High Load Rechargeable Li-ion Battery Pack
Tel: +86-25-85805753
Fax: +86-25-85805296
http://www.swit.cc
E-mail: contact@swit.cc
3. The internal impedance of battery pack will be greater at low
temperature, which may cause the automatically circuit cutting.
4. According to the using conditions, please set the camera low
battery warning voltage at 13-14V, cut off voltage at 12-13V.
Characteristics
1. High power output Li-ion battery pack, rechargeable.
2. 4-step LED power indicator.
3. D-tap DC output and charging socket.
4. Build-in multiple protective circuit design.
LED indicator
1. The four-step LEDs indicate the remaining capacity when
press the “CHECK” button.
2. The indicator may not be accurate when the battery is
powering on the camera.
3. When only one LED indicates, please charge the battery as
soon as possible.
Caution
1. Never attempt to open the battery pack.
2. Use SWIT charger or the chargers recommended by SWIT.
3. Please make sure the battery mount on camera could endure
high current, otherwise it might damage the mount or battery.
4. Keep the battery pack terminals clean.
5. Never short-circuit the battery pack terminals.
6. Never expose the battery pack to rain, fire or moisture.
7. Never expose the battery pack to temperature above 60 .
8. Avoid strong mechanical shock.
9. The battery pack may become warm in use or while being
charged. This is normal.
DC socket
℃
The D-tap DC socket can be used as 14.4V DC output or SWIT
S-3010B charging input.
1. Open the rubber cover and plug in D-tap lead to DC output or
charge.
2. Close the rubber cover when disconnected, to keep the socket
away from dust.
Charging
1. The battery pack is not fully charged when it is purchased.
Charge the battery before use.
2. Use SWIT charger or the chargers recommended by SWIT.
3. The battery pack should be charged within a temperature
range of 0-40
Self-protection and Re-activate
The battery pack has multiple protective circuits and will cut off
power automatically when overload or any abnormal detected.
Mount the battery pack to any SWIT charger, it will be reactivated and get charging normally.
℃
Discharging
Storage
1. Fully charged battery pack will discharge naturally and please
use it as soon as it gets charged.
2. At low temperature, the running time of battery pack usually
decreases.
Please keep in cool, dry and clean place.
Specifications
Nominal
Model
Mount Type
S-8210A
Gold Mount
14.4V
115Wh
8Ah
150W
S-8210S
V-mount
14.4V
115Wh
8Ah
S-8260A
Gold Mount
14.4V
172Wh
S-8260S
V-mount
14.4V
172Wh
voltage
Capacity
Max output
Dimension
Mass
12A
165×90×53mm
900g
150W
12A
165×90×51mm
900g
12Ah
180W
15A
165×90×68mm
1300g
12Ah
180W
15A
165×90×66mm
1300g
12-05
Download PDF