User Manual - Transmitter Solutions
DOLXMWIHIDEM Reader/Keypad
USER MANUAL
INSTRUCTIONAL
VIDEO
1]
2]
3]
4]
Overview
Installation
Wiring Guide
Functions Table
1
Overview
The DOLXMWIHIDEM is a Wiegand output keypad with an
integrated proximity reader. The keypad is digital backlit, with
built-in Light Dependent Resistor (LDR) sensor for anti-tamper.
Because the keypad is IP66 rated, it can be mounted indoor or
outdoor.
SPECIFICATIONS
Frequency
125KHz
Card Type
EM & HID® Cards/FOBS
Read Range
4-8 cm
Standby Current
<35mA
Operating Voltage
9-18VDC
Wiegand Ouput Format
Wiegand 26 bit (factory default)
Keypad Transmission Format
4 bits (factory default)
Operating Temperature
-40°C ~ 60°C
Operating Humidity
0% RH ~ 96% RH
Color
Black
Index of Protection
IP 66
Dimensions
4-3/4” (L) x 2” (W) x 13/16” (D) inches
Net Weight
150 g
Shipment Weight
200 g
PACKING LIST
DOLXMWIHIDEM Reader
1
Manual
1
Screw Driver
1
Wall Fixing Plus
2
Self Tapping Screws
2
2
Installation
• Drill 2 holes (A ,C) on the wall for the screws and one hole (B)
for the cable
• Knock the supplied rubber bungs to the screw holes (A ,C)
• Fix the back cover firmly on the wall with 2 screws
• Thread the cable through the cable hole (B)
• Attach the unit to the back cover
Wall
φ3.2mm
φ5X 4mm
9.5mm
A
B
φ9mm
C
Step2
Step3
70mm
41.5mm
9.5mm
Step1
3
Wiring Guide
Wire Color
Function
Notes
Red
Power +
+DC (9-18 VDC)
Black
GND
Ground
Green
D0
Data 0
White
D1
Data 1
Brown
LED
Green LED Light Control
Yellow
Buzzer
Buzzer Control
Note: Brown and Yellow wires are optional connections.
Red
Black
Green
White
Brown
Yellow
+12V
GND
D0
D1
LED
BZ
Access Controller
DOLXMWIHIDEM
4
Functions Table
Read Card
The LED light will turn Green, and the
buzzer will beep, the reader outputs the
Wiegand signal
External LED Control
When the input voltage for the LED is
low, the LED will turn Green
External Buzzer Control
When the input voltage for the Buzzer is
low, the Buzzer will sound
Wiegand Data Output
Wiegand 26~37 bits range available for
DOLXMWIHIDEM reader, factory default
setting is Wiegand 26 bits, HID® card
can output Wiegand 26~37 automatically,
EM and Mifare cards are forced to output
based on the reader setting.
Keypad Transmission Format
The reader will transmit the PIN data after every key is pressed:
1 (0001), 2 (0010), 3 (0011)
4 (0100), 5 (0101), 6 (0110)
7 (0111), 8 (1000), 9 (1001)
* (1010), 0 (0000), # (1011)
Virtual Card Number
The reader will transmit the PIN data when it receives the last
key # after PIN code
Example: PIN Code 999999
Press 9 9 9 9 9 9
#
the output format will be 0000999999
TRANSMITTER SOLUTIONS WARRANTY
The warranty period of Transmitter Solutions keypad is twenty-four (24)
months. This warranty shall begin on the date the keypad is manufactured. During the warranty period, the product will be,repaired or replaced
(at the sole discretion of Transmitter Solutions) if the product does not
operate correctly due to a defective component. This warranty does not
extend to (a) the keypad case, which can be damaged by conditions
outside the control of Transmitter Solutions, or (b) battery life of the
keypad. This warranty is further limited by the following disclaimer of
warranty and liability:
EXCEPT AS SET FORTH ABOVE, TRANSMITTER SOLUTIONS MAKES NO
WARRANTIES REGARDING THE GOODS, EXPRESS OR IMPLIED, INCLUDING
WARRANTY OF MERCHANTABILITY OR WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE. BUYER MAKES NO RELIANCE ON ANY REPRESENTATION OF
TRANSMITTER SOLUTIONS, EXPRESS OR IMPLIED, WITH REGARD TO THE
GOODS AND ACCEPTS THEM “AS-IS/WHERE-IS”. TRANSMITTER SOLUTIONS
SELLS THE GOODS TO BUYER ON CONDITION THAT TRANSMITTER SOLUTIONS
WILL HAVE NO LIABILITY OF ANY KIND AS A RESULT OF THE SALE. BUYER
AGREES THAT TRANSMITTER SOLUTIONS SHALL HAVE NO LIABILITY FOR
DAMAGES OF ANY KIND, WHETHER DIRECT, INCIDENTAL OR CONSEQUENTIAL
DAMAGES, INCLUDING INJURIES TO PERSONS OR PROPERTY, TO BUYER, ITS
EMPLOYEES OR AGENTS, AS A RESULT OF THE SALE. BUYER ALSO AGREES TO
HOLD TRANSMITTER SOLUTIONS HARMLESS FROM ANY CLAIMS BUYER, OR
ANY THIRD PARTY, MAY HAVE AS A RESULT OF BUYER’S USE OR DISPOSAL OF
THE GOODS. BUYER HAS READ THIS DISCLAIMER AND AGREES WITH ITS
TERMS IN CONSIDERATION OF RECEIVING THE GOODS.
Pierce Building: 3788 West 2270 South, Suite E
Salt Lake City, UT 84120
(866) 975-0101 • (866) 975-0404 fax
www.transmittersolutions.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement