6ZXC
USER'S MANUAL
1.
System power on by PS/2 Mouse: First, enable this function
in CMOS Setup, then you can power on the system by
double clicking the right or left button of your PS/2 Mouse.
2.
System power on by Keyboard: If your ATX power supply
supports larger than 300 mA 5V Stand-By current
(dependent on the specification of keyboards), you can
power on your system by entering password from the
keyboard after setting the “Keyboard power on” password in
CMOS Setup.
3.
Supports 3 steps ACPI LED.
4.
Modem Ring-On. (COM A , B).
5.
Wake-Up on LAN. (The ATX power supply supports larger
than 720 mA 5V Stand-By current)
*
JP12 & JP13 Jumper (PCB Ver:2.0 and after use), please
reference page 17.
For Intel Pentium II / III/ CeleronTM Processor MAINBOARD
REV. 2.0 First Edition
R-20-01-090528
6ZXC
The author assumes no responsibility for any errors or omissions which may
appear in this document nor does it make a commitment to update the
information contained herein.
Third-party brands and names are the property of their respective
owners.
Sound Blaster is a registered trademark of Creative Technology Ltd in the
United States and certain other countries. Sound Blaster-LINK and SB-LINK
are trademarks of Creative Technology Ltd.
May 28, 1999 Taipei, Taiwan
1
Quick Installation Guide
I. Quick Installation Guide :
CPU SPEED SETUP
The system bus speed is selectable between 66 / 100 MHz. The user can
select the system bus speed (SW1) and change the DIP SWITCH (SW2)
selection to set up the CPU speed for 333 - 650MHz processor.
Set System Bus Speed
SW1:
CPU
AGP
100 MHz
133 MHz
112 MHz
66 MHz
75 MHz
83 MHz
66 MHz
89 MHz
75 MHz
66 MHz
75 MHz
83 MHz
1
X
X
X
O
O
O
2
X
X
O
X
O
X
3
X
O
X
X
X
O
4
X
X
X
O
O
O
The CPU speed MUST match with the frequency RATIO. It will cause
system hanging up if the frequency RATIO is higher than that of CPU.
SW2:
FREQ. RATIO
X3
X 3.5
X4
X 4.5
X5
X 5.5
X6
X 6.5
X7
X 7.5
X8
X 8.5
X9
X 9.5
1
O
X
O
X
O
X
O
X
O
X
O
X
O
X
DIP SWITCH (SW)
2
3
X
O
X
O
O
X
O
X
X
X
X
X
O
O
O
O
X
O
X
O
O
X
O
X
X
X
X
X
2
4
O
O
O
O
O
O
X
X
X
X
X
X
X
X
6ZXC
«Note: We don’ t recommend you to setup your system speed to 75, 83,
112 or 133MHz because these frequencies are not the standard
specifications for CPU, Chipset and most of the peripherals.
Whether your system can run under 75, 83, 112 or 133MHz
properly will depend on your hardware configurations: CPU,
SDRAM, Cards, etc.
+ The black part in the picture is the white extruding piece of the
DIP switch.
