HDMI to 3G-SDI Video Converter, HDMS-200 User`s Manual - AV-iQ

CONTENTS
HDMI to 3G-SDI Video Converter,
HDMS-200
Contents
1-1
Specification / Supporting resolution
1-2
Installation
1-3
Warranty Information
1-4
Troubleshooting
1-5
User’s Manual
1-1 Contents
Specification
Installation
ITEM
DESCRIPTION
Input Signal
HDMI
Output Signal
SDI
VIDEO
Input format
RGB(444), YCbCr (444), YCbCr (422)
VIDEO
Output format
YCbCr (422)
Input format
AUDIO
AES/EBU / 48Khz
Power
7~25V DC
Power Consumption
7W
Dimension
105 x 95 x 25 (mm)
STEP1
Plug the AC/DC adapter to AC inlet and connect to receptacle on the
product.
STEP2
Connect HDMI source to HDMI input port of HDMS-200 with HDMI cable.
STEP3
Connect SDI display to SDI output port of HDMS-200 with SDI coaxial cable.
Note.1
HDMS-200 has two (2) SDI outputs.
Note.2
HDMS-200 does not have scaling up/down feature. It just converts
HDMI to SDI format with same resolution and refresh ratio.
Supporting resolution
SMPTE
Video Formats
SMPTE-425M
3G : 1920*1080p(60/59.94/50)
SMPTE-274M
HD : 1920*1080i (60/59.94/50)
SMPTE-274M
HD : 1920*1080p (30/29.97/25/24/23.98)
SMPTE-296M
HD : 1280*720p (60/59.94/50)
SMPTE-125M
SD : 601*525i (486_ NTSC)
SMPTE-125M
SD : 601*625i (576_PAL)
1-2 Specification / Supporting Resolution
1-3 Installation
Warranty Information
1 (One) Year Warranty
OPTICIS warrants OPTICIS HDMS-200 HDMI to 3G-SDI converter to be free
from defects in workmanship and materials, under normal use and service, for
a period of one (1) year from the date of purchase from OPTICIS or its
authorized resellers.
Troubleshooting
Problem
Converter does not
Operate
If a product does not work as warranted during the applicable warranty
period, OPTICIS shall, at its option and expense, repair the defective product
or part, deliver to customer an equivalent product or part to replace the
defective item, or refund to customer the purchase price paid for the defective
product.
All products that are replaced will become the property of OPTICIS.
Replacement products may be new or reconditioned.
Any replaced or repaired product or part has a ninety (90) day warranty or the
reminder of the initial warranty period, whichever is longer.
No picture (or signal)
Or Poor picture
OPTICIS shall not be responsible for any software, firmware, information, or
memory data of customer contained in, stored on, or integrated with any
products returned to OPTICIS for repair under warranty or not.
Warranty Limitation and Exclusion
OPTICIS shall have no further obligation under the foregoing limited warranty
if the product has been damaged due to abuse, misuse, neglect, accident,
unusual physical or electrical stress, unauthorized modifications, tampering,
alterations, or service other than by OPTICIS or its authorized agents, causes
other than from ordinary use or failure to properly use the Product in the
application for which said Product is intended.
Make sure the 12V power supply is plugged
firmly to DC receptacle and AC inlet.
Check if the white LED light is on.
1. If you are using copper based HDMI cable,
overall length should not exceed 20ft.
Longer than this will result in no or poor
picture quality. To extend beyond 20ft,
please use fiber optical HDMI extension
cables.
2. Make sure all HDMI, SDI connectors are
tightly secured to all HDMI, SDI ports.
Loose plugging on the connectors will
result in no or poor picture.
3. Reboot the converter.
Incorrectly sized picture /
resolution or No picture
1-5 Troubleshooting
1-4 Warranty Information
Remedy Actions
Reset SDIH-200 by pressing the reset button.
© 2011 Opticis Co., Ltd. All Rights Reserved
Revision 1a
Opticis Locations
Headquarter
Opticis Co., Ltd.
# 304, ByusanTechnopia, 434-6
Sangdaewon-Dong, Chungwon-Ku,
Sungnam City, Kyungki-Do, 463-120
South Korea
Tel: +82 (31) 737-8033~9
Fax: +82 (31) 707-8079
www.opticis.com
For order support, please contact your Distributor or Reseller.
For technical support, check with the with the Opticis web site www.opticis.com or
contact techsupport@opticis.com
Download PDF