MINIMALIST MK2 OVERHEAD SHOWER
Installation Guide
Technical Specifications:
Operating Pressure:
Min: 150kPa/1.5bar - 500kPa/5bar
Max: 1000kPa/10bar*
Optimum: 150kPa/1.5bar - 500kPa/5bar
Operating Temperature:
Hot: Max 60°C*
Cold: Min 5°C
Inlet Connections:
All ½" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at www.methven.com
www.methven.com
New Zealand
0800 804 222
Australia
13 14 16
UK
0800 195 1602
IMPORTANT: Please read all of the instructions before installation.
GENERAL:
Max Ø 25mm
Trim Ring
• This product must be installed in compliance with all relevant regional regulations.
• It is the responsibility of the installer to ensure a watertight seal is achieved.
Min 10mm
• All outlets used primarily for personal hygiene shall deliver water at a safe temperature as per regional regulations.
Filter Washer
NOTE: Use plumbers tape or similar on ¹⁄₂" male threaded connection to ensure a reliable seal.
Overhead Shower
Arm
(If Supplied)
•
•
Where a Hand Shower and/or Overhead Shower is fitted with a flow regulator the lower flow rate may not be suitable for the connection to some gravity fed Water Heaters, low pressure supply networks, Instantaneous Water Heaters, Tempering Valves, Solar Water Heaters & Thermostatic
Mixing Valves. Check with the manufacturers of these products.
Where showers incorporate flow controllers, care must be exercised during installation to ensure that the male connecting threads do not damage the flow controllers.
CARE AND CLEANING:
• Never use abrasives or abrasive cleaning agents to clean this product. To clean the chrome-plated surface use contamination free warm soapy water and a damp soft cloth.
• Lime deposits can be prevented from forming on the faceplate by wiping immediately after use. If shower performance is compromised by the build-up of lime-scale, soak in limescale remover for up to 10 minutes. Do not attempt to remove limescale with sharp objects or abrasives. Do not use products containing chlorine bleach or hydrochloric acid as these can damage the shower. Always rinse the shower thoroughly after cleaning to remove cleaning products that can damage the shower.
• Clean face plate using a brush with soft bristles.
• Do not use any sharp objects to clean nozzles.
• Clean filter washer located in the ball joint periodically.
Methven warrants this product against manufacturing defects and that it is suitable for use under the general operating conditions specified in this instruction sheet. However, regional regulations apply and may affect your warranty. Please refer to www.methven.com
or call customer service for full details.
New Zealand
0800 804 222
Australia
13 14 16
UK
0800 195 1602
IS 1926 ISSUE A