1. Pentium II /Celeron 333 / 66 MHz FSB
6ZXC
CPU
Intel
440ZX
4 3 2 1
OFF
SW 1
ON
PIIX4
4 3 2 1
SW 2
OFF
ON
2. Pentium II /Celeron 366 / 66 MHz FSB
4 3 2 1
4 3 2 1
OFF
SW1
OFF
SW2
ON
ON
3. Pentium II /Celeron 400 / 66MHz FSB
4 3 2 1
4 3 2 1
OFF
SW1
ON
OFF
SW2
ON
4. Pentium II /Celeron 433 / 66MHz FSB
4 3 2 1
SW1
OFF
ON
4 3 2 1
SW2
3
OFF
ON
Quick Installation Guide
5. Pentium II 400 / 100 MHz FSB
4 3 2 1
4 3 2 1
OFF
SW1
OFF
SW2
ON
ON
6. Pentium II / III 450 / 100 MHz FSB
4 3 2 1
4 3 2 1
OFF
SW1
OFF
SW2
ON
ON
7. Pentium II / III 500 / 100 MHz FSB
4 3 2 1
4 3 2 1
OFF
SW1
ON
OFF
SW2
ON
8. Pentium II / III 550 / 100 MHz FSB
4 3 2 1
4 3 2 1
OFF
SW1
OFF
SW2
ON
ON
9. Pentium II / III 600 / 100 MHz FSB
4 3 2 1
4 3 2 1
OFF
SW1
ON
OFF
SW2
ON
10. Pentium II / III 650 / 100 MHz FSB
4 3 2 1
SW1
4 3 2 1
OFF
ON
OFF
SW2
ON
4
6ZXC
II. Jumper setting :
SPK : Speaker Connector
6ZXC
CPU
Intel
440ZX
1 PIIX4
+
Pin No. Function
1
VCC
2
NC
3
NC
4
Data
+ 1
RST : Reset Switch
6ZXC
CPU
Intel
440ZX
PIIX4
Pin No
Function
Open Normal
Operation
Close For Hardware
Reset System
5
Quick Installation Guide
PW LED : Power LED Connector
6ZXC
CPU
Intel
440ZX
1
PIIX4
Pin No.
Function
1
LED anode(+)
2
LED cathode(-)
3
LED cathode(-)
1
HD : IDE Hard Disk Active LED
6ZXC
CPU
Intel
440ZX
1
PIIX4
Pin No.
1
2
3
4
1
6
Function
LED anode(+)
LED cathode(-)
LED cathode(-)
LED anode(+)
6ZXC
IR : Infrared Connector (Optional)
6ZXC
CPU
Intel
440ZX
PIIX4
1
Pin No.
1
2
3
4
5
Function
IR Data output
GND
IR Data input
NC
POWER(+)
GN : Green Function Switch
6ZXC
CPU
Intel
440ZX
PIIX4
Pin No.
Function
Open Normal
Operation
Close Entering
Green Mode.
7
Quick Installation Guide
GD : Green LED
6ZXC
CPU
Intel
440ZX
1
1
PIIX4
Pin No. Function
1
LED(+)
2
LED(−)
Soft POWER : Soft Power Connector
6ZXC
CPU
Intel
440ZX
1
1
PIIX4
Pin No.
Open
Close
8
Function
Normal Operation
Power On/Off
6ZXC
POWER1 : Power Connector
Pin No.
3,5,7,13,15
-17
1,2,11
4,6,19,20
10
12
18
8
9
14
6ZXC
1
11
Function
GND
CPU
3.3V
VCC
+12V
Intel
-12V
440ZX
-5V
Power Good
5V SB stand by+5V
PS-ON(Soft On/Off)
PIIX4
PS/2 Mouse / Keyboard Connector
CPU
6ZXC
PS/2 Mouse
PIIX4
PS/2 Keyboard
PS/2 Mouse/ Keyboard
Pin No.
Function
Intel
440ZX
1
Data
2
NC
3
GND
4
VCC(+5V)
5
Clock
6
NC
9
Quick Installation Guide
CPU FAN : CPU Cooling Fan Power Connector
6ZXC
1
PIN No.
1
2
3
Function
CPU
GND
+12V
Intel
SENSE
440ZX
PIIX4
Power FAN : Power Fan Power Connector
6ZXC
CPU
1
PIIX4
PIN No.
1
2
3
Function
GND
+12V
SENSE
10
Intel
440ZX
6ZXC
System FAN : System Fan Power Connector
6ZXC
CPU
1
PIN No.
