SE535LTD Earphones User Guide (English)

Sound Isolating™ Earphones
Shure Sound Isolating™ Earphones, built
with balanced armature speakers, deliver
a detailed soundstage free from outside
noise. The powerful and stylish Shure SE
earphones come with a detachable cable,
adapters, a durable carrying case, and
interchangeable Sound Isolating™ sleeves
for a comfortable and personalized fit.
­ 2011 Shure Incorporated
27A16273 (Rev. 1)
­Printed in China
The following are some suggested ways of wearing the earphones.
Over the ear in back
Wearing the cable over the ear
and securing it behind the head
can help keep the earphones in
place during physical activity
Tighten the cable and take up
slack by raising the cable cinch.
Wearing the Earphones
Cleaning the Earphone Nozzle
If you notice a change in sound quality, remove the sleeve and check the nozzle
of your earphone. If nozzle is blocked, clear obstruction by
using wire loop end of cleaning tool.
Wire Loop
Caution: When cleaning, do not force any object through the earphone nozzle!
This will damage the earphone sound filter.
Warning: The cleaning tool is only to be used to clean the earphones.
Any other use, such as using the tool to clean ears, could result in injury.
• Earphone Sleeves
• Music Phone Accessory Cables
• Replacement Cables
• Volume Control
• Carrying Cases
• Adapters
For more information visit
• Careful maintenance ensures a tight seal between the sleeve and nozzle, improving
sound quality and product safety.
• Keep the earphones and sleeves as clean and dry as possible.
• To clean sleeves, remove them from earphones, gently rinse in warm water and air
dry. Foam sleeves require a longer drying time. Inspect for damage and replace if
necessary. Ear sleeves must be completely dry before reusing.
• Wipe the earphones and sleeves with mild antiseptic to avoid infections. Do not use
alcohol-based disinfectants.
• Do not expose earphones to extreme temperatures.
• Replace the sleeves if they do not fit properly.
• Do not attempt to modify this product. Doing so will void the warranty and could result in
personal injury and/or product failure.
• Note: The cable connectors to the earphones may collect debris or other deposits that
can affect audio quality. If this happens, disconnect the cables and clean them using a
dry cotton swab.
WARNING: This product contains a chemical known to the State of California to cause
cancer and birth defects or other reproductive harm.
Technical Specifications
SE535LTD – Red
Transducer type
Triple balanced-armature drivers
Sensitivity (at 1khz)
119 dB SPL/mW
Impedance (at 1kHz)
36 W
Frequency Range
Input connector
18 Hz - 19.5 kHz
3.5mm (1/8 in.) gold-plated stereo plug
Net weight
Storage temperature
30 g (1 oz.)
-18° C to 57° C (0° F to 135° F)
-29° C to 74° C (-20° F to 165° F)
Eligible to bear CE Marking. Conforms to EMC Directive 2004/108/EC. Meets applicable
tests and performance criteria in European Standard EN55103 (1996) parts 1 and 2, for
residential (E1) and light industrial (E2) environments. The Declaration of Conformity can
be obtained from the address below.
Shure Europe GmbH
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12,
75031 Eppingen, Germany
Phone: +49-7262-92490
Fax: +49-7262-9249114
Download PDF