Rifle scope Black Anaconda

Rifle scope Black Anaconda
User's manual
www.seben.com
OPERATION
MANUAL
This scope can be used for shot gun, airgun and rifles of military use. It
can greatly increase aiming accuracy and percentage of hits. It has the
characteristics of good optical performance, waterproof and shockproof.
1.EYE PIECE
2.ILLUMINATION
4.ELEVATION ADJUSTMENT
3.ZOOMING RING
5.WINDAGE ADJUSTMENT
6.OBJECTIVE
FOCUSING THE EYE LENS
1.Hold scope about three inches from your eye.
2.Quickly glance through the scope at a featureless area, such as a wall or
the open sky.
CAUTION—DO NOT LOOK AT THE SUN AS PERMANENT EYE DAMAGE,
EVEN BLINDNESS MAY RESULT.
3.If the reticle did not instantly appear in sharp focus, rotate the eye bell
in either direction until reticle is sharply focused.
ATTACHING SCOPE TO MOUNT
1.Remove ring caps from mount, place scope in cradle formed by uncapped
ring.
2.Slide scope fore or aft to position scope at the proper eye point. ( Full
field of view can be seen).
3.Rotate scope to align the reticle horizontally and vertically.
4.Replace ring caps and tighten firmly.
ZEROING
Since zeroing involves live fire, check bore to be sure it is free of any
obstructions before loading. Use eye and ear protection.
Fire three rounds at your target. Note impact on target. Measure the
distance from group center to target center.
Adjust the windage and elevation screws accordingly. Each click
adjustment will move the bullet impact by the amount shown on the dials
(type C or D) at 100 yards.
Replace windage and elevation caps when zeroing is completed.
Each click of adjustment will move the bullet impact by the amount shown
at the distance indicated.
50
YDS
100YDS
200YDS
TYPE
1/8"
1/4"
1/2"
C
TYPE
1/4"
1/2"
1"
D
ILLUMINATION
There are degrees of illumination. The rheostat in located at the top of
the eyebell. The batteries (included with the unit) are coin style lithium
batteries. Insert them “ +” side up in the battery housing.
MAINTAINING
The scope should be kept in the dry and ventilated place where there is
no acid, alkail and volatile corrosive matter.
The lens surface with dust and greasy dirt may be cleaned with cotton
flannel, absorbent cotton or lens tissue. When necessary , they may be
dipped with a little absolute alcohol, but other solvent should not be used.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement