3 GANG 2 WAY 10AX SWITCH AND TOGGLE SWITCH
E TO MAINS SUPPLY
OIM HN) YELLOW OR GREY
С] RED OR BROWN
mu BLACK OR BLUE
(2777/1 GREEN/YELLOW
SLEEVING
1.0MM? TWIN & EARTH CABLE N
o CEILING
$222 ROSE
TO EARTH
TERMINAL
1.0MM? 3-CORE & EARTH CABLE
о ТО EARTH
= J TERMINAL
IN BOX
IN BOX
10A TRIPLE POLE FAN SWITCH
TO MAINS SUPPLY
NOTE - THIS ISOLATOR SHALL BE SO
SITUATED AS TO BE INACCESSIBLE TO A
PERSON USING A FIXED BATH OR SHOWER.
Г] RED OR BROWN
mam BLACK OR BLUE
TO = [2772 GREEN/YELLOW
LAMPHOLDER 1.0MM? TWIN & EARTH CABLE SLEEVING
LL
- TO EARTH
EEE: uns Я TERMINAL
IN BOX
1.0MM? TWIN 8.
EARTH CABLE
Eu SINGLE POLE
COM 12 Е— | CIRCUIT SWITCH
THE ABOVE DIAGRAN SHOWS THE
USE OF ALAMP IN THE CIRCUIT
WHILST USUAL THIS IS NOT VITAL
LAP-MPI0005/D-SF
Wiring Accessories
Fitting and Wiring Instructions
1). Before commencing work, isolate the mains power supply and
remove the fuse in the fuse box or switch off the circuit breaker in
the consumer unit.
If unit is to be used as a replacement for an existing product, remove
existing unit from its location and disconnect the wiring.
Please note: if the existing box is a 4 lug box, the top & bottom lugs
should be removed or bent back to ensure clearance from the
interior.
3). Connect the wires as shown in appropriate wiring diagrams overleaf.
Use green/yellow sleeving on earth conductors not insulated.
Ensure terminals are properly tightened and no bare wire is visible.
Push back unit into mounting box making sure conductors are not
trapped.
4). Screw the unit module to the mounting box, please ensure screws
are sufficiently tight to support the product but please do not over
tighten as this may cause some deformation.
Place the decorative front cover plate over the module and press
firmly top and bottom until all retaining clips have fully clipped into
position. To remove the decorative front cover plate, carefully insert
a 3mm terminal screwdriver into the bottom slots and lift upward
until the retaining clips disengage from the plastic grid moulding.
Please ensure the decorative plate is held as it is released to avoid it
being dropped and damaged.
6). These products must be installed in accordance with the latest
Building and IEE wiring regulations. If in any doubt, please
contact a qualified electrician.
2).
Neo?
5).
—"
UK Manufacturer: Kingfisher International Products Limited,
3 Sheldon Square, London, W2 6PX, United Kingdom
www.kingfisher.com/products * www.screwfix.com
EU Manufacturer: Kingfisher International Products B.V.,
Rapenburgerstraat 175E, 1011 VM Amsterdam,
The Netherlands * www.screwfix.ie
BATCH CODE EXPLANATION
yyWxx: Manufacturing code: year of manufacturing(yy)
and week of manufacturing (Wxx). BX2201M
">
