radio mode.

2. Adjust the Tuning dial to tune the radio.

LINE IN

Using the Audio Input and connecting Bluetooth devices. After initial pairing, the unit will stay paired unless unpaired manually by the user or erased due to a reset of the device.

4. When successfully paired and connected, the pairing indicator will display a solid blue light.

5. If your device should become unpaired or you it is unable to connect, repeat the above steps.

Playing Audio Wirelessly

1. To play or pause a selected track, use the native controls on the connected

Bluetooth Device.

2. Audio played through the connected Bluetooth device will now be heard through the speaker.

1. Connect a 3.5mm audio cable to the Line In Input on the unit and the

audio output on an audio device.

2. Adjust the Source/Pair knob to the Bluetooth/Line in setting. Use the native controls on the connected device to play your audio through the unit.

AC IN~

USB CHARGER LINE IN

RETRO-100 2 11/19/2014 11:35:45 AM