with USB Interface
Make the barcode label as flat as possible when it is distorted.
The C11 scanner may not read labels under direct sunshine or in extremely bright places.
It is possible to read barcodes that are upside down.
It is possible to read Inverse as well as Normal 1D barcodes.
If a barcode label is covered with a plastic sheet or film, remove the covering before scanning the barcode.
When consecutively reading the same barcode twice or when the C11 scanner is set to consecutive reading mode, be sure to hold the barcode C11 scanner reading window a sufficient distance away from the barcode being read for approximately 1 second . Then read the next barcode after the indicator LED turns OFF .
Start Configuration
Reset to default
Firmware Version
End Configuration
< >
C11
User’s Guide
Please wait for few seconds until , Windows automatically configures the scanner .
Upon completion of installation , the finish screen appears instead of the screen above . Click Finish to return to Windows .
connected success fully .
