Nilfisk E 130.2, E 140.2
Nilfisk E 130.2, E 140.2
User Manual
Index
1
2
3
4
5
6
7
8
9
10
Safety precautions and warnings .............................................3
Description ...............................................................................4
Before you start using your pressure washer ...........................5
Operating your pressure washer ..............................................6
Fields of Application
and Working Methods.............................................................10
After using your pressure washer ...........................................12
Maintenance ...........................................................................13
Trouble Shooting ....................................................................14
Further information .................................................................15
EC Declaration of Conformity .................................................17
1 Safety Precautions and Warnings
Before starting up
your high-pressure washer for
the rst time, this
instruction manual
must be read through carefully.
Save the instructions for later
use.
Safety instructions
marked with this
symbol must be
observed to prevent danger to persons.
This symbol is
used to mark
safety instructions that must
be observed to
prevent damage to the
machine and its performance.
This symbol
indicates tips
and instructions
to simplify work and to ensure a
safe operation.
3
Extension cables should be of
a watertight construction and
comply with the below-mentioned requirements for length
and cable dimensions.
1.0 mm†
1.5 mm†
2.5 mm†
max.
max.
max.
12.5 m
20 m
30 m
Cable connections should be
kept dry and off the ground.
Mains power connection
The following should be observed when connecting the
high pressure washer to the
electric installation:
Only connect the machine to
an installation with earth connection.
The electric installation shall
be made by a certi ed electrician.
It is strongly recommended
that the electric supply to this
machine should include a residual current device (GFCI).
Water connection
Connection to
the public mains
according to regulations.
This high pressure washer is only allowed to
be connected with the drinking
water mains, when an appropriate back ow preventer has
been installed, Type BA according to EN 1717. The back ow
preventer can be ordered under
number 106411177. The length
of the hose between the backow preventer and the high
pressure washer must be at
least 10 metres to absorb possible pressure peaks (min diameter ‰ inch).
Operation by suction (for example from a rainwater vessel)
is carried out without back ow
preventer. Recommended suction set: 126411387.
As soon as water has own
through the BA valve, this water
is not considered to be drinking
water any more.
IMPORTANT! Only use water without any impurities. If
there is a risk of running sands
in the inlet water (i.e. from your
own well), an additional lter
should be mounted.
Repair and maintenance
WARNING! Always remove the
electric plug from the socket before carrying out maintenance
work on the machine.
Safety devices
Locking device on spray gun
(7a) (see foldout at the end of
this manual):
The spray gun features a locking device. When the pawl is
activated, the spray gun cannot
be operated.
Thermal sensor:
A thermal sensor protects the
motor against overloading. The
machine will restart after a few
minutes when the thermal sensor has cooled.
Pressure safety device
An integrated hydraulic safety
valve protects the system from
excessive pressure.
2 Description
2.1 Application
This high-pressure washer has
been developed for domestic
use within:
Only use the high-pressure
washer for purposes described
in this manual.
- Car, motorbike, boat, caravan, trailer, patio/drive/flagstones, woodwork, brickwork,
barbecue, garden furniture,
lawn mower
The safety precautions must be
observed to prevent damage
to the machine, the surface to
be cleaned or severe personal
injuries.
Section 5 describes the use of
the high-pressure washer for
vaious cleaning jobs.
4
2.2 Operation elements
and model survey
See illustration at the end of
this manual.
1 Start/stop switch
2 Water inlet (with lter)
3 High pressure connection
(only models without hose
reel)
4 High pressure hose
5 Electric cable
6 Click & Clean spray lance
7 Spray gun with lock
8 Click & Clean Tornado¤ PR
nozzle
9 Click & Clean Powerspeed¤
nozzle
10 Click & Clean foam sprayer
11 Nozzle cleaning tool
12 Trolley handle (telescopic
handle)
13 Hose reel (not standard)
14 Hose hook
15 Model tag
16 Quick coupling
17 Button for telescopic handle
18 Turnable cable hook
Specifications: See model tag
(15) of machine.
Sound pressure level measures in accordance with ISO
3744 EEC directive 2000/14/
EEC: LpA = 69,9 dB(A), LWA = 84
dB(A).
We reserve the right to alter the
speci cations.
3 Before you start using your
pressure washer
3.1 Mounting of trolley
handle and hose hook
(standard models)
1. Push down the trolley handle
(12) over the two metal tubes.
Make sure that the handle is
mounted as illustrated. Mount
screws with nuts (make sure
that the screws go through
handle as well as tube).
2. Mount the hose hook (14)
on the machine (2 screws).
Note: the hose hook can be
mounted on the front as well
as on the back. Front position
is to be used if the product is
used together with a special
wall hook for wall storage.
3.2 Mounting of hose reel
handle (models with
hose reel)
1. Click the hose reel handle
on to the trolley handle (no
screws).
5
4.5 Start and stop of the machine (when connected
to a water supply)
8
The spray lance is affected
bT.5947s ofStapl
5.2 Typical fields of application
Below you will nd a description of a lot of cleaning tasks which can be solved by a pressure washer
from Nil sk in association with accessories and detergents.
