H004228 Master Clock Synchronizer User Manual

H004228 Master Clock Synchronizer User Manual
SiteSync IQ Master Clock
Synchronizer
Installation and Operation Manual
Wireless Master Clock Synchronizer
Part # H004283
Rev. 2
March 2011
Introduction
SiteSync IQ Master Clock
Synchronizer
The Wireless Master Clock Synchronizer is a compact wireless time receiver designed to provide a dry contact closure
at a GPS accurate specific time of the day. The time of the synchronization pulse is programmable within the SiteSync
IQ system controller to the nearest minute. The time of day and Master Clock Synchronizer module CAP code must be
set correctly on the SiteSync IQ system controller to transmit a signal to the Master Clock Synchronizer. This manual
provides instructions on making connections to your Master Clock Synchronizer module and setting your SiteSync IQ
system controller to transmit to the module.
Master or
intercom clock
with external
sync option
Part No. H004228
Figure 1 – Master Clock Synchronizer controlled by SiteSync IQ
American Time
140 3rd Street South, PO Box 707
Dassel, MN 55325-0707
Phone: 800-328-8996
Fax: 800-789-1882
american-time.com
1
© American Time
SiteSync IQ Master Clock
Synchronizer
Connecting the Master Clock Synchronizer Module
LED1
DC
Power
Adapter
LED2
LED3
Dry contact wire
connections
RJ45
Configuration
Port
RJ11
Factory
Use Only
Figure 2 – Master Clock Synchronizer connections
To install your Master Clock Synchronizer module you will need to make two connections.
1. Connect power to the module using the DC power adapter supplied with the module from an AC wall outlet. Connect the adapter to the port indicated in figure 2.
2. Connect your time setting dry contacts to the module indicated in Figure 2.
LED Function
LED1 -
LED2 -
LED3 -
© American Time
Red = No signal 2 minutes
Green = Signal last 2 minutes
Green = Relay active
Yellow = Message Rec’d - A single yellow flash will indicate the relay activation message is received.
2
Connecting the Master Clock Synchronizer Module
Turn on the power to the System Controller
SiteSync IQ Master Clock
Synchronizer
2
MTM Menu
Enter User Lock:
____
PROG=Exit
u
Set the SiteSync IQ System Controller to be a transmitter (Tx) of the contact closure. Press P9 to enter Master to Master (MTM) 3a
Menu.
MTM Menu
Master to Master:
1=Tx
3=Off
2=Rx
v
Enter User Lock. Press O.
w
a. Press 1 to set the SiteSync IQ System Controller to Tx.
b. Enter transmit duration (0-9999). Press O.
Example: 2,000ms=2 seconds
nNote: The SiteSync IQ System Controller will round up to the nearest
second.
x
Using the keypad, set the time when the contact closure should occur. Use <> to select AM or PM. Press O.
OK=Enter
3b
4
MTM Menu
Transmit Duration:
2000
OK=Done
MTM Menu
Sync Time:
12:00:00
<>AM/PM
OK=Done
nNote: Reference existing equipment instruction manual for contact
closure time.
nImportant Note! The Sync Time set in Step 4 must be the same
for both units.
3
© American Time
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement