- No category
advertisement
User Manual
Ethernet Extender
Over Coaxial Cable
EOC-100PK
EOC-100-SV
Host/Server Side
EOC-100-IPC
Camera Side
This Ethernet extender units EOC-100-SV (host/server side) and EOC-100-IPC (camera side) can be used as a kit or one-to-many. It uses coaxial cable or another type of cable to extend transmission of the Ethernet signal. It can meet the single mode, link mode and star mode. This product is suitable for long distance transmission Ethernet signal or when the situation needs link mode network, such as network video surveillance, network engineer, etc.
.. Features
• Use coaxial cable to transmit Ethernet signal
• Maximum distance up to 2000m / 6500ft
• Network delay less than 1ms
• Optional transmission medium, coaxial cable, power line, telephone cable or UTP cable
• Meet single mode, link mode and star mode network at the same time
• Loop circuit mode; if there is one breakdown in the circuit, the system can still work normally
• Meet Standard: IEEE802.3 10BASE-T, IEEE802.3u 100BASE-TX
• Appearance and structure Solid and delicate, meet MIT rack installation standard
• Protection: Excellent circuit isolation protection, effectively improve product's lightning protection, ESD and anti-interference ability
• 12V DC
Please read the Manual before attempting to use this product.
Specifications and appearance are subject to change without notice.
Copyright © 2014-2015 AAS Technology www.AAS.com.tw
N-5
R201502-V24
Disposal of Old Electrical & Electronic Equipment (Applicable in the European
Union and other European countries with separate collection systems).
This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
Caution ..
This product has been tested for conformance to safety regulations and requirements. However, like all electronic equipment, this product should be used with care. Please read and follow the safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit.
1. Handle this product with care
Avoid any shock or bumping of the product. Improper handling could damage the product. Do not handle the unit with wet hands. Provide proper ventilation and air circulation and do not use near water.
2. Requires a proper operating environment
This product is not waterproof and is designed for indoor use. The allowable temperature range for operation of this product is between 32°F ~ 131°F / 0°C ~ 55°C.
3. Check the power source voltage
The power source voltage should be within the specified range. (Product must meet the specifications).
4. Objects and liquid entry
Never push objects of any kind into this product as this may touch dangerous voltage points of short out parts that could result in a fire or electric shock. Never spill any kind of liquid on the product.
5. Cleaning
Do not use liquid or aerosol cleaners to clean this unit. Always unplug the power to the device before cleaning.
6. Servicing
Do not attempt to service this product by yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all service to qualified servicing personnel.
2
Package Contents
• One (1) EOC-100-SV unit (host/camera side)
• One (1) Power Adaptor
• Two (2) Ear Mount Brackets
• Two (2) BNC Connectors
• One (1) User Manual
..
• One (1) EOC-100-IPC unit (camera side)
• One (1) Power Adaptor
• Two (2) Ear Mount Brackets
• Two (2) BNC Connectors
• One (1) User Manual
For any returns, please include all components listed above with original packaging in Resalable
Condition. Absolutely No Returns will be accepted if any component is missing/damaged.
Parts & Functions
EOC-100-SV (Host/Server Side) and EOC-100-IPC (Camera Side)
..
3
Application Diagram
Application 1: Point-to-Point
..
Distance
100m / 300ft
200m / 650ft
500m / 1600ft
700m / 2200ft
Upload (Mbps)
99.2
99.2
99.0
99.0
1000m / 3000ft
1200m / 3500ft
1500m / 4900ft
2000m / 6500ft
74.5
70.0
40.2
44.4
Application 2: Point-to-Serial Chain
Coaxial
Download (Mbps)
99.2
99.2
99.0
99.0
82.3
71.1
46.5
28.8
Video
Clear, Smooth
Clear, Smooth
Clear, Smooth
Clear, Smooth
Clear, Smooth
Clear, Smooth
Clear, Smooth
Not Smooth, Interference
Device
1
2
3
4
5
Distance
400m / 1200ft
600m / 1900ft
700m / 2200ft
800m / 2600ft
1000m / 3000ft
Coaxial
Bandwidth (Mbps)
99.0
50.5
20.2
13.4
0
Video Image
Clear, Smooth
Clear, Smooth
Clear, Smooth
Clear, Smooth
No Signal
4
Application 3: Point-to-Multi Point
Device
1
2
3
4
5
6
Distance
200m / 650ft
400m / 1200ft
600m / 1500ft
800m / 2600ft
1000m / 3000ft
2000ft / 6500ft
Coaxial
Bandwidth (Mbps)
89.6
58.44
48.15
25.45
70.87
82.90
Device
1
2
Distance
300m / 950ft
600m / 1500ft
3
4
900m / 2900ft
1000m / 3000ft
Application 4: (Max with EPOC-100-SV)
UTP
Bandwidth (Mbps)
89.6
48.15
25.45
70.87
Video Image
Clear, Smooth
Clear, Smooth
Clear, Smooth
Clear, Smooth
Clear, Smooth
Clear, Smooth
Video Image
Clear, Smooth
Clear, Smooth
Clear, Smooth
Clear, Smooth
Device
1
2
3
4
Distance
200m / 650ft
400m / 1200ft
600m / 1500ft
700m / 2200ft
Coaxial
Bandwidth (Mbps)
70.25
60.2
14.6
0
5
Video Image
Clear, Smooth
Clear, Smooth
Clear, Smooth
No Signal
Hardware Installation ..