1Intel
440ZX
2
3
PIIX4
IDE1: For Primary IDE port
6ZXC
CPU
Intel
440ZX
PIIX4
1
11
Function
GND
+12V
SENSE
Quick Installation Guide
IDE2: For Secondary IDE port
6ZXC
CPU
Intel
440ZX
PIIX4
1
FLOPPY : FLOPPY PORT
6ZXC
CPU
Intel
440ZX
PIIX4
1
12
6ZXC
LPT PORT / COM A / COM B
6ZXC
CPU
LPT PORT
Intel
440ZX
COM B
COM A
PIIX4
JP1 : Keyboard Power On Selection
6ZXC
CPU
1
2
3
PIIX4
PIN No.
1-2
close
2-3
close
Function
Intel
440ZX
Keyboard Power
on
Enabled
Keyboard Power on
Disabled (Default)
13
Quick Installation Guide
USB : USB Port
6ZXC
PIN No.
1
2
3
4
5
6
7
8
PIIX4
Function
USB V0
USB D0USB D0+
GND
USB V1
USB D1USB D1+
GND
CPU
Intel
440ZX
J15: System After AC Back
1
6ZXC
Pin No. Function
1
Signal
2
GND
Open: Soft Off
Close: Full On
PIIX4
14
CPU
Intel
440ZX
6ZXC
JP7: Wake On LAN
CPU
6ZXC
JP7
1
Intel
440ZX
PIIX4
2
3
PIN No.
1
2
3
Function
+5V
GND
Signal
JP8:SB-LINK Creative PCI Sound Card Support
6ZXC
CPU
JP8
PIIX4
1
PIN No.
1
2
3
4
5
6
15
Intel
Function
440ZX
Signal
GND
NC
Signal
GND
Signal
Quick Installation Guide
JP10 : System Acceleration
6ZXC
CPU
Intel
440ZX
1
Pin PIIX4Function
1-2 Turbo (for 100MHz Turbo and
close other frequencies)
2-3 100MHz Normal(Default)
close
JP11:CLEAR CMOS FUNCTION
6ZXC
CPU
Intel
440ZX
1
PIIX4
2
3
PIN No.
Function
1-2 close Clear CMOS
2-3 close Normal (Default)
16
6ZXC
Internal Ring Power On FUNCTION
6ZXC
CPU
Intel
440ZX
PIIX4
1
PIN No.
1
2
Function
+5V SB
GND
JP12 / JP13 (PCB 2.0 and after version use)
CPU
6ZXC
JP13
Intel
440ZX
JP12
Open
Short
PIN No. Function
Open
Normal (Default)
Short
Close for Voodoo III
VGA Card
PIIX4
17
Quick Installation Guide
BAT1 :BATTERY
6ZXC
MDanger of explosion if battery is
incorrectly replaced.
CPU
MReplace only with
the same or
equivalent type recommended by the
manufacturer. Intel
MDispose of used440ZX
batteries according
to the manufacturer’s instructions.
+
PIIX4
BAT1
III. Top Performance Test Setting:
The following performance data list is the testing results of some popular
benchmark testing programs.
Users have to modify the value for each item in chipset features as follow
for top performance setting.
18
6ZXC
These data are just referred by users, and there is no responsibility for
different testing data values gotten by users. (Different Hardware & Software
configuration will result in different benchmark testing results.)
• CPU
Pentium III / Celeron Processor
• DRAM
128 MB SDRAM (TOSHIBA TC59S6408BFT-80)
• CACHE SIZE
512 KB included in CPU
• DISPLAY
GA-630 Voodoo banshee (16MB SGRAM)
• STORAGE
Onboard IDE (Seagate ST34520A)
• O.S.
Windows NT ™4.0 SPK4
• DRIVER
Display Driver at 1024 x 768 x 64K colors x 75Hz.
TRIONES Bus Master IDE Driver 3.60
Processor
Celeron
PentiumIII
366MHz( 66x5.5 )
550MHz(100x5.5)
Winbench99
CPU mark32
FPU Winmark
Business Disk
Hi-End Disk
Business Graphics
Hi-End Graphics
731
1970
1380
2800
4180
4590
10200
177
10600
248
335
440
27.1
24.4
34.7
32.9
Winstone99
Business
Hi-End
19
Download PDF