CLEANING
Water contains lime which remains on the surface after the water has evaporated. These lime deposits can be prevented from forming by wiping immediately after use.
To clean the chrome-plated surface use a soft cloth, soap and warm water. Never use cleaning agents that contain a corrosive acid or a scouring additive.
Clean filter washer periodicallly
WAIPORI SATINJET SLIDE RAIL SHOWER/
HANDSET WITH HOSE
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min 35 kPa, Max 500 kPa.
Recommended installation of a pressure limiting valve if supply exceeds 500kPa.
Operating Temperature:
Max 70°C.
NB: New Zealand Building Code Clause G12 -
Water Supplies specifies all outlets used primarily for personal hygiene shall deliver water at a safe temperature.
Inlet Connections: All ½" BSP.
Do not use any shap objects to clean nozzles
NOTES:
1) Low and unequal systems:
Removal of the flow restrictor with pliers may be necessary to optimise flow performance in low or unequal pressure systems only. Flow restrictor is lodged firmly in the end of the handset.
Methven warrants this product against manufacturing defects and that it is suitable for use under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com
or call Customer Service
New Zealand
0800 804 222
Australia
1300 638 483
USA
1800 975 5409
UK
0800 195 1602
436725 Issue D
1.
Waipori Handset
Slider
Hose
Soap Dish
Elbow
5.
2.
grub screw topside
Wall Boss Housing
Internal Mounting Bracket
Rail
Screw
Grub Srew
NOTE: ENSURE
PROTECTION
PADS ARE USED
BETWEEN WALL
BOSSES AND TILES grub screw underside
6.
Secure the wall boss housings in desired position with 4 screws.
Check the mounts are vertical.
Ensure the grub screws are located as shown.
Floor
Match the mountings up to the wall bosses and push into place.
Slide the rail up and down if required to centralise the rail on the brackets
Once satisfied that the rail is centralised remove the rail and tighten the tensioning screws until they lock.
Relocate the rail onto wall bosses and tighten grub screws top and bottom.
3.
7.
Attach the shelf to the rail from the end with the endcap already fitted .
Fitted endcap
Fit end cap to top of rail. Ensure drainage hole is at back
4.
Fit the internal mounting brackets by locating in slot and rotating 90 ° as shown.
Once located tighten the screws finger-tight.
8.
NOTE: TO LOOSEN SLIDERS
GRIP ON RAIL ROTATE SIDE
PIECE ANTI-CLOCKWISE.
ROTATE CLOCKWISE TO
TIGHTEN
Filter Washer
Non-Swivelling Cone
Flat Washer
Swivelling
Cone
