MULTI
DUCTLESS INVERTER
HEAT PUMP
DUCT TYPE
INDOOR UNIT
OWNER'S MANUAL
Models:
GFH(12)EA-D3DNA1A/I
GFH(18)EA-D3DNA1A/I
User Notice
◆ The total capacity of the indoor units which runs at the same time can not exceed 150% of that of the outdoor units; otherwise, the cooling (heating) effect of each indoor unit would be poor.
◆ Switch the main power on 8 hours before start the unit, helpful for a successful startup.
◆ It is a normal phenomenon that the indoor unit fan will still run for 20~70 seconds after the indoor unit receives the “stop” signal so as to make full use of after-heat for the next operation.
◆ When the running modes of the indoor and outdoor units conflict, it will be indicated on the display of the wired controller in five seconds and then the indoor unit will stop. In this case, they can back to the normal condition by harmonizing their running modes: The HEAT mode conflicts with each of the COOL mode, DRY mode and FAN mode, while the COOL mode, DRY mode and
FAN mode are compatible between each other. If the supply power fails when the unit is running, then the indoor unit will send the “start” signal to the outdoor unit three minutes later after power recovery.
◆ During installation, the communication cable and the power cord must not be twisted together but instead separated with an interval of at least 3/4”( 2cm ) , otherwise the unit is likely to run abnormally.
◆ This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Thank you for selecting Cooper&Hunter air conditioner. Before use, please read this manual carefully and keep it properly for furthur reference.
Thank you for choosing a
C&H Multi Ductless Heat Pump !
Y
ou
c
an
f
ee
l c
on
f
i
d
ent in
y
our
s
e
l
e
c
tion
b
e
c
au
s
e t
h
e
s
ame pri
d
e in
c
ra
f
t
s
man
s h
ip an
d
engineering kno
wl
e
d
ge t
h
at goe
s
into mi
ll
ion
s
o
f
ot
h
er
C&H
in
s
ta
ll
e
d
pro
d
u
c
t
s w
or
ldw
i
d
e
h
a
s
gone into
y
our unit
.
Pl
ea
s
e rea
d
t
h
i
s
o
w
ner ’
s
manua
l c
are
f
u
ll y b
e
f
ore operationan
d
retain it
f
or
f
uture re
f
eren
c
e
.
Contents
1 Safety Precautions .
.........................................................................................
1
2 Error Analysis .
.................................................................................................2
3 Maintenance .
...................................................................................................3
Free Match
1 Safety Precautions
Please read this manual carefully before using and operating correctly as instructed in this manual.
Please take special attention to the meaning of these two marks:
Warning! It indicates improper operation which will lead to human casualty or severe injury.
Note!
It indicates improper operation which will lead to injury or property damage.
Warning:
◆ The installation should be committed to the appointed service center; otherwise it will cause water leakage, electric shock or fire etc..
◆ Please install the unit at a place where is strong enough to withstand the weight of the unit; otherwise, the unit would fall down and cause injury or death.
◆ The drain pipe should be installed as instructed in the manual to guarantee the proper drainage; meanwhile it should be insulated to prevent condensing; otherwise the improper installation would cause water leakage and then wet the household wares in the room.
◆ Do not use or place any inflammable, combustible or any noxious substance next to the unit.
◆ Under the occurrence of an error (like burning smell etc.), please cut off the main power supply of the unit.
◆ Keep good ventilation in the room to avoid oxygen deficit.
◆ Never insert your finger or any other object into the air outlet/inlet grille.
◆ Please take notice of the supporting frame of the unit to see if it is damaged over the long time period of use.
◆ Never refit the unit and contact the sales agent or the professional installation personnel for the repair or relocation of the unit.
An all-pole disconnection switch having a contact separation of at least 3mm in all poles should be connected in fixed wiring.
Caution!
◆ Before installation, please check if the power supply corresponds with the requirement specified on the nameplate and also check its security.
◆ Before using the unit, please check if the piping and wiring are correct to avoid water leakage, refrigerant leakage, electric shock, or fire etc.
◆ The main power supply must be earthed to avoid the hazard of electric shock and never connect this earth wire to the gas pipe, running water pipe, lightening rod or phone cable’s earth lead.
◆ Turn off the unit after it runs at least five minutes; otherwise its service life will be shortened.
◆ Do not allow children operate this unit.
◆ Do not operate this unit with wet hands.
◆ Cut off the main power supply prior to the cleaning of the unit or the replacement of the air filter.
◆ When the unit is not to be used for a long time, please cut off the main power supply of the unit.
◆ Do not expose the unit to the moist or corrosive circumstances.
◆ After the electric installation, please take an electric leakage test.
1
Free Match
2 Error Analysis
If your conditioning unit runs abnormally, please check the following items before contacting the maintenance serviceman.
Table 1
Errors
Failed startup
Possible Causes
There is no power supply.
The breaker opens owing to electrical leakage.
Voltage is too low.
Stop after a short while of operation
The air inlet/outlet of the indoor/outdoor unit is clogged.
Poor cooling effect
Poor heating effect
The air filter screen is too dirty or clogged.
There are too much heat sources or people in the room.
The door or window is open.
There are obstacles at the air inlet/outlet.
The set temperature is too high.
The air filter screen is too dirty or clogged.
The door or window is not closed fully.
The set temperature is too low.
Uncontrollable controller
If the remote controller crashes even if the batteries have been replaced, please open the back cover of it and press the button
ACL” to let it back to the normal condition.
Is the remoter controller in the signal receiving range? Or is it blocked by obstacles?
