eightdoors B72BLACK 72 in. Matte Black Sliding Barn Door Hardware and Track Kit Instructions
Advertisement
Advertisement
TOOLS REQUIRED
BARN DOOR HARDWARE KIT
ASSEMBLY INSTRUCTIONS
INCLUDED
COMPONENTS
Track (1)
Wall Spacer (4)
Hanger (2)
Left & Right Stops (2) Floor Guide (1)
Allen Wrench(1)
Anti-Jump Disc (2)
3/8”
1/4”
Hanger Bolt w/ Cap (4) Hanger Bolt (8) for Thicker Doors
#8 Floor Screw (2)
5/16 Lag Bolt (4)
¼ Floor Anchor (2)
2/5 concrete wall (4) drill out
3/8"
1/4"
3/4"
1
PREPARE THE DOOR
If using the Floor Guide, mortise a groove ¼” wide by ¾” deep into the bottom center of door’s edge.
2
2"
Center to Stile or minimum of 2"
INSTALL HANGERS
Position hangers on front center of stile ( min. 2” from edge of door, equal on each side ). Cut a piece of cardboard 2’’ high and place between the inner groove of the wheel and the top of the door to correctly position the height of the hangers.
Mark holes & pre-drill 3/8 ” holes. Secure hangers.
* Optional Connector Plate available if connecting multiple tracks.
* Header Board and
Anchoring Screws not included in kit.
4a
3
INSTALL HEADER BOARD
Do NOT install track directly onto drywall. Install a 1 ” x 4 ” or 1 ” x 6 ” Header Board above the door opening directly into studs. Header board must be solid wood and measure at least the full legth of the track or longer.
INSTALL DIREACTLY ON CONCRETE WALL
Pre-drill 2/5’’ dia, 2’’ depth holes , and in step 4b, need to adopt the anchor .
10 (2/5’’)
4 4b
INSTALL STOPS & TRACK
4a.
Insert Stops on either side of track, inside the first & last hole.
4b.
Position center of the track by measuring up from the floor
(door height + 1 ¾”). Align Spacers with holes in track. Use Lag
Bolts to install track into wood header & wall. Use wrench to secure screws through spacers.
BARN DOOR HARDWARE KIT
ASSEMBLY INSTRUCTIONS
5
INSTALLING THE ANTI-JUMP DISCS
Position each anti-jump disc at least 1” from the edge of the hangers. Tighten slightly to secure in place.
6
HANG THE DOOR
Place assembled door on secured track. Tighten the anti-jump discs. Slide door from open to close to ensure all parts are operating smoothly. Secure stops in desired positions with allen wrench.
1 3/16"
1/4"
7
INSTALLING FLOOR DOOR GUIDE (Optional)
Once the door is plumb, place the floor door guide inside the groove and line up close to the door opening. Slide the door from open to close to insure working order. Mark holes with a pencil. Pre-drill ¼” holes. If mounting into a concrete floor, use provided anchors.
COMPLETED DOOR WITH BARN DOOR KIT

Public link updated
The public link to your chat has been updated.
Advertisement