CPL8T
Ceiling Speaker
www.peaveycommercialaudio.com
CPL8T
Ceiling Speaker
Frame Construction Ceiling Installation
1
Take the cutout template from the packaging box and punch out 3 along the larger perforated circle. Place the cutout template against the bottom of the ceiling and trace the inside of it.
Carefully cut out the ceiling material along the circle.
Support
Line
Adjusting the tap selector
4
Remove the grille and set the rotary tap selector switch. insert the speaker through the bottom of the hole in the ceiling.
4
9.56"
243mm
1
5
Loosen the four screws on the front baffle (counter clockwise)
1/2 turn. Then tighten the screws (clockwise) until the dog legs clamp the speaker to the ceiling. Then install the speaker grille.
CAUTION Do not over tighten screws.
2
Remove the top cover to contact the 4-position screw-terminal barrier strip on the back of the speaker. Connect the speaker wire to the 4-position screw-terminal barrier strip . Install the catheter and secure the connection.
5
To speaker 2 Enlarged to
Show Detail
From
Power Amplifier
ꜜ
Cover
3
Set the rotary tap selector switch. Replace the top cover and tighten the screws. connector a secondary support line from the seismic tab to a secure support point.
-
+
To speakers power amplifier
LOOP
THRU
IN IN
Speaker1
LOOP
THRU
LOOP IN IN LOOP
Speaker2
LOOP IN IN LOOP
Speaker3
Parallel Hookup Wiring Diagram
2
Crest Audio CPL8T Ceiling Speaker Specifications
Frequency Response ..............
70Hz - 13.2kHz,-10dB
Power Handling ...............
......
90W @8 Ω
Nominal Sensitivity ..............
..
90dB ±3dB ,1m,1W
Transformer Taps ..............
......
50W, 25W, 12.5W, 6.25W, 3.1W,
(100V) 70V capable
Component ..............................
8" woofer, PP cone and rubber
surround 0.875" soft dome tweeter
Crossover Frequency ..............
4kHz
Recommended filter type and point: 24 dB/oct.
Linkwitz-Riley at 70 Hz.
Outside Dimensions ...............
275mm x 222mm
Cutout Diameter .....................
243mm
Weight ......................................
.3.17kg/7lbs
CPL8T
Ceiling Speaker
PACKAGING:
The CPL8T tweeter can be aimed toward a desired listening area, so the clarity of the announcements or music can be improved. Carefully but firmly grasp the tweeter flange and aim the tweeter in the desired angle.
DO NOT APPLY EXCESSIVE FORCE, OR THE TWEETER
MOUNTING POST MIGHT GET DAMAGED.
FEATURES:
Ultrathin fireproof cover design .
Magnetic suction type grille, easy to disassemble.
Integrated design used in various places.
Wide dynamic range can keep in large volume output without
distortion.
The logo can rotate 360 degrees.
With steel fire dome.
Carton
Speaker Paper Card
Opening paper cover
Paper Cover
Product size diagram:
Unit: mm
An carton boxed 4 units
243
275
3
