3 GANG 2 WAY 10AX SWITCH AND TOGGLE SWITC H
YELLOW OR GREY
TO MAINS SUPPLY
RED OR BROWN
TO
N
LOOP
BLACK OR BLUE
GR
SL
EEN/YELLOW
EEVING
LA MPHOLDER
1.0MM
2 TWIN & EARTH CABLE
L
E
CEILING
ROSE
TO EARTH
TERMINAL
IN BOX
1.0MM
2 3-CORE & EARTH CABLE
TO EARTH
TERMINAL
IN BOX
L L1 L2 L
L1 L2 L L1 L2
L L1 L2 L
L1 L2 L L1 L2
TO
LAMPHOLDER
10A TRIPLE POLE FAN SWITCH
TO MAINS SUPPLY
NOTE - THIS ISOLATOR SHALL BE SO
SITUATED AS TO BE INACCESSIBLE TO A
PERSON USING A FIXED BATH OR SHOWER.
N
LOOP
RED OR BROWN
BLACK OR BLUE
GREEN/YELLOW
SLEEVING
COM L2
L
E
1.0MM
2
TWIN & EARTH CABLE
E
CEILING
ROSE
1.0MM
2 TWIN &
EARTH CABLE
L1 L2 L3
(N)
SINGLE POLE
CIRCUIT SWITCH
L1 L2 L3(N)
TO EARTH
TERMINAL
IN BOX
THE ABOVE DIAGRAN SHOWS THE
USE OF A LAMP IN THE CIRCUIT
WHILST USUAL THIS IS NOT VITAL
NEUTRAL
SWITCHED LIVE FAN
LAP-MPI0005/D-SF
Wiring Accessories
Fitting and Wiring Instructions
1). Before commencing work, isolate the mains power supply and remove the fuse in the fuse box or switch off the circuit breaker in the consumer unit.
2). If unit is to be used as a replacement for an existing product, remove existing unit from its location and disconnect the wiring.
Please note: if the existing box is a 4 lug box, the top & bottom lugs should be removed or bent back to ensure clearance from the interior.
3). Connect the wires as shown in appropriate wiring diagrams overleaf.
Use green/yellow sleeving on earth conductors not insulated.
Ensure terminals are properly tightened and no bare wire is visible.
Push back unit into mounting box making sure conductors are not trapped.
4). Screw the unit module to the mounting box, please ensure screws are sufficiently tight to support the product but please do not over tighten as this may cause some deformation.
5). Place the decorative front cover plate over the module and press firmly top and bottom until all retaining clips have fully clipped into position. To remove the decorative front cover plate, carefully insert a 3mm terminal screwdriver into the bottom slots and lift upward until the retaining clips disengage from the plastic grid moulding.
Please ensure the decorative plate is held as it is released to avoid it being dropped and damaged.
6).
These products must be installed in accordance with the latest
Building and IEE wiring regulations. If in any doubt, please contact a qualified electrician.
UK Manufacturer: Kingfisher International Products Limited , 3
Sheldon Square , London, W2 6PX, United Kingdom www.kingfisher.com/products • www.screwfix.com
EU Manufacturer: Kingfisher International Products B.V.,
Rapenburgerstraat 175E, 1011 VM Amsterdam, The Netherlands • www.screwfix.ie
BATCH CODE EXPLANATION yyWxx: Manufacturing code: year of manufacturing(yy) and week of manufacturing (Wxx).
BX220IM
