SPEAKMAN COMPANY
SE-855 Installation, Maintenance & Operation Instructions
Emergency Shower Head
DESCRIPTION
Replacement emergency shower head for SE-700 and SE-701.
SPECIFICATIONS
SHANK: 5” Dia. Brass, Chrome-Plated.
SPRAYFACE: Chrome-Plated Brass.
INLET: 1/2” NPT Female.
SHIPPING WEIGHT: 2 lb.
INSTALLATION
When assembling use wrench on hex (flats) only. Be sure and use pipe sealant on threaded connection Failure to use potable water can result in emergency units producing impure or contaminated water causing possible further injury.
TESTING PROGRAM
The American National Standards Institute (ANSI) states that all safety emergency equipment shall be activated on a weekly basis to flush the line and verify proper operation. Speakman Company furnishes a testing record tag
(91-0635) with each unit. On this tag the date of inspection and the inspectors initials should be noted.
MAINTENANCE
Should you need parts to repair this unit, please reference the parts listing below for correct part numbers. Before any maintenance is done be sure the water supply is off.
WARNING: Use only genuine Speakman parts when repairing or replacing components .
To order parts call 1-800-537-2107.
SE-855 REPLACEMENT/REPAIR PARTS
ITEM PART/GROUP # DESCRIPTION
1 G38-0378-PC-P Assy., Chrome-
Plated
If a ¾” NPT inlet connection is needed, order these additional parts
05-2116-PC Reducer
31-0030-RCP-PUR Nipple
NOTE: This unit should be connected to an uninterrupted source of potable water, with a minimum flowing pressure of 20 PSI and a maximum static pressure of 125 PSI.
Note: Product improvements may cause specification and dimensional changes without notice.
2/02
92-1520 Rev-3
