3 - Asus

Federal Communications Commission Statement
This device complies with FCC Rules Part 15. Operation is subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to
Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING! The use of a shielded-type power cord is required in order to meet FCC
emission limits and to prevent interference to the nearby radio and television reception.
It is essential that only the supplied power cord be used. Use only shielded cables to
connect I/O devices to this equipment. You are cautioned that changes or modifications
not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.
Reprinted from the Code of Federal Regulations #47, part 15.193, 1993. Washington DC: Office of the
Federal Register, National Archives and Records Administration, U.S. Government Printing Office.
Power Safety Requirement
Products with electrical current ratings up to 6A and weighing more than 3Kg must use approved power
cords greater than or equal to: H05VV-F, 3G, 0.75mm2 or H05VV-F, 2G, 0.75mm2.
Canadian Department of Communications Statement
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus
set out in the Radio Interference Regulations of the Canadian Department of Communications.
This Class B digital apparatus complies with Canadian ICES-003.
(Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.)
For use with AC Adaptor Model (Pour Utiliser Avec Modele): PA-1121-02 (120W), ADP-90FB (90W), ADP-65DB (65W)
2
Nordic Cautions (for Notebook PC with Lithium-Ion Battery)
CAUTION! Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturer’s instructions. (English)
ATTENZIONE! Rischio di esplosione della batteria se sostituita in modo errato. Sostituire la batteria con un
una di tipo uguale o equivalente consigliata dalla fabbrica. Non disperdere le batterie nell’ambiente. (Italian)
VORSICHT! Explosionsgetahr bei unsachgemäßen Austausch der Batterie. Ersatz nur durch denselben
oder einem vom Hersteller empfohlenem ähnlichen Typ. Entsorgung gebrauchter Batterien nach Angaben
des Herstellers. (German)
ADVARSELI! Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med
batteri af samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren. (Danish)
VARNING! Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ
som rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion. (Swedish)
VAROITUS! Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan laitevalmistajan
sousittelemaan tyyppiin. Hävitä käytetty paristo valmistagan ohjeiden mukaisesti. (Finnish)
ATTENTION! Il y a danger d’explosion s’il y a remplacement incorrect de la batterie. Remplacer
uniquement avec une batterie du mêre type ou d’un type équivalent recommandé par le constructeur.
Mettre au rebut les batteries usagées conformément aux instructions du fabricant. (French)
ADVARSEL! Eksplosjonsfare ved feilaktig skifte av batteri. Benytt samme batteritype eller en tilsvarende type
anbefalt av apparatfabrikanten. Brukte batterier kasseres i henhold til fabrikantens instruksjoner. (Norwegian)
(Japanese)
Macrovision Corporation Product Notice
This product incorporates copyright protection technology that is protected by method claims of certain
U.S.A. patents and other intellectual property rights owned by Macrovision Corporation and other
rights owners. Use of this copyright protection technology must be authorized by Macrovision
Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized
by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
CDRH Regulations
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration
implemented regulations for laser products on August 2, 1976. These regulations apply to laser products
manufactured from August 1, 1976. Compliance is mandatory for products marketed in the United
States.
WARNING: Use of controls or adjustments or performance of procedures other than
those specified herein or in the laser product installation guide may result in hazardous
radiation exposure.
3
°C
0°C/32°F
4
°C
30°C/86°F
5
CTR 21 Approval (for Notebook PC with built-in Modem)
Danish
Dutch
English
French
German
Italian
Portuguese
Spanish
Japanese Notic
Japanese Modem
Notice
6
UL Safety Notices
Required for UL 1459 covering telecommunications (telephone) equipment intended to be electrically
connected to a telecommunication network that has an operating voltage to ground that does not exceed
200V peak, 300V peak-to-peak, and 105V rms, and installed or used in accordance with the National
Electrical Code (NFPA 70).
When using the Notebook PC modem, basic safety precautions should always be followed to reduce
the risk of fire, electric shock, and injury to persons, including the following:
•
Do not use the Notebook PC near water, for example, near a bath tub, wash bowl, kitchen sink
or laundry tub, in a wet basement or near a swimming pool.
•
Do not use the Notebook PC during an electrical storm. There may be a remote risk of electric
shock from lightning.
•
Do not use the Notebook PC in the vicinity of a gas leak.
Required for UL 1642 covering primary (nonrechargeable) and secondary (rechargeable) lithium batteries
for use as power sources in products. These batteries contain metallic lithium, or a lithium alloy, or a
lithium ion, and may consist of a single electrochemical cell or two or more cells connected in series,
parallel, or both, that convert chemical energy into electrical energy by an irreversible or reversible
chemical reaction.
•
•
Do not dispose the Notebook PC battery pack in a fire, as they may explode. Check with local
codes for possible special disposal instructions to reduce the risk of injury to persons due to
fire or explosion.
Do not use power adapters or batteries from other devices to reduce the risk of injury to
persons due to fire or explosion. Use only UL certified power adapters or batteries supplied by
the manufacturer or authorized retailers.
Notebook PC Optical Drive
Laser Safety Information
Internal or external optical drives sold with this Notebook PC contains a CLASS 1 LASER PRODUCT
(LASER KLASSE 1 PRODUKT). Laser classifications can be found in the glossary at the end of this
user’s manual.
WARNING: Making adjustments or performing procedures other than those specified
in the user’s manual may result in hazardous laser exposure. Do not attempt to
disassemble the optical drive. For your safety, have the optical drive serviced only by
an authorized service provider.
