Echo Minimalist Slide Shower
SPECIFICATIONS:
Elbow Connection : ½” BSP Female
IMPORTANT:
1) FLUSH ALL PIPEWORK PRIOR TO INSTALLATION
2) If the all pressure shower is used in equal high pressure installations the flow rate can be limited to 9 litres/min by fitting the flow restrictor. Insert the flow restrictor into the inlet of the handpiece with the pointed rubber section facing outwards.
INSTALLATION INSTRUCTIONS:
1. Remove the cover pieces from the mounting brackets.
2. Determine the desired location of the rail and attach the bottom bracket.
3. If vertical clearance above or below the intended rail position is limited, insert the rail now. Otherwise insert the rail after the top bracket has been fitted.
4. Fit the top bracket to the wall, aligning the two brackets vertically to suit the rail.
5. Fit the rail, the slider and the soapdish. The slider mechanism is locked and unlocked by turning the handle. Ensure that the handle is facing away from the wall when in the unlocked position.
6. Tighten the threaded inserts into each bracket to lock the rail into place. Replace the covers onto the mounting brackets.
7. Install the elbow with the outlet pointing down.
8. Insert the rubber washers into the ends of the hose.
9. Attach one end of the hose to the elbow.
10. Attach the handpiece to the other end of the hose.
433076
Where Methven tapware or valving (tapware) is purchased for use or on-sale in the context of any business, Methven undertakes to either repair or replace (at its option) that tapware, if it is discovered that such tapware contains a material defect, which arose in the course of manufacture. This undertaking shall not apply if:
1. The defect is brought to Methven's attention later than 2 years after the date of purchase, where the defect relates to washers, "O" rings and powder
coating, or 5 years where the defect relates to any other tapware componentry. Proof of purchase will be required.
2. There is a failure by any person to follow Methven's installation instructions or the tapware is used other than in accordance with Methven's
specifications.
3.
4.
Evidence cannot be produced which confirms that the relevant tapware was purchased from a Methven authorised distributor.
Repair work is performed on the relevant tapware by a person other than Methven, its authorised service agents or any plumber who has not
received authorisation prior to proceeding with the work.
The above undertaking from Methven shall also apply to any purchaser of Methven tapware who is a "Consumer" under the Consumer Guarantees Act 1993, in addition to any other right or remedy which such person may have under that Act.
Methven shall in no way be liable to the purchaser or user of any tapware, for any loss, damage (direct, indirect or consequential), cost or expense suffered or incurred by that person, otherwise than as provided in the above provisions, or as provided under the Consumer Guarantees Act 1993.
Distributed by Methven Limited, 447 Rosebank Rd., Avondale, Auckland, New Zealand
Phone : 03 455 1149 Fax : 0800 805 222
Issue A www.methven.biz
Page 1 of 1
