Best Waroo Pro SLE Inflatable Kite kite User manual

Below you will find brief information for Waroo Pro SLE Inflatable Kite. The Waroo Pro is the most technically advanced, best performing kite ever made. With a reduced diameter Cuben Fiber leading edge, exclusive new "Canopy Framing Technology", profile shapers, surf-proof construction and countless other features, the Waroo Pro is simply the perfect kite. The Waroo Pro has handling to match its technical excellence, it delivers more explosive pop and greater hangtime than any BOW, SLE or C kite, while still delivering maximum depower, unmatched stability and multiple integrated safety systems. The Waroo Pro is not just for professional riders; it's for any rider who can stay upwind, in fact for anyone who wants to boost higher, hang longer and simply have more fun kiteboarding.

PDF Download
Document
Best Waroo Pro SLE Inflatable Kite user manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Reduced diameter Cuben leading edge
  • Exclusive Canopy Framing Technology
  • Surf tough construction
  • Harmonized arc
  • Exclusive Cuben Fiber material
  • Maximum performance strut placement
  • Perfect profile shapers
  • Fluid pocket batten mounts
  • Leading edge bridle scuff pads
  • Fluid pocket canopy protection

Frequently asked questions

Expect the ‘best-performance’, the most user-friendly and safest kite available at this time on the market! The Waroo Pro is not only used by schools, but many advanced riders prefer the flatter profile because of the huge amount of de-power available in a short amount of throw. Surfing waves has never been more do-able. With the ability to shut the kite down you can now ride the board more than ever, letting the wave provide the acceleration when wave riding and using the kite as a primary or supplemental power source. Throwing tricks (hooked and un-hooked) can be a safe way to accelerate the learning curve, due to the auto de-powering effect initiated by dropping the bar.

To the specified PSI ratings, we recommend 8.5-9psi for the Waroo Pro; smaller kites require slightly more inflation than larger kites. An under inflated kite will be problematic through the flight cycle and relaunching.

A Waroo Pro flown with a Waroo bar has multiple redundant safety systems. First and foremost releasing the bar and allowing it to slide up to the trim strap will depower the kite to be handled in a safe manner. Both back flying lines on the Waroo bar are equipped with ‘oh-shit’ handles; these can be used in conjunction with depowering the kite to completely flag the kite out to a powerless position. A leash can also be clipped to the webbing handles for use on the water.

If possible, release the OSR handle to flag the kite and wind the lines onto the end posts. Hold the bottom of the kite near the first or second strut (it doesn’t matter too much which). Then grab the part of the LE bridle that attaches closest to the wingtip, approximately 1-2ft from the LE attachment point. Once the kite is trimmed well--powered, but not dragging downwind you can sail downwind easily.

The Waroo Pro front bridle has user replaceable heavy duty inserts fitted into the centre of the line. Should these become worn then simply undo the retaining loops at either end and fix in place a replacement set. It is recommended that you replace both sides at the same time even it only one side is showing wear.
Preparing document for printing…
0%