Mooer WoodVerb Reverb Owner's Manual

WoodVerb

Acoustic Guitar Reverb Pedal

Precautions

PLEASE READ CAREFULLY BEFORE PROCEEDING

Power Supply

Please connect the designated AC adapter to an AC outlet of the correct voltage.

Please be sure to use only an AC adapter which supplies 9V (±10%) DC, center minus. The maximum working voltage shall not exceed 12V, otherwise may be dangerous equipment damage, fire or other problems.

Unplug the AC power adapter when not using or during electrical storms.

Connections

Always turn off the power of this and all other equipment before connecting or disconnecting, this will help prevent malfunction and / or damage to other devices.

Also make sure to disconnect all connection cables and the power cord before moving this unit.

Cleaning

Clean only with a soft, dry cloth. If necessary, slightly moisten the cloth.

Do not use abrasive cleanser, cleaning alcohol, paint thinners, wax, solvents, cleaning fluids, or chemical-impregnated wiping cloths.

Interference with other electrical devices

Radios and televisions placed nearby may experience reception interference.

Operate this unit at a suitable distance from radios and televisions.

Location

To avoid deformation, discoloration, or other serious damage, do not expose this unit to the following conditions:

Direct sunlight

Magnetic fields

Excessive dusty or dirty location

Strong vibrations or shocks

Heat sources

Extreme temperature or humidity

High humidity or moisture

FCC certification

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference

This device must accept any interference received, including interference

that may cause undesired operation

Main Features

A digital reverb pedal specifically designed for acoustic guitar players

Provide players with three types of reverb effects: Reverb, Mod, Filter

Reverb: Simulates a Plate reverberation

Mod: Add modulation effect to the reverb

Filter: Add a sweeping filter sound to the reverb

True bypass switch

DC 9V adapter power supply

6

7

9

5

3

8

4

1. TRUE BYPASS Footswitch:

Push down the footswitch to toggle

between on and bypass status.

2. ON/OFF LED:

Shows the on/off status of

WoodVerb , when the LED is lit the effect is engaged.

3. DC IN Power Jack:

For power supply, use a 9-volt DC

regulated AC adapter (plug polarity

is positive on the barrel and negative

in the center).

4. INPUT Jack:

1/4 ” mono audio jack, for connecting

guitar.

5. OUTPUT Jack:

1/4 ” mono audio jack, outputs the signal.

6. Mode Switch:

Change the reverb effect types from

Reverb/Mod/Filter.

7. MIX Knob: Control the ratio of the guitar dry sound and the effect sound.

Rotate the knob clockwise (right) will produce more effect sound presented

while rotate the knob counterclockwise (left) will have more of your guitar

dry sound.

8. TONE/RATE/RANGE Knob: This knob controls different parameters under

different modes. Under Reverb/Mod/Filter mode, this knob controls Tone/

Rate/Range respectively.

9. DECAY Knob: This knob controls the decay level of the reverb effects.

Input: 1/4 ” monaural jack (impedance: 470k Ohms)

Output: 1/4 ” monaural jack (impedance: 100 Ohms)

Power Requirements: AC adapter 9V DC (center minus plug), recommended to use Mooer Micro Power

Current Draw: 130 mA

Dimensions: 93.5mm (D) × 42mm (W) × 52mm (H)

Weight: 145g

Accessories: Owner’s Manual

* Disclaimer: Any specification’s update won't be amended in this manual.