Methven FU2011CP Futura Satinjet FU Slide Rail Shower Installation Sheet
Advertisement
Advertisement
Methven warrants this product against manufacturing defects and that it is suitable for use under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com
or call Customer Service.
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
435033 Issue A
FU2011CP Futura FU Satinjet Slide Rail
Shower
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min 35kPa, Max 500kPa.
Recommended installation of a pressure limiting valve if supply exceeds 500kPa
Operating Temperature:
Max 70°C.
NB: New Zealand building code clause G12 - Water
Supplies specifies all outlets used primarily for personal hygiene shall deliver water at a safe temperature.
Inlet connections: All 1/2” BSP
Notes:
●
●
After installation all connections must be checked for leaks.
All installations must be carried out in compliance with relevant water regulations.
NOTE FOR HANDSET ONLY INSTALLATIONS - use step 5 only.
1.
2.
Top Bracket
3.
4.
Slider
Rail
Soap Dish
Locate the bottom bracket in the desired position and attach with one screw.
5.
Bottom Bracket
Attach the slider and the soap dish to the rail in the desired orientation. Fit the rail to the bottom bracket. Fit the top bracket to the rail.
6.
Ensure that the rail is vertical.
CLEANING
Water contains lime which remains on the surface after the water has evaporated. These lime deposits can be prevented from forming by wiping immediately after use.
Insert the remaining screws. Fit the end caps.
To clean the chrome-plated surfaces use a soft cloth, soap and warm water. Never use cleaning agents that contain a corrosive acid or a scouring additive.
Filter Washer
Clean filter washer periodically.
Do not use any sharp objects to clean nozzles.
For handset only installations remove existing hose.
Insert the filter washer into the new hose before screwing to the handset.
Adjust shelf and slider position to desired height.
NOTE: Removal of the flow restrictor in the handset may be necessary to optimise flow performance in low or unequal pressure systems only

Public link updated
The public link to your chat has been updated.
Advertisement