Allen-Bradley 140G Series, 140MG Series Quick Start Manual
Allen-Bradley 140G Series:
Compact, rugged, and reliable motor starters for a wide range of industrial applications. Designed for use with IEC contactors and circuit breakers, these starters offer easy installation, flexibility, and durability. Ideal for controlling motors in pumps, fans, compressors, and other industrial machinery.
Advertisement
Advertisement
DIR 1000436R0643 Version 01 - 140G-K-TC3H, 140G-K-TC4H, 140G-K-TC3L, 140G-K-TC4L
HTC/LTC - Terminal covers and seal for 140G-K
HTC/LTC - Copriterminali e sigillo
HTC/LTC - Klemmenabdeckungen und Bleisiegel
HTC/LTC - Cache-bornes et cachet en plomb
HTC/LTC - Cubrebornes y sello
HTC/LTC - 固定式断路器端子盖板及密封件
Installation - Installazione - Instalación
Instalação - -
WARNING: To prevent electrical shock, disconnect from power source before installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
(Seguire i requisiti NFPA70E).
WARNUNG: Vor Installations- oder Servicearbeiten Stromversorgung zur
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen
Sie die Anforderungen nach NFPA70E).
AVERTISSEMENT: Avant le montage et la mise en service, couper l'alimentation secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs. (Vous devez respecter la norme NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de contaminantes. (Cumpra as exigências da norma NFPA70E).
警告:感電事故防止のため、取付けまたは修理の際は電源から取り外してく
ださい。適切なケース内に取付けてください。また、汚染物質がないことを
確認してください。( NFPA70E の要件に従ってください)
警告:为了防止触电,在安装或维修之前必须先切断电源。安装在合适的设备
物
140G-K-TS
Seal
(Ordered separately)
1 2
Bul. 140G/140MG
-TC*L
Screw
LENGTH dia.
1 2 mm (0.47" ) 3
-TC*H
Screw
LENGTH dia.
1 2 mm (0.47" ) 3
9 lb-in
1.0 Nm
LENGTH
1 2 mm (0.47" ) dia.
3
DIR 1000436R0643 Version 01
3 4
5
LENGTH
1 2 mm (0.47" ) dia.
3
9 lb-in
1.0 Nm
LENGTH
1 2 mm (0.47" ) dia.
3
9 lb-in
1.0 Nm
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
LENGTH
1 2 mm (0.47" ) dia.
3
9 lb-in
1.0 Nm
Rockwell Automation maintains current product environmental compliance information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/ sustainability-ethics/product-environmental-compliance.page
Publication 140G-IN014B-MU-P - February 2016 DIR 1000436R0643 Version 01 (L3882) - L9915
Copyright © 2016 Rockwell Automation, Inc. All Rights Reserved. Printed in Italy.

Public link updated
The public link to your chat has been updated.
Advertisement