Service warning label
CAUTION: INVISIBLE LASER RADIATION WHEN OPEN. DO NOT STARE INTO BEAM
OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS.
7
™
8
9
10
11
1
User’
s Man
12
ual
1
3
2
1
13
1
14
15
2
16
2
™
™
17
2
18
2
19
2
®
®
®
20
®
2
2.0
21
2
22
23
3
24
3
˚
˚
25
3
3
1
2
26
3
27
3
28
3
29
3
30
3
31
3
™
™
™
™
™
™
32
3
33
3
34
3
35
3
36
3
37
3
38
39
4
40
4
41
4
42
4
43
4
1
2
3
4
44
5
4
3
1
2
4
5
45
4
3
2
1
™
™
46
4
MS adapter
MS (Memory Stick)
Duo/Pro/Duo Pro/MG
MS (Memory Stick)
Magic Gate (MG)
MS (Memory Stick)
Select
MS (Memory Stick)
MMC (Multimedia Card)
SD (Secure Digital)
SD/MMC
MS/MS Pro (Memory Stick)
47
4
48
4
49
4
50
4
51
4
52
4
53
4
54
4
(
(
(
)
)
--
)
--
55
4
56
57
A
58
A
802
.11g
54M
bps
59
A
60
A
61
A
®
®
62
A
63
A
The Portable Desktop PC with internal modem model complies with JATE (Japan), FCC (US,
Canada, Korea, Taiwan), and CTR21. The internal modem has been approved in accordance with
Council Decision 98/482/EC for pan-European single terminal connection to the public switched
telephone network (PSTN). However due to differences between the individual PSTNs provided in
different countries, the approval does not, of itself, give an unconditional assurance of successful
operation on every PSTN network termination point. In the event of problems you should contact
your equipment supplier in the first instance.
Overview
On 4th August 1998 the European Council Decision regarding the CTR 21 has been published in the
Official Journal of the EC. The CTR 21 applies to all non voice terminal equipment with DTMFdialling which is intended to be connected to the analogue PSTN (Public Switched Telephone
Network).
CTR 21 (Common Technical Regulation) for the attachment requirements for connection to the
analogue public switched telephone networks of terminal equipment (excluding terminal equipment
supporting the voice telephony justified case service) in which network addressing, if provided, is by
means of dual tone multifrequency signalling.
Network Compatibility Declaration
Statement to be made by the manufacturer to the Notified Body and the vendor: "This declaration
will indicate the networks with which the equipment is designed to work and any notified networks
with which the equipment may have inter-working difficulties"
Network Compatibility Declaration
Statement to be made by the manufacturer to the user: "This declaration will indicate the networks
with which the equipment is designed to work and any notified networks with which the equipment
may have inter-working difficulties. The manufacturer shall also associate a statement to make it
clear where network compatibility is dependent on physical and software switch settings. It will also
advise the user to contact the vendor if it is desired to use the equipment on another network."
Up to now the Notified Body of CETECOM issued several pan-European approvals using CTR 21.
The results are Europe's first modems which do not require regulatory approvals in each individual
European country.
Non-Voice Equipment
Answering machines and loud-speaking telephones can be eligible as well as modems, fax machines,
auto-dialers and alarm systems. Equipment in which the end-to-end quality of speech is controlled by
regulations (e.g. handset telephones and in some countries also cordless telephones) is excluded.
64
A
Country
Austria1
Belgium
Czech Republic
Denmark1
Finland
France
Germany
Greece
Hungary
Iceland
Ireland
Italy
Israel
Lichtenstein
Luxemburg
The Netherlands1
Norway
Poland
Portugal
Spain
Sweden
Switzerland
United Kingdom
Applied
More Testing
Yes
Yes
No
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
Pending
No
Yes
Yes
Yes
Yes
No
No
No
Yes
Yes
Yes
No
No
not applicable
Yes
No
No
No
No
not applicable
No
No
Pending
No
No
No
Yes
No
not applicable
not applicable
not applicable
No
No
No
This information was copied from CETECOM and is supplied without liability. For updates to this
table, you may visit http://www.cetecom.de/technologies/ctr_21.html
1
National requirements will apply only if the equipment may use pulse dialling (manufacturers may
state in the user guide that the equipment is only intended to support DTMF signalling, which would
make any additional testing superfluous).
In The Netherlands additional testing is required for series connection and caller ID facilities.
65
A
ACPI (Advanced Configuration and Power Management Interface)
APM (Advanced Power Management)
AWG (American Wire Gauge)
66
A
BIOS (Basic Input/Output System)
Bit (Binary Digit)
Boot
Bus Master IDE
Byte (Binary Term)
Clock Throttling
COM Port
CPU (Central Processing Unit)
Device Driver
Hardware
67
A
DVD (Digital Versatile Disc)
®
IDE (Integrated Drive Electronics)
IEEE1394
Infrared Port (IrDA)
Kensington® Locks
®
68
A
Laser Classifications
LPT Port (Line Printer Port)
PCI Bus (Peripheral Component Interconnect Local Bus)
PC Cards (PCMCIA)
69
A
POST (Power On Self Test)
RAM (Random Access Memory)
ROM (Read Only Memory)
Suspend Mode
System Disk
Twisted-Pair Cable
UltraDMA/66 or 100
USB (Universal Serial Bus)
70
A
71
A
72
Download PDF