For the duct type unit, operate the remote controller pointing at the wired controller.
Check if the otherwise change new batteries .
of the wired controller is enough; or change them.
Note:
If the air conditioner still runs abnormally after the above check and handling, please contact the maintenance serviceman at the local appointed service center.
2
Free Match
3 Maintenance
CAUTION!
Take notice of the following items before cleaning your air conditioning unit.
(1). Cut off the main power supply before contacting any wiring device.
(2). Only when the unit is turned off and the main power supply is cut off, can the unit be cleaned; otherwise it would cause an electric shock or injury.
(3). Do not wash the unit with water; or it may cause an electric shock.
(4). During the cleaning, remember to use the stable standing platform Daily Maintenance.
1). How to clean the filter
① .
Never dismantle the air filer except for cleaning; otherwise it may cause some error.
② .
When the air conditioning unit is used under the environment with heavy dust, the air filter should be cleaned often (generally once every two weeks).
2). Maintenance before seasonal use
① .
Check if the air inlet/outlet of the indoor unit is clogged.
② .
Check if the earthing is in good condition.
③ .
heck if the wiring is in good condition.
④ .
Check if the indicating lamp of the wired controller blinks after it is energized.
Note: If there is something abnormal, please consult the after-sales serviceman.
3). Maintenance after seasonal use
① .
Let the air conditioning unit run for half day under the fan mode to dry the inside of the unit.
② .
If the unit is not to be used for a long time, please shut off the main power supply for energy conservation, at the same time, the power indicating lamp of the wired control will go off.
3
www.
cooperandhunter.us
LIMITED WARRANTY STATEMENT
Ductless Heat Pump MultiSplit System
FOR WARRANTY SERVICE OR REPAIR:
Contact your installing contractor. You may find the installer’s name on the equipment or in your Owner’s packet.
Complete product registration below and send back by e-mail at
PRODUCT REGISTRATION:
Model No.: ______________________________________________________________________________________________
Serial No.: _______________________________________________________ Date of Installation: ______________________
Owner Name: ____________________________________________________________________________________________
Address of Installation:_____________________________________________________________________________________
Installing Contractor: ______________________________________________________________________________________
Address: ________________________________________________________________________________________
Phone No. / E-mail: _______________________________________________________________________________
C&H distributor (hereinafter “Company”) warrants this product against failure due to defect in materials or workmanship under normal use and maintenance as follows. All warranty periods begin on the date of original installation. If the date cannot be verified, the warranty period begins one hundred twenty (120) days from date of manufacture. If a part fails due to defect during the applicable warranty period Company will provide a new or remanufactured part, at Company’s option, to replace the failed defective part at no charge for the part. This limited warranty is subject to all provisions, conditions, limitations and exclusions listed below.
A warranty period of Seven (7) years on compressor to the original registered end-user.
A warranty period of Five (5) years on all parts to the original registered end user.
A warranty period of One (1) year on the remote control provided with the original unit.
Limited warranty applies only to systems that are properly installed by a state certified or licensed HVAC contractor, under applicable local and state law in accordance with all applicable building codes and permits; C&H installation and operation instructions and good trade practices.
Warranty applies only to products remaining in their original installation location.
Defective parts must be returned to the distributor through a registered servicing dealer for credit.
LIMITATIONS OF WARRANTIES: ALL IMPLIED WARRANTIES AND/OR CONDITIONS (INCLUDING IMPLIED WARRANTIES OR
CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR USE OR PURPOSE) ARE LIMITED TO THE DURATION OF
THIS LIMITED WARRANTY, SOME STATES OR PROVINCES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY
OR CONDITION LASTS, SO THE ABOVE MAY NOT APPLY TO YOU. THE EXPRESS WARRANTIES MADE IN THIS WARRANTY ARE
EXCLUSIVE AND MAY NOT BE ALTERED, ENLARGED, OR CHANGED BY ANY DISTRIBUTOR, DEALER, OR OTHER PERSON,
WHATSOEVER.
THIS WARRANTY DOES NOT COVER :
1.
Labor or other costs incurred for diagnosing, repairing, removing, installing, shipping, servicing or handling of either defective parts, or replacement parts, or new units.
2.
Product cleaning required prior to warranty service and repair.
3.
Normal maintenance as outlined in the installation and servicing instructions or Owner’s Manual, including filter cleaning and/or replacement and lubrication.
4.
Failure, damage or repairs due to faulty installation, misapplication, abuse, improper servicing, unauthorized alteration or improper operation.
5.
Failure to start due to voltage conditions, blown fuses, open circuit breakers, or damages due to the inadequacy or interruption of electrical service.
6.
Failure or damage due to floods, winds, fires, lightning, accidents, corrosive environments (rust, etc.) or other conditions beyond the control of the Company.
7.
Failure or damage of coils or piping due to corrosion on installations within one (1) miles of sea coast or corrosive body.
8.
Parts not supplied or designated by Company, or damages resulting from their use.
9.
Products installed outside continental USA and Canada.
10. Electricity or fuel costs, or increases in electricity or fuel costs from any reason whatsoever, including additional or unusual use of supplemental electric heat.
11. Any cost to replace, refill or dispose of refrigerant, including the cost of refrigerant.
12. Shipping damage or damage as a result of transporting the unit.
13. Accessories such as condensate pumps, line sets and so forth are not covered.
14. Any special, indirect or consequential property or commercial damage of any nature whatsoever. Some states or provinces do not allow the exclusion of incidental or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state or province to province.
66175200003
