Installation Manual
AC-100
WARNING: DO NOT ATTEMPT TO INSTALL OR USE THE
AC100 FIXTURE WITHOUT READING THE INSTALLATION
INSTRUCTIONS AND SAFETY LABELS COMPLETELY.
FAILURE TO ADHERE TO THESE INSTRUCTIONS COULD RESULT IN SERIOUS
INJURY OR PROPERTY DAMAGE.
DO NOT MODIFY, ALTER OR ATTEMPT TO SERVICE THE AC100.
DOING SO WILL VOID THE WARRANTY.
Installation Instructions
AC100
Solid Color Dimmable LED Light Strips
Introduction:
The Boca AC100 is designed for low power applications where energy consumption and size are the main concerns. It can be specified with either 18, 36, 52, or 72 LED’s per linear foot, depending on the housing that’s chosen and the light output required. It offers seamless LED configuration, easy installation, and vibrant solid color. The AC100 can be used with any magnetic low voltage dimmer and is available in different housings for different uses, including underwater installations where IP68 is required.
Maintenance:
CLEANING Dry and Damp (IP65) Rated Fixtures: To clean surface use a soft damp cloth.
Wet (IP68) Rated Fixtures: To clean surface use a soft cloth with mild soap and water.
STORAGE Store in a dry, well-ventilated area when product is not in use.
Keep the electrical cord away from heated surfaces when in use or not in use.
If cord shows signs of damage do not use, return product to manufacturer.
Electrical Specifications:
1. Input Voltage: 24 VDC or 24 VAC (See layout drawings for spec.)
2. Total linear ft per 20A breaker: Single Row - 175ft ; Double Row - 90ft; Triple Row-56ft;
Four Rows - 45ft;
3. Total linear ft per 15A breaker: Single Row- 146ft; Double Row - 65ft; Triple Row - 48ft;
Four Rows - 32ft Input Current: 90mA RMS per linear foot, per row.
IP65
DAMP LISTING
IP68
WET LISTING
Max temp: 55C
Min. temp: -40C
Fixtures must be installed by a qualified and licensed electrician in accordance with all national, state and local electrical codes and regulations.
If any part of this manual does not meet the necessary codes and regulations, contact the factory for more information before attempting to install.
Model Dependent
Turn Power Off At Circuit Breaker Before Beginning Installation!
INCLUDED IN THIS PACKAGE:
1
AC100 Fixtures
(In lengths shown on job specific drawings)
2
Mounting Brackets
(2 brackets per fixture)
3
Remote Transformers
(If ordered)
Underwater Tube
OR
OR
Tube
For Underwater Tube
5
Distribution Box
(If ordered)
For Tube
6 Job Specific Drawings
4
Distribution Box
(If ordered)
Cables shown are interior
Cables shown are interior
AC100
Installation Instructions
AC100
1. INSTALL CLIPS INTO SUBSTRATE
1a 1b
OR
OR OR
Screw Information:
1. Screws not provided by
Boca Flasher.
2. For Tube Boca Flasher recommends
wide washer flat head Philips #6
screw for the tube. For underwater
tube, Boca Flasher recommends
Philips #8 screw.
(not to exceed .330”)
3. Length of screw will vary depending
on mounting surface.
4. For outdoor installations,
installer should use a screw with
weatherproof coating.
2. INSTALL FIXTURES INTO CLIPS
2a
Push Fixture down with slightly firm pressure.
2b
Clip will securely snap into place.
OR
▶
OR
▶ snap!
▶
▶
3. CONNECT FIXTURES TOGETHER
FOR TUBE ONLY
(AS SHOWN ON JOB SPECIFIC DRAWINGS) NOTE: Underwater Tube ships connected.
3a
Connect Male and Female connectors in order shown on job specific drawings.
3b 3c
Push together until you hear a “Click”.
Coupler click!
▶
▶
PAGE 3 OF 6
4a CONNECT FIXTURES TO POWER
Installation Instructions
AC100
4b CONNECT FIXTURES TO POWER
WITH DINNING SYSTEM
PAGE 4 OF 6
Installation Instructions
AC100
IMPORTANT SAFETY REMINDERS:
1. DANGER:
To reduce the risk of electric shock, always unplug the AC100 from electrical outlet before cleaning. Cut breaker if outlet is not available.
2. To reduce the risk of burns, fire, electric shock or injury to persons:
• Use the AC100 only for its intended use as described in these instructions.
• Do not use attachments not recommended by Boca Flasher.
• Never operate the AC100 if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or dropped into water. If the seal appears
to be damaged/broken/torn return the AC100 to a service center for examination or repair.
• Keep cord away from heated surfaces.
• Never drop or insert any object into any opening.
• Do not operate where aerosol (spray) products are being used or where oxygen is
being administered.
3. WARNING:
Do not attempt to install or use the AC100 without reading the installation instructions and safety labels. Failure to adhere to these instructions could result in serious injury or property damage.
4. Do not modify, alter or attempt to service the AC100:
Doing so will void the warranty.
5. Do not use sharp tools near or on the fixture lens:
Doing so will result in property damage and void the warranty.
Boca Flasher, Inc.
508 S. Military Trail n Deerfield Beach, Florida n 33442 USA
Phone: 561-989-5338 n Fax: 561-982-8323 www.bocaflasher.com
We are constantly improving our fixtures and reserve the right to change options and specifications. Additional information & details at www.bocaflasher.com. For specific requirements, contact your Boca Flasher sales representative. Boca Flasher, Inc. 508
S. Military Trail, Deerfield Beach, Florida 33442 USA Phone: 561.989.5338 Fax: 561.982.8323 © 2017 Boca Flasher, Inc. All rights reserved. All names and trademarks are property of their respective owners. REV 06-2017
IP65
DAMP LISTING
IP68
WET LISTING
