Westek SL-ALWR 1-Light 10 in. Illuminated Integrated Non-Rope LED Address Light Installation Guide

Plug-in Power Supply Installation Instructions

1.

Separate the ends of the solid black wire (negative) and black with white dashes wire (positive) to allow enough length for a secure connection to your doorbell transformer. Remove ½” of insulation from the end of both wires.

2.

Match the solid black wire from the address light to the solid black wire of the Plug-In Power Supply and connect by screwing on one of the provided weatherproof orange wire caps in a clockwise direction.

Match the black wire with white dashes from the address light to the black wire with white dashes of the Plug-In Power Supply and connect by screwing on one of the provided weatherproof orange wire caps in a clockwise direction.

40590

Address Light

Wire Connector

Transformer

3.

Plug the Power Supply into your wall outlet and check for power.

(Remember your new address light only works in the dark to save money and energy.)

4.

Install your light using the included screws, and run the wires through the small clips in the back in the direction you like.

©2020 AmerTac™ [email protected] Phone: (610) 336-1330