dibea DV-888DC User Instruction Manual

Rechargeable Vacuum Cleaner

Model No.: DV-888DC

22.2V 2200mAh

USER INSTRUCTION MANUAL

1

IMPORTANT SAFE GUARDS

When using an electrical appliance, basic safety precautions should always be observed, including the following

READ ALL INSTRUCTIONS BEFORE USING YOUR VACUUM CLEANER.

WARNING: To reduce the risk of fire, electrical shock, or injury

1. Do not use outdoors or on wet surfaces

2.Do not allow to be used as a toy. Close attention is necessary when used by or near children.

3.Use only as described in this manual. Use only manufacturer’s recommended attachments.

4.Do not use vacuum if it has been dropped, damaged, left outdoors, or dropped in water. Return it to an authorized service center.

5.Do not handle plug or appliance with wet hands.

6.Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair and anything that may reduce air flow.

7.Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.

8.Do not pick up anything that is burning or smoking, such as cigarettes, matches, or got ashes.

9.Use extra care when cleaning on stairs.

10.Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.

11.Look on your vacuum and follow all label and marking instructions.

12.Keep end of hose, wands and other openings away from your face and body.

13. Do not use the vacuum cleaner without dust cup filter in place.

14.Always unplug this appliance before connecting or disconnecting vacuum hose.

15.Store the vacuum indoors. Put the vacuum away after us to prevent tripping accidents.

16.Use the incorrect battery will damage motor and users. Please use the recommended batteries.

17.Use only on dry, indoor surfaces.

18.Do not use for any purpose other than described in this user’s guide.

19.If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

2

PRECAUTIONARY MEASURES

If the opening that sucks in the air, the brush or extension tubes are blocked, you should switch off the vacuum cleaner at once. First clear the blocked substance before you attempt to start the vacuum cleaner again

.

1.Do not operate the vacuum cleaner too close to heaters and like radiators, cigarette butts etc.

2.Before you start using the vacuum cleaner,please remove large or sharp objects from the floor in order to prevent that the filter is damaged.

Do not use the vacuum to clean anything that is easy to burning, such as gas and cigarettes.

ASSEMBLING VACUUM CLEANER

Install the conversion connector

When you need to be used directly to access the body accessories, please use the conversion joint connection.

4

Install extended aluminum tube

We can use aluminum tube longer a head of connection machine (after heard cut when installation, the installation is successful), and then the other side of the connect accessories in the pipe (right), so that it can be used as vertical vacuum cleaner:

* connection after shangdi brush can be directly used to clean the floor or carpet.

* connected to brush or flat after absorption, can be used to clean the ceiling, curtain is difficult to clean at ordinary times, such as higher place, very convenient and practical

Remove and install the dust cup

(a) Remove dust cup from body: push the

2

、 move release button of dust cup. Then take out the dust cup from body.

(fig. A)

(b) Install dust cup on body: first make the underside of dust cup to connect with the body. (pls pay attention to the fitting position and direction). Then push the dust cup to close with the body. The dust cup will be locked after a voice of “kata”.(fig.B).

1 、 push here fig.A fig.B

5

Installation and remove the battery pack

(a) remove the battery pack: to promote the body BaoSuo button at the bottom of the battery, and then along the direction of mobile battery pack, so that you can remove the battery pack from the body. (FIG. A)

2

、 move

(b) install the battery pack: according to the direction along the guide into the battery pack, heard a loud "crack" the sound of the dust cup lock. (FIG. B) push

6

1 、 push here fig.A

fig.B

Clean up the charging cleaner and cleaner

A.How to drop dust and clean the dust cup

1.

Remove the dust cup from body.

2.

Press the dust cup bottom release button, then the dust will fall down automatically. Usually you may only do like this to drop the dust. (fig. A)

3.

If find the plastic filter system too dirty, please press the dust cup cover (for air exhaust) release button, take out the filter assembly out of the dust cup, then you can clean them with soft brush or wash them with water. You should dry them completely before you use again.(fig.B).

Push

Dust Cup Bottom

Release Button

Plastic Centering

Filter System

B.Change or cleaning the sponge and

HEPA filter

1. Remove the dust cup from body.

2. Rotate the dust cup cover anticlockwise from

“close” to “open”, take out the dust cup cover. Draw out the sponge and HEPA filter set.

(fig. A)

3. Pull up the knob of the filter frame, and pull out the sponge filter and HEPA filter from the case box. Cleaning the Sponge and HEPA filter by soft brush or rinse it in lukewarm water and dry them completely before use again.

All the filters are washable. (we recommend you to clean the filters when feeling the suction power becoming weak.) (fig.B)

Note: The above filters should be equipped in correct places when work the vacuum machine

7

fig.A fig.B

Sponge and

HEPA Filter

fig.A fig.B

Suggestion: clean up after work, in order to facilitate the use of the follow-up.

You can put to the company the fuselage and accessories designed with charging seat for you.

TROUBLESHOOTING GUIDE

PROBLEM

Machine doesn't work

POSSIBLE REASON POSSIBLE SOLUTION

The battery may be no electricity change the battery.

Check the battery for electric or

The machine can't suck ash 1. The DUST CUP may be full or suction is very weak

2. Lack of battery power

1.

Empty dust cup

(see page 7).

2.Connect the charger.

DUST ESCAPING

FROM VACUUM

VACUUM BRUSHES WILL NOT

PICK-UP

1.

Empty dust cup .

1.

Dust cup is full. 2.

Check to see if the dust at the

2.The dust filter dust cup or cup bottom there may not be assembled bottom of the cup lock button

1.

Dust cup is full.

1.Empty and clean dust cup container.

8