1. Please turn off the signal source and the device's power, installation with power on may damage the device.
2. Use network cable to connect IP camera with IPC's RJ45 port.
3. Use network cable to connect Receiver's RJ 45 port and NVR.
4. Use telephone cable or UTP cable/Coaxial cable to connect with Transmitter and
Receiver's transmission port.
5. Check if the installation is correct and device is good, make sure all the connection is reliable and power for the system.
6. Make sure every network device has power supply and work normally.
Technical Specifications
Kit Model
Model
Application Location
EOC-100-SV
Host/Server Side
EOC-100PK
EOC-100-IPC
Camera Side
..
Power Supply
Power Consumption
Ethernet Port
Transmission Distance
LED Status Indicator
ESD Protection
MTBF Stability
Working Temperature
Storage Temperature
Humidity (non-condensing)
Dimensions (L x W x H)
Net Weight
12V DC Power
< 10W
EOC Port: Use coaxial cable to transmit Ethernet signal and power
Ethernet Port: 10/100mbps
Coaxial Cable: 2000m / 6500ft (max)
(transmission rate decrease with distance)
Cat5\5e\6: 100m / 300ft
Power: 1 (Red)
Ethernet: 1 (Green)
RJ415 Ethernet: 1 (Green), 1 (Yellow), indicate
Link/Active
1a Contact Discharge Level 3
1b Air Discharge Level 3
Per: IEC61000-4-2
> 30,000h
32°F ~ 131°F / 0°C ~ 55°C
-40°F ~ 158°F / -40°C ~ 70°C
0~95%
82 x 100 x 25 mm / 3.23 x 3.94 x 0.98 inches
180g / 6.35 oz
*Specifications are subject to change without notice
6
Trouble Shooting ..
• Please confirm if the installation is correct.
• Please confirm if the RJ45 cable order in accordance with the EIA/TIA568A or 568B industry standards.
• The maximum transmission distance is depend on the signal source and cable quality, please do not over the maximum transmission distance.
• Please replace a normal device with a failure one to check if the device is broken.
• If the problem still exist, please contact the factory.
Limited Warranty
LIMITED ONE (1) YEAR WARRANTY AND EXCLUSIONS
Manufacturer warrants to the original consumer purchaser and not for the benefit of anyone else that this product at the time of its sale by Manufacturer is free of defects in materials and workmanship under normal and proper use for one (1) year from the purchase date. Manufacturer's only obligation is to correct such defects by repair or replacement, at its option, if within such one (1) year period the product is returned prepaid, with proof of purchase date, and a description of the problem. This warrant excludes and there is disclaimed liability for labor for removal of this product or reinstallation.
This warranty is voided if this product is installed improperly or in an improper environment, overloaded, misused, opened, abused, or altered in any manner, or is not used under normal operating conditions or not in accordance with any labels or instructions. There are no other implied
warranties of any kind, including merchantability and fitness or a particular purpose, but if any implied warranty is required by the applicable jurisdiction, the duration of any such implied warrant, including merchantability and fitness of or a particular purpose, is limited to one (1) year.
Manufacturer is not liable for incidental, indirect, special, or consequential damages, including without limitation, damage to, or loss of use of, any equipment, loss sales or profits or delay or
failure to perform this warranty obligation. The remedies, provided therein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise.
www.AAS.com.tw
..
7
CAUTION!!!
Failure to read this notice may result in damaging the camera or device in which the warranty will be voided due to installation error.
When using any type of RJ45 jack powered balun, a Cable Tester must be used to ensure proper connection. Many individuals can make RJ45 connections easily, however mistakes can be made.
When making connections for powered baluns, make sure to test the connectivity and ensure proper alignment on both sides.
Cable Tester
When using passive or active baluns, the alignment of the cable is imperative to the success of the operation. Use a Cable Tester because it is a very simple, yet easy to find tool that can save a huge headache. For example, if one of the video wires accidentally gets crimped into the power side, and the powered balun is then hooked up to the camera, both the camera and the balun have just burned out. This is an extremely costly mistake, not only in dollars but time as well.
How long does it take to test the RJ45 using a Cable Tester? Less than one minute.
The new terms and conditions state: When an RMA is requested and the product has been burned by bad RJ45 connections, the product is NO LONGER covered under warranty.
Note: Whichever way the RJ45 is terminated on one end of the cable, IT MUST BE THE SAME ON
THE OTHER SIDE for either TIA/EIA 568A or TIA/EIA 568B. Below is an example of TIAEIA 568B.
1 2 3 4 5 6 7 8
Pair 3
Pair 2 Pair 1 Pair 4
1 2 3 4 5 6
4
5
6
7
8
Pin Pair
1 2
Color
Orange / White
2
3
2
3
Orange
Green / White
3
4
1
1
4
Blue
Blue / White
Green
Brown / White
Brown
Character
Video +
Video –
Power –
Power –
Power –
Power +
Power +
Power +
TIA/EIA 568B
MADE IN CHINA
Copyright © 2014-2015 AAS Technology www.AAS.com.tw
8
N-5
R201502-V24
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project