Task
Accessories ‘Click Cleaning method
& Clean’
Car
Car nozzle,
auto brush,
underchassis
nozzle,
Foam sprayer,
Car Combi Cleaner
1. Apply Car Combi Cleaner with the foam sprayer. Always
start from the bottom and work upwards. Let Car Combi
Cleaner act for at least 5 min.
2. Wash the car with the car nozzle, which has been optimized for
quick and gentle cleaning of enamelled surfaces (the jet is wider
and not so sharp). Start at the front of the car and work backwards to avoid water from penetrating by the door mouldings.
3. Use the brush for removal of traf c lm which is not removed by the
nozzle. If the car is very dirty, apply Car Combi Cleaner again.
4. Attach the undercarriage nozzle and clean undercarriage and
wheel arches.
5. Remove water from the surface of the car with the scraper
on the car brush. Make sure that all grains of sand etc. have
been removed before using the scraper. Wipe with a wash leather where the scraper cannot reach.
Rims, aluminium
Rim brush,
auto nozzle,
atomizer,
Alu Cleaner
Apply Alu Cleaner with an automizer. Let it act for approx.
5 min. and wash with the rim brush. For steel rims, use Car Combi Cleaner. Use the foam sprayer and wash with rim brush.
Be careful! The high pressure jet may damage the tyres.
Flagstones,
concrete
floors and
other hard
surfaces
Powerspeed¤
nozzle,
Stone & Wood
Cleaner,
Patio Cleaner
Wash towards outlets or the like. On surfaces with moss or
algae you may start by applying Stone & Wood Cleaner with
the foam sprayer. Wash before the soap dries. Another
more effective and quicker method is to use the Patio
Cleaner. Thus you will also avoid splashes.
Garden
furniture,
wood
Wood Cleaner
Garden brush
Apply Wood Cleaner and wash before the soap dries.
NOTE: Use the garden brush to clean off the dirt.
Brickwork, Powerspeed¤
Wood
nozzle,
work
Stone & Wood
Cleaner,
Patio Cleaner
Gutter
Same method as for agstones, but be careful - bad joints and
wood may be damaged by high pressure. You may choose only
to use the Tornado¤ nozzle. Adjust the distance (pressure) to
the quality of the joints and the wood. Patio Cleaner can also be
used on vertical surfaces.
Underchassis spray Wash the gutter with the nozzle. Always wash towards
lance
downpipes. Beware not to spray under the roo ng.
Cleaning
Tube cleaner
of drain
pipes, outlets, down
pipes etc.
Push the tube cleaner approx. ‰ m (to mark) into a tube or drain
and activate the trigger of the spray handle. The nozzle opening
turning backwards will pull the cleaner through the tube. The
nozzle will break down the ªplug and ush the dirt backwards.
Rust, paint Water/sandblasting
equipment
Mount the water/sand blasting equipment and rust and paint
is ef ciently and quickly removed. Beware not to damage the
surface to be sandblasted.
Greenhouse
Tornado¤ PR nozzle Wash with high pressure and maybe a brush. You may use Stone
brush, Stone &
& Wood Cleaner to remove moss and algae.
Wood Cleaner
Garden
tools,
lawn
mover
Tornado¤ PR
nozzle, Powerspeed¤ nozzle,
multiangle adaptor,
Metal Cleaner
Rinse the worst dirt off with the nozzle. Apply Metal Cleaner with
the foam sprayer and let it act for approx. 5 min. Wash with the
nozzle. You may use the multiangle adaptor for hard to get at
areas to avoid splashing.
11
8 Trouble-shooting
14
9 Further information
9.1 Recycling the washer
Make the old cleaner unusable
immediately.
1. Unplug the cleaner and cut
the electric cable.
Do not discard electrical appliances with household waste.
9.2 Warranty conditions
Nil sk guarantees high pressure washers for domestic use
for 2 years. If your high pressure washer or accessories are
handed in for repair, a copy of
the receipt must be enclosed.
Guarantee repairs are being
made on the following conditions:
that defects are attributable
to aws or defects in materials or workmanship. (wear
and tear as well as misuse
are not covered by the guarantee).
that the directions of this
instruction manual have been
thoroughly observed.
that repair has not been carried out or attempted by other than Nil sk-trained service
staff.
that only original accessories
have been applied.
that the product has not been
exposed to abuse such as
knocks, bumps or frost.
that only water without any
impurities has been used.
that the high pressure washer has not been used for
rental nor used commercially
in any other way.
As speci ed in European Directive 2002/96/EC on old electrical and electronic appliances,
used electrical goods must
be collected separately and
recycled ecologically.
Contact your local authorities or
your nearest dealer for further
information.
Repairs under this guarantee
include replacement of defective parts, exclusive of packing
and postage/carriage. Besides,
we refer to your national law of
sale.
The machine should be forwarded to one of the service
centres of the Nil sk organisation with description/speci cation of the fault.
Repairs not covered by the
guarantee conditions will be
invoiced. (I.e. malfunctions due
to Causes mentioned in section
Troubleshooting Chart of the
instruction manual).
In order that Nil sk can render
you optimum service, you
should register your product on
our web site www.nil sk-alto.
com under PRODUCT REGISTRATION .
15
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement